The compound that results after transamination of alanine should be determined. Concept introduction: Protein catabolism: It is defined as breakdown of proteins into smaller units that is into amino acids gets transported finally polymerized to give new proteins. Transamination: The reaction that transfers amino group into ketone group which results to form new set of amino acid. Substrate: The molecule where the reaction takes place with help of enzymes. Coenzyme: They are non-proteins molecules which helps enzymes for catalyzing the reaction. Enzyme: The proteins that helps chemical reaction to occur. Oxidation: The oxidation is reaction that involves addition of oxygen atom or loss of electrons or removal of hydrogen atom present in the chemical compound. Reduction: It involves removal of oxygen or addition of hydrogen to the chemical compound. Coenzyme: They are non-proteins molecules which helps enzymes for catalyzing the reaction.

Question

A cylinder contains 12 L of water vapour at 150˚C and 5 atm. The temperature of the water vapour is raised to 175˚C, and the volume of the cylinder is reduced to 8.5 L. What is the final pressure of the gas in atmospheres? assume that the gas is ideal

Answer 1

Question

Chapter 24.8, Problem 15P

Interpretation Introduction

Interpretation:

The compound that results after transamination of alanine should be determined.

Concept introduction:

Protein catabolism: It is defined as breakdown of proteins into smaller units that is into amino acids gets transported finally polymerized to give new proteins.

Transamination: The reaction that transfers amino group into ketone group which results to form new set of amino acid.

Substrate: The molecule where the reaction takes place with help of enzymes.

Coenzyme: They are non-proteins molecules which helps enzymes for catalyzing the reaction.

Enzyme: The proteins that helps chemical reaction to occur.

Oxidation: The oxidation is reaction that involves addition of oxygen atom or loss of electrons or removal of hydrogen atom present in the chemical compound.

Reduction: It involves removal of oxygen or addition of hydrogen to the chemical compound.

Coenzyme: They are non-proteins molecules which helps enzymes for catalyzing the reaction.

Expert Solution & Answer

Trending nowThis is a popular solution!

See solution

Check out sample textbook solution

Students have asked these similar questions

A cylinder contains 12 L of water vapour at 150˚C and 5 atm. The temperature of the water vapour is raised to 175˚C, and the volume of the cylinder is reduced to 8.5 L. What is the final pressure of the gas in atmospheres? assume that the gas is ideal

On the next page is an LC separation of the parabens found in baby wash. Parabens are suspected in a link to breast cancer therefore an accurate way to quantitate them is desired. a. In the chromatogram, estimate k' for ethyl paraben. Clearly indicate what values you used for all the terms in your calculation. b. Is this a "good" value for a capacity factor? Explain. c. What is the resolution between n-Propyl paraben and n-Butyl paraben? Again, indicate clearly what values you used in your calculation. MAU | Methyl paraben 40 20 0 -2 Ethyl paraben n-Propyl paraben n-Butyl paraben App ID 22925 6 8 min

d. In Figure 4, each stationary phase shows some negative correlation between plate count and retention factor. In other words, as k' increases, N decreases. Explain this relationship between k' and N. Plate Count (N) 4000 3500 2500 2000 1500 1000 Figure 4. Column efficiency (N) vs retention factor (k') for 22 nonionizable solutes on FMS (red), PGC (black), and COZ (green). 3000 Eluent compositions (acetonitrile/water, A/W) were adjusted to obtain k' less than 15, which was achieved for most solutes as follows: FMS (30/70 A/W), PGC (60/40), COZ (80/20). Slightly different compositions were used for the most highly retained solutes. All columns were 50 mm × 4.6 mm id and packed with 5 um particles, except for COZ, which was packed with 3 um particles. All other chromatographic conditions were constant: column length 5 cm, column j.§. 4.6 mm, flow rate 2 mL/min, column temperature 40 °C, and injection volume 0.5 μL Log(k'x/K'ethylbenzene) FMS 1.5 1.0 0.5 0.0 ཐྭ ཋ ཤྩ བྷྲ ; 500 0 5 10…