Suppose the maximum safe intensity of microwaves for human exposure is taken to be 1,00 W/m 2 . (a) If a radar unit leaks 10.0 W of microwaves (other than those sent by its antenna) uniformly in all directions, how far away must you be to be exposed to an intensity considered to be safe? Assume that the power spreads uniformly over the area of a sphere with no complications from absorption or reflection, (b) What is the maximum electric field strength at the safe intensity? (Note that early radar units leaked more than modem ones do. This caused identifiable health problems, such as cataracts, for people who worked near them.)
Suppose the maximum safe intensity of microwaves for human exposure is taken to be 1,00 W/m 2 . (a) If a radar unit leaks 10.0 W of microwaves (other than those sent by its antenna) uniformly in all directions, how far away must you be to be exposed to an intensity considered to be safe? Assume that the power spreads uniformly over the area of a sphere with no complications from absorption or reflection, (b) What is the maximum electric field strength at the safe intensity? (Note that early radar units leaked more than modem ones do. This caused identifiable health problems, such as cataracts, for people who worked near them.)
Suppose the maximum safe intensity of microwaves for human exposure is taken to be 1,00 W/m2. (a) If a radar unit leaks 10.0 W of microwaves (other than those sent by its antenna) uniformly in all directions, how far away must you be to be exposed to an intensity considered to be safe? Assume that the power spreads uniformly over the area of a sphere with no complications from absorption or reflection, (b) What is the maximum electric field strength at the safe intensity? (Note that early radar units leaked more than modem ones do. This caused identifiable health problems, such as cataracts, for people who worked near them.)
Consider the circuit shown in the figure below. (Let R = 12.0 (2.)
25.0 V
10.0
www
10.0 Ω
b
www
5.00 Ω
w
R
5.00 Ω
i
(a) Find the current in the 12.0-0 resistor.
1.95
×
This is the total current through the battery. Does all of this go through R? A
(b) Find the potential difference between points a and b.
1.72
×
How does the potential difference between points a and b relate to the current through resistor R? V
3.90 ... CP A rocket designed to place small payloads into orbit
is carried to an altitude of 12.0 km above sea level by a converted
airliner. When the airliner is flying in a straight line at a constant
speed of 850 km/h, the rocket is dropped. After the drop, the air-
liner maintains the same altitude and speed and continues to fly in
a straight line. The rocket falls for a brief time, after which its
rocket motor turns on. Once its rocket motor is on, the combined
effects of thrust and gravity give the rocket a constant acceleration
of magnitude 3.00g directed at an angle of 30.0° above the hori-
zontal. For reasons of safety, the rocket should be at least 1.00 km
in front of the airliner when it climbs through the airliner's alti-
tude. Your job is to determine the minimum time that the rocket
must fall before its engine starts. You can ignore air resistance.
Your answer should include (i) a diagram showing the flight paths
of both the rocket and the airliner, labeled at several…
1. In an industrial fabrication process, a fluid, with density p = 800 kg/m and specific heat capacity
c = 5000 J/kg-C°, emerges from a tank at a temperature, T, = 400 °C. The fluid then enters a metal pipe with inner radius a = 2.0 cm and outer radius b = 3.0 cm and thermal conductivity k = 180 W/m•C°.
Outside the pipe the temperature is fixed at Tout = 15 °C.
If the fluid flows at speed v = 8.0 m/s and the length of the pipe is L = 25 m, what is the temperature
of the fluid at the end of the pipe? (Answer: 83 °C)
please I need to show All work problems step by step