
Concept explainers
A cannon is fired over level ground at an angle of 35° to the horizontal. The initial velocity of the cannonball is 500 m/s, but because the cannon is fired at an angle, the vertical component of the velocity is 287 m/s and the horizontal component is 410 m/s.
- a. How long is the cannonball in the air? (Use g = 10 m/s2 and the fact that the total time of flight is twice the time required to reach the high point.)
- b. How far does the cannonball travel horizontally?
- c. Repeat these calculations, assuming that the cannon was fired at a 55° angle to the horizontal, resulting in a vertical component of velocity of 410 m/s and a horizontal component of 287 m/s. How does the distance traveled compare to the earlier result? (See fig. 3.20.)
(a)

The time of flight of the ball.
Answer to Problem 4SP
The time of flight of the ball is
Explanation of Solution
Given Info: A cannon is fired over the ground level at an angle of
Write the expression for the time required to reach the high point.
Here,
Substitute
Write the expression for the time of flight.
Here,
Substitute
Conclusion:
Thus, the time of flight of the ball is
(b)

The distance travelled by the cannonball horizontally.
Answer to Problem 4SP
The distance travelled by the cannonball horizontally is
Explanation of Solution
Given Info: A cannon is fired over the ground level at an angle of
Write the expression for the distance travelled horizontally.
Here,
Substitute
Conclusion:
Thus, the distance travelled by the cannonball horizontally is
(c)

Repeat the above results for angle
Answer to Problem 4SP
The time of flight of the ball is
Explanation of Solution
Given Info: A cannon is fired over the ground level at an angle of
Write the expression for the time required to reach the high point.
Substitute
Write the expression for the time of flight.
Substitute
Write the expression for the distance travelled horizontally.
Substitute
Conclusion:
Thus, the time of flight of the ball is
Want to see more full solutions like this?
Chapter 3 Solutions
Physics of Everyday Phenomena
- What are the expected readings of the ammeter and voltmeter for the circuit in the figure below? (R = 5.60 Ω, ΔV = 6.30 V) ammeter I =arrow_forwardsimple diagram to illustrate the setup for each law- coulombs law and biot savart lawarrow_forwardA circular coil with 100 turns and a radius of 0.05 m is placed in a magnetic field that changes at auniform rate from 0.2 T to 0.8 T in 0.1 seconds. The plane of the coil is perpendicular to the field.• Calculate the induced electric field in the coil.• Calculate the current density in the coil given its conductivity σ.arrow_forward
- An L-C circuit has an inductance of 0.410 H and a capacitance of 0.250 nF . During the current oscillations, the maximum current in the inductor is 1.80 A . What is the maximum energy Emax stored in the capacitor at any time during the current oscillations? How many times per second does the capacitor contain the amount of energy found in part A? Please show all steps.arrow_forwardA long, straight wire carries a current of 10 A along what we’ll define to the be x-axis. A square loopin the x-y plane with side length 0.1 m is placed near the wire such that its closest side is parallel tothe wire and 0.05 m away.• Calculate the magnetic flux through the loop using Ampere’s law.arrow_forwardDescribe the motion of a charged particle entering a uniform magnetic field at an angle to the fieldlines. Include a diagram showing the velocity vector, magnetic field lines, and the path of the particle.arrow_forward
- Discuss the differences between the Biot-Savart law and Coulomb’s law in terms of their applicationsand the physical quantities they describe.arrow_forwardExplain why Ampere’s law can be used to find the magnetic field inside a solenoid but not outside.arrow_forward3. An Atwood machine consists of two masses, mA and m B, which are connected by an inelastic cord of negligible mass that passes over a pulley. If the pulley has radius RO and moment of inertia I about its axle, determine the acceleration of the masses mA and m B, and compare to the situation where the moment of inertia of the pulley is ignored. Ignore friction at the axle O. Use angular momentum and torque in this solutionarrow_forward
- A 0.850-m-long metal bar is pulled to the right at a steady 5.0 m/s perpendicular to a uniform, 0.650-T magnetic field. The bar rides on parallel metal rails connected through a 25-Ω, resistor (Figure 1), so the apparatus makes a complete circuit. Ignore the resistance of the bar and the rails. Please explain how to find the direction of the induced current.arrow_forwardFor each of the actions depicted, determine the direction (right, left, or zero) of the current induced to flow through the resistor in the circuit containing the secondary coil. The coils are wrapped around a plastic core. Immediately after the switch is closed, as shown in the figure, (Figure 1) in which direction does the current flow through the resistor? If the switch is then opened, as shown in the figure, in which direction does the current flow through the resistor? I have the answers to the question, but would like to understand the logic behind the answers. Please show steps.arrow_forwardWhen violet light of wavelength 415 nm falls on a single slit, it creates a central diffraction peak that is 8.60 cm wide on a screen that is 2.80 m away. Part A How wide is the slit? ΟΙ ΑΣΦ ? D= 2.7.10-8 Submit Previous Answers Request Answer × Incorrect; Try Again; 8 attempts remaining marrow_forward
- Principles of Physics: A Calculus-Based TextPhysicsISBN:9781133104261Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningPhysics for Scientists and Engineers with Modern ...PhysicsISBN:9781337553292Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningPhysics for Scientists and EngineersPhysicsISBN:9781337553278Author:Raymond A. Serway, John W. JewettPublisher:Cengage Learning
- Physics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage LearningPhysics for Scientists and Engineers, Technology ...PhysicsISBN:9781305116399Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningUniversity Physics Volume 1PhysicsISBN:9781938168277Author:William Moebs, Samuel J. Ling, Jeff SannyPublisher:OpenStax - Rice University





