Physics for Scientists and Engineers
10th Edition
ISBN: 9781337553278
Author: Raymond A. Serway, John W. Jewett
Publisher: Cengage Learning
expand_more
expand_more
format_list_bulleted
Concept explainers
Question
Chapter 19, Problem 11P
To determine
The distance at which skier glider has to ski to melt 1.00 kg
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solution
Students have asked these similar questions
Imagine a physics lecture hall with 83 students who are settling in for a 1-hour lecture. At the start of the lecture, the temperature of the air in the room is a comfortable 70oF (21.1°C). Unfortunately, the room’s air conditioner breaks right as the lecture begins. Each student has an average power output of about 60.0 W at room temperature. Imagine the energy released by each student goes into heating just the air in the room, which has a volume of 9.50 × 102 m3 and a density of 1.20 kg/m3. Assume the volume of the air remains constant and the specific heat capacity of the air is 718 J/(kg · °C). Calculate the room’s temperature at the end of the lecture in oF (the answer may sound high (!), but in reality, a significant portion of the heat produced would be absorbed by the walls, ceiling, floors, chairs, desks, and so on, which we are neglecting).
A typical weather balloon is made of a thin latex envelope that takes very little force to stretch, so the pressure inside the balloon is approximately equal to atmospheric pressure. Suppose a weather balloon filled with 180 mol of helium is waiting for launch on a cold morning at a high-altitude station. The balloon warms in the sun, which raises the temperature of the gas from0°C to 30°C. As the balloon expands, how much work is done by the expanding gas?
During a chemistry lab, you take a 0.4 kg sample of ice and put it in a beaker with a thermometer. You then place the beaker with the ice on
0 the temperature of the ice is -18
=
a hot plate, and turn on the hot plate. This hot plate adds heat to the ice at a rate of 330 W. At time t
°C.
Because of the large heat capacity of water and ice, you may assume in this problem that all the heat goes into the sample of ice, and that
we can ignore the amount of heat going into the beaker and thermometer. Also assume no heat escapes from the system.
Some useful values:
●
Specific heat of water: C =
Specific heat of ice: Ci
= 2100 J/kg K
• Latent heat of fusion: L = 334 000 J/kg
●
4200 J/kg K
=
1a) At what time does the ice reach a temperature of -3.5°C?
answer=
units?
1b) At what time has all the ice melted?
answer=
units?
Check your answer
Check your answer
1c) After the ice has completely melted, we're left with 0.4 kg of water.
Check your answer
answer=
units?
not yet solved
not yet solved…
Chapter 19 Solutions
Physics for Scientists and Engineers
Ch. 19.2 - Prob. 19.1QQCh. 19.3 - Suppose the same process of adding energy to the...Ch. 19.5 - Prob. 19.3QQCh. 19.5 - Characterize the paths in Figure 19.12 as...Ch. 19.6 - Prob. 19.5QQCh. 19 - Prob. 1PCh. 19 - The highest waterfall in the world is the Salto...Ch. 19 - Prob. 3PCh. 19 - The temperature of a silver bar rises by 10.0C...Ch. 19 - You are working in your kitchen preparing lunch...
Ch. 19 - If water with a mass mk at temperature Tk is...Ch. 19 - An aluminum calorimeter with a mass of 100 g...Ch. 19 - An electric drill with a steel drill bit of mass m...Ch. 19 - A 3.00-g copper coin at 25.0C drops 50.0 m to the...Ch. 19 - How much energy is required to change a 40.0-g ice...Ch. 19 - Prob. 11PCh. 19 - A 3.00-g lead bullet at 30.0C is fired at a speed...Ch. 19 - In an insulated vessel, 250 g of ice at 0C is...Ch. 19 - Prob. 14PCh. 19 - One mole of an ideal gas is warmed slowly so that...Ch. 19 - (a) Determine the work done on a gas that expands...Ch. 19 - A thermodynamic system undergoes a process in...Ch. 19 - Why is the following situation impossible? An...Ch. 19 - A 2.00-mol sample of helium gas initially at 300...Ch. 19 - (a) How much work is done on the steam when 1.00...Ch. 19 - A 1.00-kg block of aluminum is warmed at...Ch. 19 - In Figure P19.22, the change in internal energy of...Ch. 19 - A student is trying to decide what to wear. His...Ch. 19 - A concrete slab is 12.0 cm thick and has an area...Ch. 19 - Two lightbulbs have cylindrical filaments much...Ch. 19 - Prob. 26PCh. 19 - (a) Calculate the R-value of a thermal window made...Ch. 19 - Prob. 28PCh. 19 - Gas in a container is at a pressure of 1.50 atm...Ch. 19 - Prob. 30APCh. 19 - You have a particular interest in automobile...Ch. 19 - You are working in a condensed-matter laboratory...Ch. 19 - Prob. 33APCh. 19 - Prob. 34APCh. 19 - Prob. 35APCh. 19 - Prob. 36APCh. 19 - An ice-cube tray is filled with 75.0 g of water....Ch. 19 - Prob. 38APCh. 19 - An iron plate is held against an iron wheel so...Ch. 19 - One mole of an ideal gas is contained in a...Ch. 19 - Prob. 41APCh. 19 - Prob. 42APCh. 19 - Prob. 43APCh. 19 - A student measures the following data in a...Ch. 19 - (a) The inside of a hollow cylinder is maintained...Ch. 19 - A spherical shell has inner radius 3.00 cm and...Ch. 19 - Prob. 47CP
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.Similar questions
- (a) How much heat must be added to raise the temperature of 1.5 mol of air 25.0 to 33.0 at constant volume? Assume air is completely diatomic. (b) Repeat the problem for the same number of moles of xenon, Xe.arrow_forwardIn Figure P19.22, the change in internal energy of a gas that is taken from A to C along the blue path is +800 J. The work done on the gas along the red path ABC is 500 J. (a) How much energy must be added to the system by heat as it goes from A through B to C? (b) If the pressure at point A is five times that of point C, what is the work done on the system in going from C to D? Figure P19.22 (c) What is the energy exchanged with the surroundings by heat as the gas goes from C to A along the green path? (d) If the change in internal energy in going from point D to point A is +500 J, how much energy must be added to the system by heat as it goes from point C to point D?arrow_forwardFrom Table 21.1, the specific heat of milk is 3.93 103 J/ (kg K). and the specific heat of water is 4.19 103 J/(kg K). Suppose you wish to make a large mug (0.500 L) of hot chocolate. Each liquid is initially at 5.00C. and you need to raise their temperature to 80.0C. The density of milk is about 1.03 103 kg/m3, and the density of water is 1.00 103 kg/m3. a. How much heat must be transferred in each case? b. If you use a small electric hot plate that puts out 455 W, how long would it take to heat each liquid?arrow_forward
- (a) Calculate the rate of heat transfer by radiation from a car radiator at 110C into a 50.0C environment, if the radiator has an emissivity of 0.750 and a 1.20m2 surface area. (b) Is this a significant fraction of the heat transfer by an automobile engine? To answer this, assume a horsepower of 200 hp (1.5 kW) and the efficiency of automobile engines as 25%.arrow_forwardA gas expands from I to Fin Figure P20.58 (page 622). The energy added to the gas by heat is 418 J when the gas goes from I to F along the diagonal path, (a) What is the change in internal energy of the gas? (b) How much energy must be added to the gas by heat along the indirect path IAF?arrow_forward(a) The inside of a hollow cylinder is maintained at a temperature Ta, and the outside is at a lower temperature, Tb (Fig. P19.45). The wall of the cylinder has a thermal conductivity k. Ignoring end effects, show that the rate of energy conduction from the inner surface to the outer surface in the radial direction is dQdt=2Lk[TaTbln(b/a)] Suggestions: The temperature gradient is dT/dr. A radial energy current passes through a concentric cylinder of area 2rL. (b) The passenger section of a jet airliner is in the shape of a cylindrical tube with a length of 35.0 m and an inner radius of 2.50 m. Its walls are lined with an insulating material 6.00 cm in thickness and having a thermal conductivity of 4.00 105 cal/s cm C. A heater must maintain the interior temperature at 25.0C while the outside temperature is 35.0C. What power must be supplied to the heater? Figure P19.45arrow_forward
- A lake is covered with ice that is 2.0 cm thick. The temperature of the ambient air is 20C. Find the rate of thickening of ice. Assume the thermal conductivity of ice is 200.0 W/(m K), the density of ice is 9.0 102 kg/m3, and the latent heat of fusion is 3.33 105 J/kg.arrow_forward(a) Determine the work done on a gas that expands from i to f as indicated in Figure P19.16. (b) What If? How much work is done on the gas if it is compressed from f to i along the same path? Figure P19.16arrow_forward(a) It is difficult to extinguish a fire on a crude oil tanker, because each liter of crude oil releases 2.80107 J of energy when burned. To illustrate this difficulty, calculate the number of liters of water that must be expended to absorb the energy released by burning 1.00 L of crude oil, if the water's temperature rises from 20.0 C to 100 C, it boils, and the resulting steam's temperature rises to 300 C at constant pressure. (b) Discuss additional complications caused by the fact that crude oil is less dense than water.arrow_forward
- A cylinder is closed at both ends and has insulating EZZ3 walls. It is divided into two compartments by an insulating piston that is perpendicular to the axis of the cylinder as shown in Figure P21.75a. Each compartment contains 1.00 mol of oxygen that behaves as an ideal gas with = 1.40. Initially, the two compartments haw equal volumes and their temperatures are 550 K and 250 K. The piston is then allowed to move slowly parallel to the axis of the cylinder until it comes to rest at an equilibrium position (Fig. P2l.75b). Find the final temperatures in the two compartments.arrow_forwardIn Figure P17.32, the change in internal energy of a gas that is taken from A to C along the blue path is +800 J. The work done on the gas along the red path ABC is 500 J. (a) How much energy must be added to the system by heat as it goes from A through B to C? (b) If the pressure at point A is five times that of point C, what is the work done on the system in going from C to D? (c) What is the energy exchanged with the surroundings by heat as the gas goes from C to A along the green path? (d) If the change in internal energy in going from point D to point A is +500 J, how much energy must be added to the system by heat as it goes from point C to point D? Figure P17.32arrow_forwardIn cold climates, including the northern United States, a house can be built with very large windows facing south to take advantage of solar heating. Sunlight shining in during the daytime is absorbed by the floor, interior walls, and objects in the room, raising their temperature to 38.0C. If the house is well insulated, you may model it as losing energy by heat steadily at the rate 6 000 W on a day in April when the average exterior temperature is 4C and when the conventional heating system is not used at all. During the period between 5:00 p.m. and 7:00 a.m., the temperature of the house drops and a sufficiently large "thermal mass" is required to keep it from dropping too far. The thermal mass can be a large quantity of stone (with specific heat 850 J/kg C) in the floor and the interior walls exposed to sunlight. What mass of stone is required if the temperature is not to drop below 18.0C overnight?arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
Principles of Physics: A Calculus-Based TextPhysicsISBN:9781133104261Author:Raymond A. Serway, John W. JewettPublisher:Cengage Learning
Physics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage Learning
Physics for Scientists and Engineers, Technology ...PhysicsISBN:9781305116399Author:Raymond A. Serway, John W. JewettPublisher:Cengage Learning
College PhysicsPhysicsISBN:9781938168000Author:Paul Peter Urone, Roger HinrichsPublisher:OpenStax College
Physics for Scientists and Engineers with Modern ...PhysicsISBN:9781337553292Author:Raymond A. Serway, John W. JewettPublisher:Cengage Learning
Principles of Physics: A Calculus-Based Text
Physics
ISBN:9781133104261
Author:Raymond A. Serway, John W. Jewett
Publisher:Cengage Learning
Physics for Scientists and Engineers: Foundations...
Physics
ISBN:9781133939146
Author:Katz, Debora M.
Publisher:Cengage Learning
Physics for Scientists and Engineers, Technology ...
Physics
ISBN:9781305116399
Author:Raymond A. Serway, John W. Jewett
Publisher:Cengage Learning
College Physics
Physics
ISBN:9781938168000
Author:Paul Peter Urone, Roger Hinrichs
Publisher:OpenStax College
Physics for Scientists and Engineers with Modern ...
Physics
ISBN:9781337553292
Author:Raymond A. Serway, John W. Jewett
Publisher:Cengage Learning