Concept explainers
A plastic film with index of refraction 1.70 is applied to the surface of a car window to increase the reflectivity and thus to keep the car’s interior cooler. The window glass has index of refraction 1.52. (a) What minimum thickness is required if light of wavelength 550 nm in air reflected from the two sides of the film is to interfere constructively? (b) Coatings as thin as that calculated in part (a) are difficult to manufacture and install. What is the next greater thickness for which constructive interference will also occur?
Want to see the full answer?
Check out a sample textbook solutionChapter 35 Solutions
University Physics (14th Edition)
Additional Science Textbook Solutions
The Cosmic Perspective (8th Edition)
Physics for Scientists and Engineers with Modern Physics
College Physics
Essential University Physics: Volume 2 (3rd Edition)
Cosmic Perspective Fundamentals
- To save money on making military aircraft invisible to radar, an inventor decides to coat them with a nonreflective material having an index of refraction of 1.20, which is between that of air and the surface of the plane. This, he reasons, should be much cheaper than designing Stealth bombers. (a) What thickness should the coating be to inhibit the reflection of 4.00-cm wavelength radar? (b) What is unreasonable about this result? (c) Which assumptions are unreasonable or inconsistent?arrow_forwardA beam of 580-nm light passes through two closely spaced glass plates at close to normal incidence as shown in Figure P27.23. For what minimum nonzero value of the plate separation d is the transmitted light bright?arrow_forwardAstronomers observe the chromosphere of the Sun with a filter that passes the red hydrogen spectral line of wavelength 656.3 nm, called the H line. The filter consists of a transparent dielectric of thickness d held between two partially aluminized glass plates. The filter is held at a constant temperature. (a) Find the minimum value of d that produces maximum transmission of perpendicular H light if the dielectric has an index of refraction of 1.378. (b) What If? If the temperature of the filter increases above the normal value, increasing its thickness, what happens to the transmitted wavelength? (c) The dielectric will also pass what near-visible wavelength? One of the glass plates is colored red to absorb this light.arrow_forward
- The movable mirror of a Michelson interferometer is attached to one end of a thin metal rod of length 23.3 mm. The other end of the rod is anchored so it does not move. As the temperature of the rod changes from 15°C to 25 C , a change of 14 fringes is observed. The light source is a He Ne laser, =632.8 nm . What is the change in length of the metal bar, and what is its thermal expansion coefficient?arrow_forwardA thin uniform film of refractive index 1.750 is placed on a sheet of glass with a refractive index 1.50. At room temperature (22.4 °C), this film is just thick enough for light with a wavelength 580.5 nm reflected off the top of the film to be canceled by light reflected from the top of the glass. After the glass is placed in an oven and slowly heated to 176 °C, you find that the film cancels reflected light with a wavelength 588.0 nm Part A What is the coefficient of linear expansion of the film? (Ignore any changes in the refractive index of the film due to the temperature change.) Express your answer using two significant figures. α = Submit 96 ΫΠ ΑΣΦ Request Answer ? Review | Constants (°C) -¹arrow_forwardWhat is the smallest nonzero thickness of an oil (n = 1.46) layer on water that will maximally reflect normally incident light of wavelength 573 nm?arrow_forward
- Problem 7. After a car is painted, a highly reflective coating is sprayed on to make the car look extra shiny. The index of refraction of the coating is less than the index of refraction of the paint underneath. 14. The minimum thickness needed for this coating is 100 nm. Find the index of refraction of this coating if it is highly reflective for a wavelength = 510 nm, near the center of the visible spectrum. (A) 5.61 (B) 6.94 (C) 3.56 (D) 4.89 (E) 2.55arrow_forwardAstronomers observe the chromosphere of the Sun with a filter that passes the red hydrogen spectral line of wavelength 656.3 nm, called the H, line. The filter consists of a transparent dielectric of thickness d held between two partially aluminized glass plates. The filter is held at a constant temperature. (a) Find the minimum value of d that produces maximum transmission of perpendicular H, light if the dielectric has an index of refraction of 1.494. (Assume that the glass's refractive index exceeds 1.494.) nm (b) If the temperature of the filter increases above the normal value, increases its thickness, what happens to the transmitted wavelength? (Its index of refraction does not change significantly.) O It increases. O It decreases. O It remains unchanged. (c) The dielectric will also pass what near-visible wavelength? One of the glass plates is colored red to absorb this light. nm Additional Materials O eBookarrow_forwardLaser light of wavelength 460 nmnm is traveling in air and shines at normal incidence onto the flat end of a transparent plastic rod that has nn = 1.30. The end of the rod has a thin coating of a transparent material that has refractive index 1.75. a)What is the minimum (nonzero) thickness of the coating for which there is maximum transmission of the light into the rod? b)What is the minimum (nonzero) thickness of the coating for which transmission into the rod is minimized?arrow_forward
- A thin film of polystyrene is used as an antireflective coating for fabulite (known as the substrate). The index of refraction of the polystyrene is 1.49, and the index of refraction of the fabulite is 2.409. What is the minimum thickness of film required? Assume that the wavelength of the light in air is 490 nanometers.arrow_forwardA thin film of thickness 0.4 x 10-6 m and refractive index 1.4 is coated on plastic of refractive index 1.3. Red light of wavelength 560 nm is incident normally on the film. (a) Determine total path difference between light reflecting from the top and bottom of the film (b) Express path difference in terms of wavelength. (c) what type of interference do we have for the reflected light?arrow_forwardA sheet of glass having an index of refraction of 1.46 is to be coated with a film of material having an index of refraction of 1.59 in order that green light with a wavelength of 535 nm (in air) will be preferentially transmitted via constructive interference. (a) What is the minimum thickness of the film that will achieve the result?arrow_forward
- Principles of Physics: A Calculus-Based TextPhysicsISBN:9781133104261Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningUniversity Physics Volume 3PhysicsISBN:9781938168185Author:William Moebs, Jeff SannyPublisher:OpenStaxPhysics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage Learning
- Glencoe Physics: Principles and Problems, Student...PhysicsISBN:9780078807213Author:Paul W. ZitzewitzPublisher:Glencoe/McGraw-Hill