Concept explainers
In a setup similar to that of Problem 35.39, the glass has an index of refraction of 1.53, the plates are each 8.00 cm long, and the metal foil is 0.015 mm thick. The space between the plates is filled with a jelly whose refractive index is not known precisely, but is known to be greater than that of the glass. When you illuminate these plates from above with light of wavelength 525 nm, you observe a series of equally spaced dark fringes in the reflected light. You measure the spacing of these fringes and find that there are 10 of them every 6.33 mm. What is the index of refraction of the jelly?
Want to see the full answer?
Check out a sample textbook solutionChapter 35 Solutions
UNIVERSITY PHYSICS UCI PKG
Additional Science Textbook Solutions
Tutorials in Introductory Physics
Physics for Scientists and Engineers with Modern Physics
Essential University Physics: Volume 2 (3rd Edition)
The Cosmic Perspective Fundamentals (2nd Edition)
Applied Physics (11th Edition)
Conceptual Physics (12th Edition)
- The Michelson interferometer can be used to measure the index of refraction of a gas by placing an evacuated transparent tube in the light path along one arm of the device. Fringe shifts occur as the gas is slowly added to the tube. Assume 580-nm light is used, the tube is 5.40 cm long, and 152 fringe shifts occur as the pressure of the gas in the tube increases to atmospheric pressure. What is the index of refraction of the gas? Hint: The fringe shifts occur because the wavelength of the light changes inside the gas-filled tube. (Give your answer to five decimal places.) 4.0arrow_forwardA thin layer of a transparent material that has an index of refraction of 1.25 is used as a nonreflective coating on the surface of glass that has an index of refraction of 1.50. What should the minimum thickness of the material be for the material to be nonreflecting for light that has a wavelength of 578 nm?arrow_forwardThe index of refraction of silicate flint glass for red light is 1.620 and for violet light is 1.660. A beam of white light in this glass strikes the glass-air interface at a 28.30° angle of incidence and refracts out into the air. What is the angular separation A between the red and violet components of the spectrum that emerges from the glass? A0=arrow_forward
- A light ray is incident at 45° on a glass block immersed inside a liquid of refractive index nL = 1.33 as shown in the figure below. In this configuration, the refractive ray skims the bottom surface. Determine the refractive index of the glass, ng. ng 45° ng = 1.63 ng = 1.7 ng = 1.48 ng = 1.51 O ng = 1.57arrow_forwardA technician places a fluid substance, with a refractive index of 1.61, between two horizontal panes of flat glass (each of which has n = 1.55). He then illuminates the assembly from above with monochromatic light (? = 620 nm). What is the minimum thickness (in nm) that the liquid layer must have, if the light is to be strongly reflected back toward its source? answer in nmarrow_forwardA sodium light, having wavelength 632.8 nm, is used to view a soap film to make it look black when directed perpendicular to the film. What is the minimum thickness of the soap film if the index of refraction of soap solution is 1.33? 158 nm 119 nm 476 nm 316 nm 238 nmarrow_forward
- Light from a laser penetrates a glass block at A and emerges at B; see figure. The glass block has a length L = 54.7 cm and a refractive index n = 1.63. The angle incidence is θ = 24.0 °. Determine the time required for the light to pass through the block.arrow_forwardA ray of light originates inside the glass filled with water, as shown in the figure. It travels through water, in incident on the glass side, and emerges into the air. Ignore any partial reflections. What is the values of angles Q? Water n=1.33 370 Air Glass n = 1.0 n= 1.5 32.25° 67.16° 53.17° 35.89°arrow_forwardAn instructor places a fluid substance, with a refractive index of 1.61, between two horizontal panes of flat glass (each of which has n = 1.55). She then illuminates the assembly from above with monochromatic light (? = 700 nm). What is the minimum thickness (in nm) that the liquid layer must have, if the light is to be strongly reflected back toward its source? ??nmarrow_forward
- In the figure below, assume that two waves of light in the air are innitially in phase. One wave travels through a layer of a material of index of refraction n1 = 1.5 and thickness L = 0.5 micro m. The other travels through an equally thick plastic layer of index of refraction n2 = 2. The wavelength of the light is 500nm. If after transversing the materials the waves arrive at some common point with the same amplitude, is there interference fully constructive, fully destructive, intermediate but closer to fully constructive, or intermediate but closer to fully destructive.arrow_forwardLaser light of wavelength 460 nmnm is traveling in air and shines at normal incidence onto the flat end of a transparent plastic rod that has nn = 1.30. The end of the rod has a thin coating of a transparent material that has refractive index 1.75. a)What is the minimum (nonzero) thickness of the coating for which there is maximum transmission of the light into the rod? b)What is the minimum (nonzero) thickness of the coating for which transmission into the rod is minimized?arrow_forwardNon-reflective coating is put on eyeglasses. Magnesium fluoride MgF2 is used. The refractive index of MgF2 is 1.38. Designed for light of wavelength 584 nm, the thinnest coating thickness needed is nm. Type your answer....arrow_forward
- Physics for Scientists and Engineers with Modern ...PhysicsISBN:9781337553292Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningPhysics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage LearningPrinciples of Physics: A Calculus-Based TextPhysicsISBN:9781133104261Author:Raymond A. Serway, John W. JewettPublisher:Cengage Learning