The reasons that would make consumers interested in large pickle slices. Case summary: In the given case, VP is a popular brand of all kinds of pickles and folks decided about the market for large pickle slices which are made from bringing cucumbers. therefore, to make large slices of pickles, they need large cucumbers which created a problem for them because at that time large cucumbers didn’t exist. To find out large cucumbers they crossed a variety of cucumber types and they needed to wait for several weeks because cucumber plants need time to get mature. Then, through a number of attempts and tries, they found large cucumbers but the taste of these cucumbers was not good. After that, they again went through different varieties of cucumbers and waited for other several weeks to get results but this time, they found large cucumbers with good taste. But then, one more issue arose when the pickle slicing equipment was broken down while larger pickles were trying to slice. Therefore, they need to design new equipment for slicing the larger size pickles.

Question

Want to see the full answer?

Answer 1

Question

Chapter 4.2, Problem 1.1RQ

Summary Introduction

To explain: The reasons that would make consumers interested in large pickle slices.

Case summary: In the given case, VP is a popular brand of all kinds of pickles and folks decided about the market for large pickle slices which are made from bringing cucumbers. therefore, to make large slices of pickles, they need large cucumbers which created a problem for them because at that time large cucumbers didn’t exist. To find out large cucumbers they crossed a variety of cucumber types and they needed to wait for several weeks because cucumber plants need time to get mature. Then, through a number of attempts and tries, they found large cucumbers but the taste of these cucumbers was not good. After that, they again went through different varieties of cucumbers and waited for other several weeks to get results but this time, they found large cucumbers with good taste. But then, one more issue arose when the pickle slicing equipment was broken down while larger pickles were trying to slice. Therefore, they need to design new equipment for slicing the larger size pickles.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

Question 3 i. Using the Center of Gravity method, determine the optimal location (X, Y) for the new distribution center. [7 marks] [TOTAL 25 MARKS] Time (sec.) Power steering assembly firm wants to set up an assembly line which must have an output of 60 units per hour. The work elements, task times and their precedence relationships are shown in Table 2: Table 1 Work Element Immediate Predecessor(s) A 30 NONE B 26 A C 50 A D 44 B E 10 с F 20 с G 15 D.E H 30 E,G,F Required: a. Draw the precedence diagram showing the task precedence and their times b. Determine the cycle time associated with the rate of output required. [3 marks] c. What is the theoretical number of work stations required to satisfy this output rate? [3 marks] [4 marks] d. Allocate the tasks to work stations taking into consideration the precedence requirements and using the LOT rule to break ties between feasible tasks. e. Calculate the total idle time [8 marks] [3 marks] f. What is the efficiency of the line and the…

Question 2 MGMT2026 Production and Operations Management Semester II 2024-2025 a. Aman ltd. desires to locate a new facility. Based on preliminary analysis, the choice has been reduced to four locations: A, B, C, and D. These four locations were rated on a scale from 1 (worst) to 10 (best) on each of four criteria. Each criterion was also weighted to indicate its importance (i.e., the higher the weight, the more important). The list of ratings and weights follows in the Table 2 below: Table 2 Factor Score Evaluation by Location Criterion Weights A B с D Wages 25 4 5 3 4 Government Policies 30 8 7 6 5 Unionisation Weather 15 6 4 3 2 30 3 4 6 5 i. Based on weighted scores, where should Acme locate its new facility? [6 marks] b. An operations manager has narrowed down the search for a new factory to three locations. The fixed and variable costs associated with each location is given in the table below. i. Table 3 Location Fixed Cost Variable Cost A $100,000 $10 B $150,000 $7 с $200,000 $5…

The University of the West Indies GLOBAL CAMPUS MGMT 2026 Production and Operations Management - Problem Sheet Assignment Semester II 2024/2025 Note: Although this assignment is being currently assessed out of 100 marks it would be prorated to Contribute a maximum of 40% towards your final course marks. M&H company ltd. sells television sets and has collected monthly sales data (in units) for the past 12 months as shown in table 1below: TABLE 1 Month Sales (Units) 1 120 2 135 3 150 165 5 180 200 7 195 8 210 225 10 240 11 255 12 270 This Assignment is comprised of four (4) Questions - All questions must be attempted Using the data provided, answer the following questions: a. Using a 3-month weighted moving average with weights 0.5, 0.3, and 0.2 (most recent month having the highest weight), calculate the forecast for month 13. [2 marks] Screens 5-7 of 7