The term snRNPs has to be defined, and the manner in that they are able to facilitate RNA splicing has to be determined. Concept Introduction: RNA splicing is a very significant post-translational modification; however, it must be done with high fidelity. The particles that assist in such precise RNA splicing are called spliceosomes. If excess or a very small amount of RNA is removed from the transcript then the mRNA will not be able to carry the correct code for the protein. Therefore there are certain signals that serve to demarcate the boundaries for the introns. Identification of such splice boundaries and stability to the splicing complex is conferred by means of particles that are termed as the spliceosome.

Question

Want to see the full answer?

Answer 1

Question

Chapter 20, Problem 20.52QP

Interpretation Introduction

Interpretation:

The term snRNPs has to be defined, and the manner in that they are able to facilitate RNA splicing has to be determined.

Concept Introduction:

RNA splicing is a very significant post-translational modification; however, it must be done with high fidelity. The particles that assist in such precise RNA splicing are called spliceosomes.

If excess or a very small amount of RNA is removed from the transcript then the mRNA will not be able to carry the correct code for the protein. Therefore there are certain signals that serve to demarcate the boundaries for the introns. Identification of such splice boundaries and stability to the splicing complex is conferred by means of particles that are termed as the spliceosome.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

There is an instrument in Johnson 334 that measures total-reflectance x-ray fluorescence (TXRF) to do elemental analysis (i.e., determine what elements are present in a sample). A researcher is preparing a to measure calcium content in a series of well water samples by TXRF with an internal standard of vanadium (atomic symbol: V). She has prepared a series of standard solutions to ensure a linear instrument response over the expected Ca concentration range of 40-80 ppm. The concentrations of Ca and V (ppm) and the instrument response (peak area, arbitrary units) are shown below. Also included is a sample spectrum. Equation 1 describes the response factor, K, relating the analyte signal (SA) and the standard signal (SIS) to their respective concentrations (CA and CIS). Ca, ppm V, ppm SCa, arb. units SV, arb. units 20.0 10.0 14375.11 14261.02 40.0 10.0 36182.15 17997.10 60.0 10.0 39275.74 12988.01 80.0 10.0 57530.75 14268.54 100.0…

A mixture of 0.568 M H₂O, 0.438 M Cl₂O, and 0.710 M HClO are enclosed in a vessel at 25 °C. H₂O(g) + C₁₂O(g) = 2 HOCl(g) K = 0.0900 at 25°C с Calculate the equilibrium concentrations of each gas at 25 °C. [H₂O]= [C₁₂O]= [HOCI]= M Σ M

What units (if any) does the response factor (K) have? Does the response factor (K) depend upon how the concentration is expressed (e.g. molarity, ppm, ppb, etc.)?