The explanation corresponding to the given statement that 80 % of D − idose exists in the anhydrous form in an aqueous solution at 100 °C , but only 0.1 % of D − idose exists in the anhydro form under the same condition has to be given. Concept Introduction: The chair conformers are stable forms of cyclic compounds. In chair conformation, substituent’s prefers to place at equatorial positions. This is due to unwanted interactions between those substituent’s that are placed at axial positions. These interactions cause repulsion and that leads to the un-stability in molecule. The general interactions that occur between axial substituents are 1 , 3 − diaxial interactions.

Question

Want to see the full answer?

Answer 1

Question

Chapter 16, Problem 41P

Interpretation Introduction

Interpretation:

The explanation corresponding to the given statement that 80% of D−idose exists in the anhydrous form in an aqueous solution at 100 °C, but only 0.1% of D−idose exists in the anhydro form under the same condition has to be given.

Concept Introduction:

The chair conformers are stable forms of cyclic compounds. In chair conformation, substituent’s prefers to place at equatorial positions. This is due to unwanted interactions between those substituent’s that are placed at axial positions. These interactions cause repulsion and that leads to the un-stability in molecule. The general interactions that occur between axial substituents are 1,3− diaxial interactions.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

A cylinder contains 12 L of water vapour at 150˚C and 5 atm. The temperature of the water vapour is raised to 175˚C, and the volume of the cylinder is reduced to 8.5 L. What is the final pressure of the gas in atmospheres? assume that the gas is ideal

On the next page is an LC separation of the parabens found in baby wash. Parabens are suspected in a link to breast cancer therefore an accurate way to quantitate them is desired. a. In the chromatogram, estimate k' for ethyl paraben. Clearly indicate what values you used for all the terms in your calculation. b. Is this a "good" value for a capacity factor? Explain. c. What is the resolution between n-Propyl paraben and n-Butyl paraben? Again, indicate clearly what values you used in your calculation. MAU | Methyl paraben 40 20 0 -2 Ethyl paraben n-Propyl paraben n-Butyl paraben App ID 22925 6 8 min

d. In Figure 4, each stationary phase shows some negative correlation between plate count and retention factor. In other words, as k' increases, N decreases. Explain this relationship between k' and N. Plate Count (N) 4000 3500 2500 2000 1500 1000 Figure 4. Column efficiency (N) vs retention factor (k') for 22 nonionizable solutes on FMS (red), PGC (black), and COZ (green). 3000 Eluent compositions (acetonitrile/water, A/W) were adjusted to obtain k' less than 15, which was achieved for most solutes as follows: FMS (30/70 A/W), PGC (60/40), COZ (80/20). Slightly different compositions were used for the most highly retained solutes. All columns were 50 mm × 4.6 mm id and packed with 5 um particles, except for COZ, which was packed with 3 um particles. All other chromatographic conditions were constant: column length 5 cm, column j.§. 4.6 mm, flow rate 2 mL/min, column temperature 40 °C, and injection volume 0.5 μL Log(k'x/K'ethylbenzene) FMS 1.5 1.0 0.5 0.0 ཐྭ ཋ ཤྩ བྷྲ ; 500 0 5 10…