Two cubic containers are given to contain the same quantity of gas at the same temperature. The cube containing gas at higher entropy is to be identified. The sample with higher entropy if, the sample in the part (b) is left unchanged, but the sample in part (a) is cooled so that it condenses, is to be identified. Concept introduction: Entropy is a thermodynamic property which shows the randomness or disorder of the atoms within the system. In the spontaneous process, the entropy of the system increases when one phase changes to another phase in an isolated system according to the second law of thermodynamic. The entropy is maximum in the gas phase and minimum in the solid phase. To determine: The cube containing gas at higher entropy, when the two cubic containers contain the same quantity of gas at the same temperature and the sample with higher entropy if, the sample in the part (b) is left unchanged but the sample in part (a) is cooled so that it condenses.

Question

Want to see the full answer?

Answer 1

Question

Chapter 18, Problem 18.2VP

Interpretation Introduction

Interpretation: Two cubic containers are given to contain the same quantity of gas at the same temperature. The cube containing gas at higher entropy is to be identified. The sample with higher entropy if, the sample in the part (b) is left unchanged, but the sample in part (a) is cooled so that it condenses, is to be identified.

Concept introduction: Entropy is a thermodynamic property which shows the randomness or disorder of the atoms within the system.

In the spontaneous process, the entropy of the system increases when one phase changes to another phase in an isolated system according to the second law of thermodynamic.

The entropy is maximum in the gas phase and minimum in the solid phase.

To determine: The cube containing gas at higher entropy, when the two cubic containers contain the same quantity of gas at the same temperature and the sample with higher entropy if, the sample in the part (b) is left unchanged but the sample in part (a) is cooled so that it condenses.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

6. Choose the compound that will produce the spectrum below and assign the signals as carbonyl, aryl, or alkyl. 100 ō (ppm) 50 0 7. 200 150 Assign all of the protons on the spectrum below. 8. A B 4 E C 3 ō (ppm) 2 1 0 Choose the compound that will produce the spectrum below and assign the signals to the corresponding protons. OH 6 OH 3 2 1 0 4 ō (ppm)

In the Thermo Fisher application note about wine analysis (Lesson 3), the following chromatogram was collected of nine components of wine. If peak 3 has a retention time of 3.15 minutes and a peak width of 0.070 minutes, and peak 4 has a retention time of 3.24 minutes and a peak width of 0.075 minutes, what is the resolution factor between the two peaks? [Hint: it will help to review Lesson 2 for this question.] MAU 300 200 T 34 5 100- 1 2 CO 6 7 8 9 0 2.4 2.6 2.8 3.0 3.2 3.4 3.6 3.8 4.0 4.2 4.4 4.6 4.8 5.0 5.2 Minutes 3.22 0.62 1.04 O 1.24

The diagram shows two metals, A and B, which melt at 1000°C and 1400°C. State the weight percentage of the primary constituent (grains of C) that would be obtained by solidifying a 20% alloy of B. 1000°C a+L L+C 900°С 12 α a+C 45 1200 C L+y 140096 C+Y a+ß 800°C 700°C C+B 96 92 a+B 0 10 20 30 40 50 60 70 80 90 100 A % peso B B