The complete oxidation of glucose 6-phosphate derived from free glucose yields30 molecules ATP, whereas the complete oxidation of glucose 6- phosphate derived from glycogen yields 31 molecules of ATP , this difference should be accounted. Concept introduction: Glycogen is a readily mobilized storage form of glucose. It is a very large, branched polymer of glucose residues that can be broken down to yield glucose molecules when energy is needed. Enzyme phosphoglucomutase breakdown glycogen into glucose 6-phosphate. Catalyzed by the glycogen phosphorylase enzyme.

Question

Want to see the full answer?

Answer 1

Question

Chapter 21, Problem 25P

Interpretation Introduction

Interpretation:

The complete oxidation of glucose 6-phosphate derived from free glucose yields30 molecules ATP, whereas the complete oxidation of glucose 6- phosphate derived from glycogen yields 31 molecules of ATP , this difference should be accounted.

Concept introduction:

Glycogen is a readily mobilized storage form of glucose. It is a very large, branched polymer of glucose residues that can be broken down to yield glucose molecules when energy is needed.

Enzyme phosphoglucomutase breakdown glycogen into glucose 6-phosphate. Catalyzed by the glycogen phosphorylase enzyme.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

The preferred substrate is T because the enzyme half-saturates at 7.00 mM for T, but requires 28.0 mM for U, and 112 mM for S. b Question Content Area The rate constant k 2 with substrate S is 9.60×107 sec-1, with substrate T, k 2 = 6.00×104 sec-1, and with substrate U, k 2 = 2.40×106 sec-1. Calculate the catalytic efficiency with S, T, and U. Catalytic efficiency with S = Catalytic efficiency with T = Catalytic efficiency with U = Does enzyme A use substrate S, substrate T, or substrate U with greater catalytic efficiency?

Fumerase catalyzes the conversion of fumerate to malate. fumerate + H2O ⇋ malate The turnover number, kcat, for fumerase is 8.00×102 sec-1. The Km of this enzyme for fumerate is 5.00×10-3 μmol mL-1. a In an experiment using 2.00×10-3 μmol·mL-1, what is Vmax?

Suppose you wanted to make a buffer of exactly pH 7.00 using KH2PO4 and Na2HPO4. If the final solution was 0.18 M in KH2PO4, you would need 0.25 M Na2HPO4. Now assume you wish to make a buffer at the same pH, using the same substances, but want the total phosphate molarity ([HPO42−]+[H2PO−4]) to equal 0.20 M. What concentration of the Na2HPO4 would be required?