The rate of the enzyme in the presence of both the product in high number in case of cumulative feedback inhibition is to be calculated. Concept introduction: Biological reactions are catalyzed by biological catalyst known as enzymes. Enzymes do not take part in reaction rather it decreases the activation energy. In some reactions, the excess amount of product formation decreases the enzyme activity. This is known as feedback inhibition.

Question

Want to see the full answer?

Answer 1

Question

Chapter 24, Problem 28P

Interpretation Introduction

Interpretation:

The rate of the enzyme in the presence of both the product in high number in case of cumulative feedback inhibition is to be calculated.

Concept introduction:

Biological reactions are catalyzed by biological catalyst known as enzymes. Enzymes do not take part in reaction rather it decreases the activation energy. In some reactions, the excess amount of product formation decreases the enzyme activity. This is known as feedback inhibition.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

The preferred substrate is T because the enzyme half-saturates at 7.00 mM for T, but requires 28.0 mM for U, and 112 mM for S. b Question Content Area The rate constant k 2 with substrate S is 9.60×107 sec-1, with substrate T, k 2 = 6.00×104 sec-1, and with substrate U, k 2 = 2.40×106 sec-1. Calculate the catalytic efficiency with S, T, and U. Catalytic efficiency with S = Catalytic efficiency with T = Catalytic efficiency with U = Does enzyme A use substrate S, substrate T, or substrate U with greater catalytic efficiency?

Fumerase catalyzes the conversion of fumerate to malate. fumerate + H2O ⇋ malate The turnover number, kcat, for fumerase is 8.00×102 sec-1. The Km of this enzyme for fumerate is 5.00×10-3 μmol mL-1. a In an experiment using 2.00×10-3 μmol·mL-1, what is Vmax?

Suppose you wanted to make a buffer of exactly pH 7.00 using KH2PO4 and Na2HPO4. If the final solution was 0.18 M in KH2PO4, you would need 0.25 M Na2HPO4. Now assume you wish to make a buffer at the same pH, using the same substances, but want the total phosphate molarity ([HPO42−]+[H2PO−4]) to equal 0.20 M. What concentration of the Na2HPO4 would be required?