An air-conditioning system involves the mixing of cold air and warm outdoor air before the mixture is routed to the conditioned room in steady operation. Cold air enters the mixing chamber at 7°C and 105 kPa at a rate of 0.55 m3/s while warm air enters at 34°C and 105 kPa. The air leaves the room at 24°C. The ratio of the mass flow rates of the hot to cold airstreams is 1.6. Using variable specific heats, determine (a) the mixture temperature at the inlet of the room and (b) the rate of heat gain of the room.
FIGURE P5–83
(a)
The mixture temperature at the inlet of the room.
Answer to Problem 83P
The mixture temperature at the inlet of the room is
Explanation of Solution
Here, the warm and cold streams of fluids are mixed in a rigid mixing chamber and operates at steady state. Hence, the inlet and exit mass flow rates are equal.
Write the energy rate balance equation for two inlet and one outlet system.
Here, the rate of heat transfer is
The system is at steady state. Hence, the rate of change in net energy of the system becomes zero.
Neglect the heat transfer, work transfer, kinetic and potential energies.
The Equation (II) reduced as follows.
Substitute
Here, the ratio of mass flow rate of hot to cold air streams is
Substitute
Refer Table A-17, “Ideal-gas properties of air”
Obtain the enthalpy
Obtain the enthalpy
Write the formula of interpolation method of two variables.
Show the temperature and enthalpy values from the Table A-17 as in below table.
S.No. | x | y |
Temperature | enthalpy | |
1 | 305 | 305.22 |
2 | 307 | ? |
3 | 310 | 310.24 |
Substitute
Thus, the enthalpy
Similarly,
Obtain the enthalpy
Conclusion:
Substitute
Refer Table A-17, “Ideal-gas properties of air”
Obtain the temperature
Show the temperature and enthalpy values from the Table A-17 as in below table.
S.No. | x | y |
Enthalpy | Temperature | |
1 | 295.17 | 295 |
2 | 296.8096 | ? |
3 | 298.18 | 298 |
Substitute
The temperature
Thus, the mixture temperature at the inlet of the room is
(b)
The rate of heat gain of the room.
Answer to Problem 83P
The rate of heat gain of the room is
Explanation of Solution
Write the formula for mass flow rate of cold air
Here, the volumetric flow rate of air is
Express the formula for heat gain by the room.
Here, the mass flow rate of mixed air entering the room is
Refer Table A-1, “Molar mass, gas constant, and critical-point properties”.
The gas constant of air is
Conclusion:
Substitute
Substitute
Substitute
Thus, the rate of heat gain of the room is
Want to see more full solutions like this?
Chapter 5 Solutions
CENGEL'S 9TH EDITION OF THERMODYNAMICS:
- Saturated ambient air with a DB of 8°C and a mass flow rate of 0.98 kg/s is divided into two streams. One stream passes through a heating section and leaves it with an RH of 30%. The conditions of the other stream that bypasses the heater remains unchanged. The two streams are then adiabatically mixed to produce the supply air stream at 22°C. The pressure is constant at 101.3 kPa. -Determine the partial pressure of water vapor (in kPa) of the heated air (Hint: sensible heating process).-Determine the mass flow of air that bypassed the heater in kg/s.-Determine the heat input by the heating coil in kW.arrow_forwardA single effect evaporator is being used to concentrate 8000 kg/h of tomato juice from 5% total solids to 30% total solids. The juice enters the evaporator at 25°C. The evaporator is operated with steam (85% quality) at 143.27 kPa. The vacuum inside the evaporator allows the juice to boil at 75°C. The specific heat of the liquid feeds is 4.1 kJ/(kg°C) and the concentrated product is 3.1 kJ(kg°C) Calculate a. The steam requirements = ... kg/h b. Steam economy for the process. Assume the condensate is discharged at 75°Carrow_forwardA stream of outdoor air is mixed with a stream of return air in an air-conditioning system that is operated at 101.325 kPa barometric pressure. The flow rate of outdoor air is 2.0 kg/s and its condition is 35°C DBT and 25°C WBT temperatures. The flow rate of return air is 3.0 kg/s and its condition is 24°C DBT and 50% RH. If the ambient pressure is 98 kPaa, determine the following: 1. Enthalpy of the mixture in kJ/kg 2. Humidity ratio 3. Dry bulb temperature of the mixture in °Carrow_forward
- To eliminate dust, air with a dry bulb temperature of 38 oC and a wet bulb temperature of 27 oC scrubbed with water. The water temperature is kept at 25 degrees Celsius. The air that is expelled from the scrubber is in balance with water. It is then heated to 93 degrees Celsius in an air preheater before being admitted to an adiabatic rotary dryer. The air exits the drier at 49 degrees Celsius. Moisture is lost at a rate of 0.05 kg of water per kg of product. The total product capacity is 1000 kg/h. Calculate the following (using a psychrometric chart): is a. Total weight of dry air used per hour. b. Total volume of air leaving the dryer.arrow_forwardIt is suggested to pump 5,000 kg/h of a liquid at 114°C and 1.1 atm abs pressure from a reboiler of a distillation tower to a second distillation unit without cooling the liquid before this joins the pump in a given industrial operation. The liquid has a density of 866 kg/ m2 and a vapor pressure of 1.1 atm at this heat.condition. The reboiler-to-pump line has a friction loss of 5 kN/m2. a. To achieve a net positive suction head of 2.5 m, how far must the liquid level in the reboiler be maintained? b. Compute the power needed to drive the pump if the liquid is to be elevated 5 meters, the pressure in the second unit is atmospheri and the discharge line friction loss is 25 kN/ m2. The pump discharge line has a velocity of 2 m/s, and the pump-motor efficiency is 65 percent.arrow_forwardQuestion as shown in picture.arrow_forward
- A stream of outdoor air is mixed with a stream of return air in an air-conditioning system that operated at 101.325 kPa barometric pressure. The flow rate of outdoor air is 2.0 kg/s, and its condition is 35℃ DB and 25℃ WB temperatures. The flow rate of return air is 3.0 kg/s, and its condition is 24℃ DB and 50% RH. If the ambient pressure is 98 kPaa, determine the following: a. The enthalpy of the mixture in kJ/kg dry-air b. The humidity ratio of the mixture in kg/kg dry-air c. The dry-bulb temperature of the mixture in ℃.arrow_forwardA mixture of refrigerant-134a at 120 kPa enters an evaporator with quality 0.12 and leaves it as fully vaporized (quality equal to 1). The latent heat is provided by 16.4 kg/s of air entering in the device at 23 ºC and exiting at 7 °C. Assume constant specific heat of the air cp=1.005 kJ/(kg K). Calculate the mass flow rate of the refrigerant in kg/s to 2 decimal places.arrow_forwardTwo boilers of equal evaporative capacities generate steam at the same pressure of 15 bar (1.5 MPa) to a common pipe line. One boiler produces superheated steam at 150°C and the other produces wet steam If the mixture is just dry and satrated, find the dryness fraction of the wet steam from the second boiler. Steam Properties: At 15 bar (1.5 MPa), 250°C h = 2925 kJ/kg At 15 bar (1.5 MPa) he = 845 kJ/kg hfg = 1947 kJ/kg = 2792 kJ/kg hg = A. 0.9315 B. 0.8425 C. 0.7142 D. 0.6573arrow_forward
- Question 43 At a science fair, an inventor suggests a hypothetical device that operates permanently and which is fed by a flow rate of 2 kg/s of Air at 400 kg/s kPa and 27 °C. At the outlet there are two distinct air vents that leave the device to the ambient pressure of 100 kPa and same mass flow. One of the outputs is at 57°C while the other output is at -3°C. The ambient temperature is 27 °C during the process. Assuming the device is well insulated, determine: a) The entropy generated on the device; b) Is this device possible?arrow_forwardAir at 20 ° C and 50% RH is channeled into the heating coil so that the temperature of the dry ball is 70 ° C. Then it is used for drying by passing it to a pile of granular pet food. The air exiting the pile has a dry ball temperature of 50 ° C. This air is then reheated to 80 ° C and flown to the other pile of pet food. The air coming out of the second dryer is in a saturated state. Draw the processes that occur from ambient air to saturated air from dryer 2 on a psychrometric diagram. Determine the amount of water removed in the first and second dryers per kg of dry air.a. first dryer (kg water / kg air).b. second dryer = (kg water / kg air)arrow_forwardAtmospheric air at 40°C dbt and 55% RH is passed over a cooling coll at the rate of 600 m/mint. At exit from coil the air is saturated and its temperature is 8°C. The condensate also leaves at 8°C. Determine the amount of condensate leaving coll per minute and refrigeration in kW. The specific heat of superheated steam may be assumed to be 1.88 kJ/kg-K. Solve the problem without psychromatic chart.arrow_forward
- Elements Of ElectromagneticsMechanical EngineeringISBN:9780190698614Author:Sadiku, Matthew N. O.Publisher:Oxford University PressMechanics of Materials (10th Edition)Mechanical EngineeringISBN:9780134319650Author:Russell C. HibbelerPublisher:PEARSONThermodynamics: An Engineering ApproachMechanical EngineeringISBN:9781259822674Author:Yunus A. Cengel Dr., Michael A. BolesPublisher:McGraw-Hill Education
- Control Systems EngineeringMechanical EngineeringISBN:9781118170519Author:Norman S. NisePublisher:WILEYMechanics of Materials (MindTap Course List)Mechanical EngineeringISBN:9781337093347Author:Barry J. Goodno, James M. GerePublisher:Cengage LearningEngineering Mechanics: StaticsMechanical EngineeringISBN:9781118807330Author:James L. Meriam, L. G. Kraige, J. N. BoltonPublisher:WILEY