To indicate the location of 1 1 2 1 2 and 1 2 1 4 1 2 point co-ordinates for tetragonal unit cell.

Question

Want to see the full answer?

Answer 1

Question

Chapter 3, Problem 27QAP

To determine

To sketch:

To indicate the location of 11212 and 121412 point co-ordinates for tetragonal unit cell.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

1.11 (a) A test piece is cut from a brass bar and subjected to a tensile test. With a load of 6.4 kN the test piece, of diameter 11.28 mm, extends by 0.04 mm over a gauge length of 50 mm. Determine: (i) the stress, (ii) the strain, (hi) the modulus of elasticity. (b) A spacer is turned from the same bar. The spacer has a diameter of 28 mm and a length of 250mm. both measurements being made at 20°C. The temperature of the spacer is then increased to 100°C, the natural expansion being entirely prevented. Taking the coefficient of linear expansion to be 18 x 10-6/"C determine: (i) the stress in the spacer, (ii) the compressive load on the spacer. [C.G.] [64MN/m2, 0.0008, 80GN/m2, 115.2 MN/m2, 71 KN.] 10:41

Don't use ai to answer I will report you answer

2. If the Ce value in Fig. 11-7 is changed to 0.1 μF, is the output still a PWM waveform? Explain. C₁ 0.014 C₂ 100 R₁ 300 HF 8 Vcc 4 reset output 3 discharge 7 2 trigger 5 control voltage U₁ LM555 6 threshold GND ODUCT R₂ 10k ww Bo +12 V 22 R3 1k VR 5k www Re 300 C5 100 ww 8 Vcc 4 reset output 3 2 trigger 7 discharge ли R7 10k PWM Output threshold C6 -0.014 5 control voltage GND Rs 2k CA U2 LM555 1 100μ C3 0.01 Audio lutput Fig. 11-7 Pulse width modulator