Automotive Technology: A Systems Approach (MindTap Course List)
6th Edition
ISBN: 9781133612315
Author: Jack Erjavec, Rob Thompson
Publisher: Cengage Learning
expand_more
expand_more
format_list_bulleted
Concept explainers
Textbook Question
Chapter 17, Problem 10ASRQ
While discussing the results of a load test: Technician A says that if a battery fails a load test but the voltage rises above 12.4 volts when the load is removed, the battery should be replaced. Technician B says that if a battery fails a load test but the voltage rises above 12.4 volts when the load is removed, the battery is able to hold a charge. Who is correct?
- Technician A
Expert Solution & Answer
Trending nowThis is a popular solution!
Students have asked these similar questions
Which of the following statements about battery rating is true?
a.The ampere-hour rating is defined as the amount of steady current that
a fully charged battery' can supply for 1 hour at 80o F (26.7o C) without
the cell voltage falling below a predetermined voltage.
b.The cold cranking amps rating represents the number of amps that a fully charged battery can deliver at 0o F(-17.7o C) for 30 seconds
while maintaining a voltage above 9.6 volts for a 12 volt battery.
c.The craking amp rating expresses that number of amperes a battery'
can deliver at 32o F (0o C) for 30 seconds and maintain at least 1.2 volts
percell.
d.The reserve capacity ratng expresses the number of amperes a fully charged battery at 80o F can supply before the battery's voltage
falls below 10.5 volts.
True or False? A fully charged new battery willhave a low conductance reading.
true or False? The computer in most late-model vehicles must undergo a relearn or initialization procedure after the vehicle's battery has been disconnected and reconnected?
Chapter 17 Solutions
Automotive Technology: A Systems Approach (MindTap Course List)
Ch. 17 - Define an electrolyte and its role in battery...Ch. 17 - Prob. 2RQCh. 17 - How is a battery leakage test conducted?Ch. 17 - Describe parasitic draw.Ch. 17 - How can you identify the high-voltage system in...Ch. 17 - How many volts are present in a fully charged...Ch. 17 - What is meant by the term specific gravity?Ch. 17 - What causes gassing in a battery?Ch. 17 - List five things that shorten the life of a...Ch. 17 - True or False? All electrochemical batteries have...
Ch. 17 - Prob. 11RQCh. 17 - True or False? A batteny is an electromechanical...Ch. 17 - True or False? The BCI determines battery ratings...Ch. 17 - Which of the following statements about battery...Ch. 17 - Which of the following statements about battery...Ch. 17 - Prob. 1ASRQCh. 17 - Technician A says that the reserve rating of a...Ch. 17 - Technician A says that battery straps should be...Ch. 17 - Technician A says jump-starting a battery can...Ch. 17 - Prob. 5ASRQCh. 17 - Technician A says that before a battery is...Ch. 17 - Technician A says that side post terminals need to...Ch. 17 - A vehicles battery goes dead after sitting for two...Ch. 17 - Technician A always wears safety glasses or...Ch. 17 - While discussing the results of a load test:...
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.Similar questions
- Technician A says that battery straps should be used whenever a battery is lifted Technician B says that when a battery is removed, the positive cable should be disconnected first. Who is correct? Technician A Technician B Both A and B Neither A nor Barrow_forwardTechnician A says that the reserve rating of a battery is the amount of steady current that a fully charged battery can supply tor 20 hours without the voltage falling below 10.5 volts. Technician B says that ampere-hour ratings state how many hours the battery is capable of supplying 25 amperes. Who is correct? Technician A Technician B Both A and B Neither A nor Barrow_forwardTechnician A says that before a battery is removed, a memory' saver ought to be installed. Technician B says that before a battery is removed, the positive cable should be disconnected and the area around the battery should be cleaned. Who is correct? Technician A Technician B Both A and B Neither A nor Barrow_forward
- Technician A says jump-starting a battery can damage electronic components. Technician B says a dead battery should be jump-started instead of recharged. Who is correct? Technician A Technician B Both A and B Neither A nor Barrow_forwardHow is a battery leakage test conducted?arrow_forwardA vehicles battery goes dead after sitting for two days. Technician A says a thorough battey inspection should be performed. Technician B says a check for a parasitic draw should be performed. Who is correct? Technician A Technician B Both A and B Neither A nor Barrow_forward
- While measuring the resistance of a wire with an ohmmeter: Technician A says that if low resistance is shown on the meter, the wire is shorted. Technician B says that if no resistance is measured, the wire is shorted. Who is correct? Technician A Technician B Both A and B d. Neither A nor Barrow_forwardTrue or False? A lab scope is a visual voltmeter that shows voltage over a period of time.arrow_forwardWhich of the following tests would not be performed to check for high resistance in the battery' cables? Cranking voltage test Insulated circuit resistance test Starter relay by-pass test Ground circuit resistance testarrow_forward
- Extraterrestrial Incorrect Question 2 0/1 Which of the following is an example of mechanical technology? The legs of a chair A generator A mobile phone A lawnmowerarrow_forwardTrue or False 1. It is acceptable to use a hoist to lift something that weighs more than the rating on the hoist when the load is lifted carefully. 2. Typically, combustible material accidents occur at higher temperatures while flammable material accidents occur at room temperature. 3. Water reactive chemicals include calcium carbide, cyclooctene, metal hydrides, and metals like sodium and potassium. 4. When driving material lifting equipment, workers should maintain at least a 5-foot clearance from overhead power lines. 5. Workers should use at least 2 straps placed equally from the center when lifting a long I-beam. ******************************************************************************************** Multiple Choice 1. Which of the following chemicals is not considered a liver toxin? A. Glacial acetic acid B. Carbon Tetrachloride C. Ethanol D. Trichloroethylene 2. Which of the following is a safety practice intended to protect workers from a lightning strike? A. Use a metal…arrow_forwardTechnician A always wears safety glasses or goggles when working with batteries. Technician B says that there is no need to seek medical help if electrolyte gets in your eyes as long as you flush your eyes immediately after the electrolyte hits them. Who is correct? Technician A Technician B Both A and B Neither A nor Barrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
- Automotive Technology: A Systems Approach (MindTa...Mechanical EngineeringISBN:9781133612315Author:Jack Erjavec, Rob ThompsonPublisher:Cengage LearningAutomotive TechnologyMechanical EngineeringISBN:9781337794213Author:ERJAVEC, Jack.Publisher:Cengage,Refrigeration and Air Conditioning Technology (Mi...Mechanical EngineeringISBN:9781305578296Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill JohnsonPublisher:Cengage Learning
Automotive Technology: A Systems Approach (MindTa...
Mechanical Engineering
ISBN:9781133612315
Author:Jack Erjavec, Rob Thompson
Publisher:Cengage Learning
Automotive Technology
Mechanical Engineering
ISBN:9781337794213
Author:ERJAVEC, Jack.
Publisher:Cengage,
Refrigeration and Air Conditioning Technology (Mi...
Mechanical Engineering
ISBN:9781305578296
Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson
Publisher:Cengage Learning
General Industrial Safety; Author: Jim Pytel;https://www.youtube.com/watch?v=RXtF_vQRebM;License: Standard youtube license