The components present in the ejaculated semen that make it thick and gelatinous and the mechanism of escape of sperms from this gel to travel up in the female reproductive tract. Introduction: The human male reproductive system consists of primary sex organs as well as accessory sex organs. The primary sex organs are involved in the production of the sperms and secretion of hormones, whereas the accessory sex organs are involved in the production of seminal fluids and passage of sperms within and into the female reproductive tract.

Question

Want to see the full answer?

Answer 1

Question

Chapter 42.3, Problem 1R

Summary Introduction

To review:

The components present in the ejaculated semen that make it thick and gelatinous and the mechanism of escape of sperms from this gel to travel up in the female reproductive tract.

Introduction:

The human male reproductive system consists of primary sex organs as well as accessory sex organs. The primary sex organs are involved in the production of the sperms and secretion of hormones, whereas the accessory sex organs are involved in the production of seminal fluids and passage of sperms within and into the female reproductive tract.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

Outline a method for using apomixis to maintain feminized CannabisAssume apomixis is controlled by a single dominant gene. You can choose the type of apomixis: obligate or facultative, gametophytic or sporophytic. Discuss advantages and disadvantages of your proposed method.

Kinetics: One-Compartment First-Order Absorption 1. In vivo testing provides valuable insight into a drug’s kinetics. Assessing drug kinetics following multiple routes of administration provides greater insight than a single route of administration alone. The following data was collected in 250-g rats following bolus IV, oral (PO), and intraperitoneal (ip) administration. Using this data and set of graphs, determine:(calculate for each variable) (a) k, C0, V, and AUC* for the bolus iv data (b) k, ka, B1, and AUC* for the po data c) k, ka, B1, and AUC* for the ip data (d) relative bioavailability for po vs ip, Fpo/Fip (e)absolute ip bioavailability, Fip (f) absolute po bioavailability, Fpo

3. A promising new drug is being evaluated in human trials. Based on preliminary human tests, this drug is most effective when plasma levels exceed 30 mg/L. Measurements from preliminary tests indicate the following human pharmacokinetic parameter values: t1/2,elim = 4.6hr, t1/2,abs = 0.34hr, VD = 0.29 L/kg, Foral = 72%. Based on these parameters, estimate the following if a 49 kg woman were to receive a 1000mg oral dose of this drug: (a) Estimate the plasma concentration of the drug at 1hr, 6 hr, and 20hr after taking the drug ( Concentration estimate) (b) Estimate the time for maximum plasma concentration (tmax). (c) Estimate the maximum plasma concentration (Cmax). (d) Estimate the time at which the plasma level first rises above 30 mg/L. (Note this is a trial and error problem where you must guess a time, plug it into the concentration equation, and determine if it is close to 30 mg/L. Hint: based on part (a) it should be apparent that the answer is less than 1hr.) (e)…