‘Tritium contains one proton and two neutrons. There is no significant proton-proton repulsion present in the nucleus. But tritium is radioactive’- The reason should be explained. Concept Introduction: Unstable nuclei emit radiation spontaneously to become stable nuclei by losing energy. This process of emission of radiation by unstable nuclei is known as radioactive decay. These emitted radiations may be alpha radiations( α ), beta radiations( β ) or gamma radiations( γ ) These unstable nuclei are the nuclei with more than 83 protons and which do not lie within the belt of stability If the N/P ratio of nucleus is more or less than one which lies outside the belt of stability and it exhibits radioactivity. To explain: The reason for the radioactivity of tritium.

Question

Want to see the full answer?

Answer 1

Question

Chapter 20, Problem 20.76QP

Interpretation Introduction

Interpretation:

‘Tritium contains one proton and two neutrons. There is no significant proton-proton repulsion present in the nucleus. But tritium is radioactive’- The reason should be explained.

Concept Introduction:

Unstable nuclei emit radiation spontaneously to become stable nuclei by losing energy. This process of emission of radiation by unstable nuclei is known as radioactive decay.

These emitted radiations may be alpha radiations( α ), beta radiations( β ) or gamma radiations( γ )

These unstable nuclei are the nuclei with more than 83 protons and which do not lie within the belt of stability

If the N/P ratio of nucleus is more or less than one which lies outside the belt of stability and it exhibits radioactivity.

To explain: The reason for the radioactivity of tritium.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

In an effort to reduce costs and increase the accessibility of instruments that utilize spectrophotometric detection, some researchers are beginning to experiment with 3D-printed parts. One example of this is the 3D-printed flow cell, shown at right. This device was made using polylactic acid and accommodates a LED at one end and a detector at the other. It can be used for standalone flow injection spectrophotometry or coupled to a chromatographic separation to be used as a detector. Explain why the sensitivity varies with the length of the flow cell, as shown in the data below. Could this setup be used for fluorescence analysis? Why or why not?

The dark lines in the solar spectrum were discovered by Wollaston and cataloged by Fraunhofer in the early days of the 19th century. Some years later, Kirchhoff explained the appearance of the dark lines: the sun was acting as a continuum light source and metals in the ground state in its atmosphere were absorbing characteristic narrow regions of the spectrum. This discovery eventually spawned atomic absorption spectrometry, which became a routine technique for chemical analysis in the mid-20th century. Laboratory-based atomic absorption spectrometers differ from the original observation of the Fraunhofer lines because they have always employed a separate light source and atomizer. This article describes a novel atomic absorption device that employs a single source, the tungsten coil, as both the generator of continuum radiation and the atomizer of the analytes. A 25-μL aliquot of sample is placed on the tungsten filament removed from a commercially available 150-W light bulb. The…

Don't used hand raiting and don't used Ai solution