The formal charge on the nitrogen atom in the given structure has to be found. Concept Introduction: Formal charge is the one that is associated with the atom which do not exhibit the expected number of valence electrons. They are very much important in drawing the structure because ignoring formal charge will lead to a wrong structure information. Formal charge can be found by knowing the valence electron of the atom and the total number of bonds present in the atom. Each and every bond is formed by two electrons. Formal charge can be found by placing the electrons around the atom and comparing it with the valence electrons of that particular atom. If both are same means, then there is no formal charge on the atom. If the valence electron is more than the electrons that takes place in the bond, then a negative formal charge is present and vice-versa.

Question

Want to see the full answer?

Answer 1

Question

Chapter 1.5, Problem 1.41P

Interpretation Introduction

Interpretation:

The formal charge on the nitrogen atom in the given structure has to be found.

Concept Introduction:

Formal charge is the one that is associated with the atom which do not exhibit the expected number of valence electrons. They are very much important in drawing the structure because ignoring formal charge will lead to a wrong structure information. Formal charge can be found by knowing the valence electron of the atom and the total number of bonds present in the atom. Each and every bond is formed by two electrons. Formal charge can be found by placing the electrons around the atom and comparing it with the valence electrons of that particular atom. If both are same means, then there is no formal charge on the atom. If the valence electron is more than the electrons that takes place in the bond, then a negative formal charge is present and vice-versa.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

A cylinder contains 12 L of water vapour at 150˚C and 5 atm. The temperature of the water vapour is raised to 175˚C, and the volume of the cylinder is reduced to 8.5 L. What is the final pressure of the gas in atmospheres? assume that the gas is ideal

On the next page is an LC separation of the parabens found in baby wash. Parabens are suspected in a link to breast cancer therefore an accurate way to quantitate them is desired. a. In the chromatogram, estimate k' for ethyl paraben. Clearly indicate what values you used for all the terms in your calculation. b. Is this a "good" value for a capacity factor? Explain. c. What is the resolution between n-Propyl paraben and n-Butyl paraben? Again, indicate clearly what values you used in your calculation. MAU | Methyl paraben 40 20 0 -2 Ethyl paraben n-Propyl paraben n-Butyl paraben App ID 22925 6 8 min

d. In Figure 4, each stationary phase shows some negative correlation between plate count and retention factor. In other words, as k' increases, N decreases. Explain this relationship between k' and N. Plate Count (N) 4000 3500 2500 2000 1500 1000 Figure 4. Column efficiency (N) vs retention factor (k') for 22 nonionizable solutes on FMS (red), PGC (black), and COZ (green). 3000 Eluent compositions (acetonitrile/water, A/W) were adjusted to obtain k' less than 15, which was achieved for most solutes as follows: FMS (30/70 A/W), PGC (60/40), COZ (80/20). Slightly different compositions were used for the most highly retained solutes. All columns were 50 mm × 4.6 mm id and packed with 5 um particles, except for COZ, which was packed with 3 um particles. All other chromatographic conditions were constant: column length 5 cm, column j.§. 4.6 mm, flow rate 2 mL/min, column temperature 40 °C, and injection volume 0.5 μL Log(k'x/K'ethylbenzene) FMS 1.5 1.0 0.5 0.0 ཐྭ ཋ ཤྩ བྷྲ ; 500 0 5 10…