By using the given NMR spectrum, the structure of the product and mechanism of the reaction are to be determined. Concept introduction: For the analysis of the molecular formula of organic molecules, the sites of unsaturation, also known as IHD, are used for the determination of total number of ring and π bonds in the structure. Alkene hydrogen indicates the chemical shift at 2 .1 - 2 .2 δ , and CH 3 groups, which are slightly deshielded, indicate the chemical shift at 5 .8 - 5 .9 δ respectively. In case of proton transfer reaction, proton is abstracted by the electronegative atom like oxygen. In nucleophilic addition reaction, the nucleophile will attack the most electropositive carbon which results in the formation of a new bond. Heterolysis is the removal of water. In E1 elimination reaction, deprotonation of a hydrogen nearby the carbocation results in the formation of an alkene.

Question

Want to see the full answer?

Answer 1

Question

Chapter 18, Problem 18.100P

Interpretation Introduction

Interpretation:

By using the given NMR spectrum, the structure of the product and mechanism of the reaction are to be determined.

Concept introduction:

For the analysis of the molecular formula of organic molecules, the sites of unsaturation, also known as IHD, are used for the determination of total number of ring and π bonds in the structure.

Alkene hydrogen indicates the chemical shift at 2.1 - 2.2 δ, and CH3 groups, which are slightly deshielded, indicate the chemical shift at 5.8 - 5.9 δ respectively.

In case of proton transfer reaction, proton is abstracted by the electronegative atom like oxygen.

In nucleophilic addition reaction, the nucleophile will attack the most electropositive carbon which results in the formation of a new bond.

Heterolysis is the removal of water.

In E1 elimination reaction, deprotonation of a hydrogen nearby the carbocation results in the formation of an alkene.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

Calculate the cell potential for the following reaction that takes place in an electrochemical cell at 25°C. Mg(s) ∣ Mg2+(aq, 2.74 M) || Cu2+(aq, 0.0033 M) ∣ Cu(s)

Calculate E° for Ni(glycine)2 + 2e– D Ni + 2 glycine– given Ni2+ + 2 glycine– D Ni(glycine)2 K = 1.2×1011 Ni2+ + 2 e– D Ni E° = -0.236 V

One method for the analysis of Fe3+, which is used with a variety of sample matrices, is to form the highly colored Fe3+–thioglycolic acid complex. The complex absorbs strongly at 535 nm. Standardizing the method is accomplished using external standards. A 10.00-ppm Fe3+ working standard is prepared by transferring a 10-mL aliquot of a 100.0 ppm stock solution of Fe3+ to a 100-mL volumetric flask and diluting to volume. Calibration standards of 1.00, 2.00, 3.00, 4.00, and 5.00 ppm are prepared by transferring appropriate amounts of the 10.0 ppm working solution into separate 50-mL volumetric flasks, each of which contains 5 mL of thioglycolic acid, 2 mL of 20% w/v ammonium citrate, and 5 mL of 0.22 M NH3. After diluting to volume and mixing, the absorbances of the external standards are measured against an appropriate blank. Samples are prepared for analysis by taking a portion known to contain approximately 0.1 g of Fe3+, dissolving it in a minimum amount of HNO3, and diluting to…