Astronomy
1st Edition
ISBN: 9781938168284
Author: Andrew Fraknoi; David Morrison; Sidney C. Wolff
Publisher: OpenStax
expand_more
expand_more
format_list_bulleted
Concept explainers
Textbook Question
Chapter 18, Problem 22E
Suppose you want to search for brown dwarfs using a space telescope. Will you design your telescope to detect light in the ultraviolet or the infrared part of the spectrum? Why?
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solution
Students have asked these similar questions
Which of the following is part of the interior of the Sun?
photosphere
the corona
sunspots
radiation zone
Most craters on the surface of the Moon are believed to be caused by which of the following?
faults
asteroids
volcanoes
meteoroids
An object is subjected to a friction force with magnitude 5.49 N, which acts against the object's velocity. What is the work (in J) needed to move the object at constant speed for the following routes?
y (m)
C
B
(5.00, 5.00)
A
x (m)
©
(a) the purple path O to A followed by a return purple path to O
]
(b) the purple path O to C followed by a return blue path to O
]
(c) the blue path O to C followed by a return blue path to O
]
(d) Each of your three answers should be nonzero. What is the significance of this observation?
○ The force of friction is a conservative force.
○ The force of friction is a nonconservative force.
Chapter 18 Solutions
Astronomy
Ch. 18 - How does the mass of the Sun compare with that of...Ch. 18 - Name and describe the three types of binary...Ch. 18 - Describe two ways of determining the diameter of a...Ch. 18 - What are the largest- and smallest-known values of...Ch. 18 - You are able to take spectra of both stars in an...Ch. 18 - Sketch an HR diagram. Label the axes. Show where...Ch. 18 - Describe what a typical star in the Galaxy would...Ch. 18 - How do we distinguish stars from brown dwarfs? How...Ch. 18 - Describe how the mass, luminosity, surface...Ch. 18 - One method to measure the diameter of a star is to...
Ch. 18 - We discussed in the chapter that about half of...Ch. 18 - Is the Sun an average star? Why or why not?Ch. 18 - Suppose you want to determine the average...Ch. 18 - Why do most known visual binaries have relatively...Ch. 18 - Figure 18.11 shows the light curve of a...Ch. 18 - There are fewer eclipsing binaries than...Ch. 18 - Within 50 light-years of the Sun, visual binaries...Ch. 18 - Which is easier to observe at large distances-a...Ch. 18 - The eclipsing binary Algol drops from maximum to...Ch. 18 - Review this spectral data for five stars. Which is...Ch. 18 - Which changes by the largest factor along the main...Ch. 18 - Suppose you want to search for brown dwarfs using...Ch. 18 - An astronomer discovers a type-M star with a large...Ch. 18 - Approximately 6000 stars are bright enough to be...Ch. 18 - Use the data in Appendix J to plot an HR diagram...Ch. 18 - Use the diagram you have drawn for Exercise 18.25...Ch. 18 - Use the data in Appendix I to plot an HR diagram...Ch. 18 - If a visual binary system were to have two...Ch. 18 - Two stars are in a visual binary star system that...Ch. 18 - Describe the spectra for a spectroscopic binary...Ch. 18 - Figure 18.7 shows the velocity of two stars in a...Ch. 18 - You go out stargazing one night, and someone asks...Ch. 18 - If you were to compare three stars with the same...Ch. 18 - Are supergiant stars also extremely massive?...Ch. 18 - Consider the following data on four stars: Which...Ch. 18 - If two stars are in a binary system with a...Ch. 18 - It is possible that stars as much as 200 times the...Ch. 18 - The lowest mass for a true star is 1/12 the mass...Ch. 18 - Spectral types are an indicator of temperature....Ch. 18 - We can estimate the masses of most of the stars in...Ch. 18 - In Diameters of Stars, the relative diameters of...Ch. 18 - Now calculate the radius of Sirius’ white dwarf...Ch. 18 - How does this radius of Sirius B compare with that...Ch. 18 - From the previous calculations and the results...Ch. 18 - How much would you weigh if you were suddenly...Ch. 18 - The star Betelgeuse has a temperature of 3400 K...Ch. 18 - Using the information provided in Table 18.1, what...Ch. 18 - Confirm that the angular diameter of the Sun of...Ch. 18 - An eclipsing binary star system is observed with...Ch. 18 - If a 100 solar mass star were to have a luminosity...Ch. 18 - If Betelgeuse had a mass that was 25 times that of...
Additional Science Textbook Solutions
Find more solutions based on key concepts
Endospore formation is called (a) _____. It is initiated by (b) _____. Formation of a new cell from an endospor...
Microbiology: An Introduction
Choose the best answer to each of the following. Explain your reasoning. A geocentric model of the universe is ...
Cosmic Perspective Fundamentals
10.71 Identify each of the following as an acid or a base: (10.1)
H2SO4
RbOH
Ca(OH)2
HI
...
Chemistry: An Introduction to General, Organic, and Biological Chemistry (13th Edition)
Answer the following questions for each compound: a. How many signals are in its 13C NMR spectrum? b. Which sig...
Organic Chemistry (8th Edition)
Which one of the following is not a fuel produced by microorganisms? a. algal oil b. ethanol c. hydrogen d. met...
Microbiology: An Introduction
Fill in the blanks: The nose is to the mouth. The ankle is to the knee. The ring finger is to the inde...
Human Anatomy & Physiology (2nd Edition)
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.Similar questions
- A block of mass m = 2.50 kg is pushed d = 2.30 m along a frictionless horizontal table by a constant applied force of magnitude F = 10.0 N directed at an angle 25.0° below the horizontal as shown in the figure below. m (a) Determine the work done by the applied force. ] (b) Determine the work done by the normal force exerted by the table. ] (c) Determine the work done by the force of gravity. ] (d) Determine the work done by the net force on the block. ]arrow_forwardA man pushing a crate of mass m = 92.0 kg at a speed of v = 0.845 m/s encounters a rough horizontal surface of length = 0.65 m as in the figure below. If the coefficient of kinetic friction between the crate and rough surface is 0.357 and he exerts a constant horizontal force of 294 N on the crate. e (a) Find the magnitude and direction of the net force on the crate while it is on the rough surface. magnitude direction ---Select--- N (b) Find the net work done on the crate while it is on the rough surface. ] (c) Find the speed of the crate when it reaches the end of the rough surface. m/sarrow_forwardTwo blocks, A and B (with mass 45 kg and 120 kg, respectively), are connected by a string, as shown in the figure below. The pulley is frictionless and of negligible mass. The coefficient of kinetic friction between block A and the incline is μk = 0.26. Determine the change in the kinetic energy of block A as it moves from to, a distance of 15 m up the incline (and block B drops downward a distance of 15 m) if the system starts from rest. × J 37° Barrow_forward
- You are working for the Highway Department. In mountainous regions, highways sometimes include a runaway truck ramp, and you are asked to help with the design of such a ramp. A runaway truck ramp is often a lane of gravel adjacent to a long downhill section of roadway where trucks with failing brakes may need assistance to stop. Working with your supervisor, you develop a worst-case scenario: a truck with a mass of 6.00 × 104 kg enters a runaway truck lane traveling at 34.1 m/s. Assume that the maximum constant value for safe acceleration of the truck is -5.00 m/s². Any higher magnitude of acceleration increases the likelihood that semi-trailer rigs could jackknife. Your supervisor asks you to advise her on the required length (in m) of a runaway truck lane on a flat section of ground next to the roadway. marrow_forwardA large cruise ship of mass 6.20 × 107 kg has a speed of 10.2 m/s at some instant. (a) What is the ship's kinetic energy at this time? ] (b) How much work is required to stop it? (Give the work done on the ship. Include the sign of the value in your answer.) ] (c) What is the magnitude of the constant force required to stop it as it undergoes a displacement of 3.10 km? Narrow_forwardA 7.80 g bullet is initially moving at 660 m/s just before it penetrates a block of wood to a depth of 6.20 cm. (a) What is the magnitude of the average frictional force (in N) that is exerted on the bullet while it is moving through the block of wood? Use work and energy considerations to obtain your answer. N (b) Assuming the frictional force is constant, how much time (in s) elapses between the moment the bullet enters the block of wood and the moment it stops moving? Sarrow_forward
- Please don't use Chatgpt will upvote and give handwritten solutionarrow_forwardTwo blocks, A and B (with mass 45 kg and 120 kg, respectively), are connected by a string, as shown in the figure below. The pulley is frictionless and of negligible mass. The coefficient of kinetic friction between block A and the incline is μk = 0.26. Determine the change in the kinetic energy of block A as it moves from to ①, a distance of 15 m up the incline (and block B drops downward a distance of 15 m) if the system starts from rest. ] 37° A © Barrow_forwardA skateboarder with his board can be modeled as a particle of mass 80.0 kg, located at his center of mass. As shown in the figure below, the skateboarder starts from rest in a crouching position at one lip of a half-pipe (point). On his descent, the skateboarder moves without friction so that his center of mass moves through one quarter of a circle of radius 6.20 m. i (a) Find his speed at the bottom of the half-pipe (point Ⓡ). m/s (b) Immediately after passing point Ⓑ, he stands up and raises his arms, lifting his center of mass and essentially "pumping" energy into the system. Next, the skateboarder glides upward with his center of mass moving in a quarter circle of radius 5.71 m, reaching point D. As he passes through point ①, the speed of the skateboarder is 5.37 m/s. How much chemical potential energy in the body of the skateboarder was converted to mechanical energy when he stood up at point Ⓑ? ] (c) How high above point ① does he rise? marrow_forward
- A 31.0-kg child on a 3.00-m-long swing is released from rest when the ropes of the swing make an angle of 29.0° with the vertical. (a) Neglecting friction, find the child's speed at the lowest position. m/s (b) If the actual speed of the child at the lowest position is 2.40 m/s, what is the mechanical energy lost due to friction? ]arrow_forwardA force acting on a particle moving in the xy plane is given by F = (2yî + x²), where F is in newtons and x and y are in meters. The particle moves from the origin to a final position having coordinates x = 5.60 m and y = 5.60 m, as shown in the figure below. y (m) B (x, y) x (m) (a) Calculate the work done by F on the particle as it moves along the purple path (0 Ⓐ©). ] (b) Calculate the work done by ♬ on the particle as it moves along the red path (0 BC). J (c) Is F conservative or nonconservative? ○ conservative nonconservativearrow_forwardA 3.5-kg block is pushed 2.9 m up a vertical wall with constant speed by a constant force of magnitude F applied at an angle of 0 = 30° with the horizontal, as shown in the figure below. If the coefficient of kinetic friction between block and wall is 0.30, determine the following. (a) the work done by F J (b) the work done by the force of gravity ] (c) the work done by the normal force between block and wall J (d) By how much does the gravitational potential energy increase during the block's motion? ]arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
AstronomyPhysicsISBN:9781938168284Author:Andrew Fraknoi; David Morrison; Sidney C. WolffPublisher:OpenStax
Stars and Galaxies (MindTap Course List)PhysicsISBN:9781337399944Author:Michael A. SeedsPublisher:Cengage Learning
Foundations of Astronomy (MindTap Course List)PhysicsISBN:9781337399920Author:Michael A. Seeds, Dana BackmanPublisher:Cengage Learning
Horizons: Exploring the Universe (MindTap Course ...PhysicsISBN:9781305960961Author:Michael A. Seeds, Dana BackmanPublisher:Cengage Learning
Astronomy
Physics
ISBN:9781938168284
Author:Andrew Fraknoi; David Morrison; Sidney C. Wolff
Publisher:OpenStax
Stars and Galaxies (MindTap Course List)
Physics
ISBN:9781337399944
Author:Michael A. Seeds
Publisher:Cengage Learning
Foundations of Astronomy (MindTap Course List)
Physics
ISBN:9781337399920
Author:Michael A. Seeds, Dana Backman
Publisher:Cengage Learning
Horizons: Exploring the Universe (MindTap Course ...
Physics
ISBN:9781305960961
Author:Michael A. Seeds, Dana Backman
Publisher:Cengage Learning