Heating, Ventilation, and Air Conditioning: Analysis and Design
Heating, Ventilation, and Air Conditioning: Analysis and Design
6th Edition
ISBN: 9781119628798
Author: Faye C. McQuiston; Jerald D. Parker; Jeffrey D. Spitler
Publisher: Wiley Global Education US
bartleby

Videos

Textbook Question
Book Icon
Chapter 3, Problem 3.1P

A space is at a temperature of 75 F (24 C), and the relative humidity is 45 percent. Find (a) the partial pressures of the air and water vapor, (b) the vapor density, and (c) the humidity ratio of the mixture. Assume standard sea-level pressure.

(a)

Expert Solution
Check Mark
To determine

The partial pressure of the air.

The partial pressure of water vapor.

Answer to Problem 3.1P

The value of partial pressure of air is 99.57kPa .

The value of partial pressure of vapor is 1.43kPa .

Explanation of Solution

Given:

The temperature of the space is T=75F(24°C) .

The relative humidity is ϕr=45% .

Formula used:

The expression for the partial pressure of air is given as,

  Pa=PatmPv

Here, Patm is the atmospheric pressure and its value is 101kPa and Pv is the vapor pressure.

The expression for the partial pressure of vapor is given as,

  Pv=ϕrPs

Here, Ps is the saturation temperature at 24°C .

Calculation:

The partial pressure of vapor can be calculated as,

  Pv=ϕrPsPv=0.45×(3.17kPa)Pv=1.43kPa

The partial pressure of air can be calculated as,

  Pa=PatmPvPa=(1011.43)kPaPa=99.57kPa

Conclusion:

Therefore, the value of partial pressure of air is 99.57kPa .

Therefore, the value of partial pressure of vapor is 1.43kPa .

(b)

Expert Solution
Check Mark
To determine

The vapor density.

Answer to Problem 3.1P

The value of vapor density is 0.0104kg/m3 .

Explanation of Solution

Given:

The temperature of the space is T=75F(24°C) .

The relative humidity is ϕr=45% .

Formula used:

The expression for the vapor density is given as,

  ρv=PvRv×T

Here, Rv is the gas constant of water vapor and its value is 462.5J/kgK .

Calculation:

The vapor density can be calculated as,

  ρv=PvRv×Tρv=1430Pa462.5J/kgK×( 297K)ρv=0.0104kg/m3

Conclusion:

Therefore, the value of vapor density is 0.0104kg/m3 .

(c)

Expert Solution
Check Mark
To determine

The humidity ratio of the mixture.

Answer to Problem 3.1P

The value of humidity ratio is 0.00893kgv/kga .

Explanation of Solution

Given:

The temperature of the space is T=75F(24°C) .

The relative humidity is ϕr=45% .

Formula used:

The expression for the humidity ratio is given as,

  W=0.6219×Pv(Pa+Pv)Pv

Calculation:

The humidity ratio can be calculated as,

  W=0.6219×Pv( P a + P v )PvW=0.6219×1.43kPa( 99.57+1.43)kPa1.43kPaW=0.00893kgv/kga

Conclusion:

Therefore, the value of humidity ratio is 0.00893kgv/kga .

Want to see more full solutions like this?

Subscribe now to access step-by-step solutions to millions of textbook problems written by subject matter experts!
03:55
Students have asked these similar questions
Please help, make sure it's to box out and make it clear what answers go where...
A triangular distributed load of max intensity w acts on beam AB. The beam is supported by a pin at A and member CD, which is connected by pins at C and D respectively. Determine the largest load intensity, Wmax, that can be applied if the pin at D can support a maximum force of 18000 N. Also determine the reactions at A and C and express each answer in Cartesian components. Assume the masses of both beam and member ✓ are negligible. Dwas шал = A BY NC SA 2016 Eric Davishahl C D -a- Ур -b- X B W Values for dimensions on the figure are given in the following table. Note the figure may not be to scale. Variable Value a 6.6 m b 11.88 m C 4.29 m The maximum load intensity is = wmax N/m. The reaction at A is A = The reaction at C is = i+ Ĵ N. ĴN. 12 i+
The beam is supported by a pin at B and a roller at C and is subjected to the loading shown with w =110 lb/ft, and F 205 lb. a.) If M = 2,590 ft-lb, determine the support reactions at B and C. Report your answers in both Cartesian components. b.) Determine the largest magnitude of the applied couple M for which the beam is still properly supported in equilibrium with the pin and roller as shown. 2013 Michael Swanbom CC BY NC SA M ру W B⚫ C F ka b Values for dimensions on the figure are given in the following table. Note the figure may not be to scale. Variable Value a 3.2 ft b 6.4 ft C 3 ft a.) The reaction at B is B = The reaction at C is C = ĵ lb. i+ Ĵ lb. b.) The largest couple that can be applied is M ft-lb. == i+

Chapter 3 Solutions

Heating, Ventilation, and Air Conditioning: Analysis and Design

Ch. 3 - The environmental conditions in a room are to be...Ch. 3 - Air enters a cooling coil at the rate of 5000 cfm...Ch. 3 - Air flowing in a duct has dry and wet bulb...Ch. 3 - Air is humidified with the dry bulb temperature...Ch. 3 - Air at 38 C db and 20 C wb is humidified...Ch. 3 - Two thousand cfm (1.0 m3/s) of air at an initial...Ch. 3 - Air at 40 F (5 C) db and 35 F (2 C) wb is mixed...Ch. 3 - Rework Problem 3-25, using Chart 1a, with the...Ch. 3 - The design cooling load for a zone in a building...Ch. 3 - Assume that the air in Problem 3-22 is supplied to...Ch. 3 - The sensible heat loss from a space is 500,000...Ch. 3 - Air enters a refrigeration coil at 90 Fdb and 75...Ch. 3 - A building has a total heating load of 200,000...Ch. 3 - Reconsider Problem 3-36 for an elevation of 5000...Ch. 3 - The system of Problem 3-34 has a supply air fan...Ch. 3 - An evaporative cooling system is to be used to...Ch. 3 - A cooling system is being designed for use at high...Ch. 3 - Consider a space heating system designed as shown...Ch. 3 - A variable-air-volume VAV cooling system is a type...Ch. 3 - Rework Problem 3-43 for an elevation of 5000 feet...Ch. 3 - The design condition for a space is 77 F (25 C) db...Ch. 3 - Rework Problem 3-45 for an elevation of 5000 feet...Ch. 3 - It is necessary to cool and dehumidify air from 80...Ch. 3 - Conditions in one zone of a dual-duct conditioning...Ch. 3 - Rework Problem 3-48 for an elevation of 5000 ft...Ch. 3 - A water coil in Problem 3-48 cools return air to...Ch. 3 - A multizone air handler provides air to several...Ch. 3 - Under normal operating conditions a zone has a...Ch. 3 - An interior zone of a large building is designed...Ch. 3 - Outdoor air is mixed with room return air to...Ch. 3 - Consider an enclosed swimming pool. The pool area...Ch. 3 - One particular zone served by a multizone air...Ch. 3 - A research building requires 100 percent outdoor...Ch. 3 - A space requires cooling in the amount of 120,000...

Additional Engineering Textbook Solutions

Find more solutions based on key concepts
Write an input validation loop that asks the user to enter the word yes or no.

Starting Out with Java: From Control Structures through Objects (7th Edition) (What's New in Computer Science)

What type of recursive method do you think would be more difficult to debug: one that uses direct recursion or ...

Starting Out with Java: From Control Structures through Data Structures (4th Edition) (What's New in Computer Science)

You need to write a multiple alternative decision structure, but the language you are using will not allow you ...

Starting Out with Programming Logic and Design (5th Edition) (What's New in Computer Science)

Knowledge Booster
Background pattern image
Mechanical Engineering
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.
Similar questions
SEE MORE QUESTIONS
Recommended textbooks for you
Text book image
Refrigeration and Air Conditioning Technology (Mi...
Mechanical Engineering
ISBN:9781305578296
Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson
Publisher:Cengage Learning
The Refrigeration Cycle Explained - The Four Major Components; Author: HVAC Know It All;https://www.youtube.com/watch?v=zfciSvOZDUY;License: Standard YouTube License, CC-BY