Explanation: In asynchronous parallel Small Computer System Interface (SCSI) data transfer method, each phase of data transfer is allotted with fixed time. If the floppy disk is removed during the data transmission, then the error may be occurred in any phase of data transfer. Bus free: The bus is said to be in “bus free” state if the data transmission is completed. By removing the target, the floppy disk cannot free the bus. Hence, the error occurs in bus free phase. Selection: The target on the bus includes the address of floppy disk and increases the SEL signal and decreases the BSY line. By removing the target, the BSY signal cannot be increased. Hence, the error occurs in selection phase. Command: The change in the SEL signals doesn’t affect the command line, request signal and data transfer. Hence, the error occurs in command phase. Data: The error occurred after the completion of data transmission doesn’t change the bus mode, command signal and input/output line...

Question

Want to see the full answer?

Answer 1

Expert Solution & Answer

Chapter 13, Problem 3E

a.

Explanation of Solution

Explanation:

In asynchronous parallel Small Computer System Interface (SCSI) data transfer method, each phase of data transfer is allotted with fixed time.

If the floppy disk is removed during the data transmission, then the error may be occurred in any phase of data transfer.

Bus free: The bus is said to be in “bus free” state if the data transmission is completed. By removing the target, the floppy disk cannot free the bus. Hence, the error occurs in bus free phase.

Selection: The target on the bus includes the address of floppy disk and increases the SEL signal and decreases the BSY line. By removing the target, the BSY signal cannot be increased. Hence, the error occurs in selection phase.

Command: The change in the SEL signals doesn’t affect the command line, request signal and data transfer. Hence, the error occurs in command phase.

Data: The error occurred after the completion of data transmission doesn’t change the bus mode, command signal and input/output line...

b.

Explanation of Solution

Explanation:

In asynchronous parallel Small Computer System Interface (SCSI) data transfer method, each phase of data transfer is allotted with fixed time.

If the floppy disk is removed during the data transmission, then the error may be occurred in any phase of data transfer.

Bus free: The bus is said to be in “bus free” state if the data transmission is completed. By removing the target, the floppy disk cannot free the bus. Hence, the error occurs in bus free phase.

Selection: The target on the bus includes the address of floppy disk and increases the SEL signal and decreases the BSY line. By removing the target, the BSY signal cannot be increased. Hence, the error occurs in selection phase.

Command: The change in the SEL signals doesn’t affect the command line, request signal and data transfer. Hence, the error occurs in command phase.

Data: The error occurred after the completion of data transmission doesn’t change the bus mode, command signal and input/output line...

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

Show all the work

[5 marks] Give a recursive definition for the language anb2n where n = 1, 2, 3, ... over the alphabet Ó={a, b}. 2) [12 marks] Consider the following languages over the alphabet ={a ,b}, (i) The language of all words that begin and end an a (ii) The language where every a in a word is immediately followed by at least one b. (a) Express each as a Regular Expression (b) Draw an FA for each language (c) For Language (i), draw a TG using at most 3 states (d) For Language (ii), construct a CFG.

Question 1 Generate a random sample of standard lognormal data (rlnorm()) for sample size n = 100. Construct histogram estimates of density for this sample using Sturges’ Rule, Scott’s Normal Reference Rule, and the FD Rule. Question 2 Construct a frequency polygon density estimate for the sample in Question 1, using bin width determined by Sturges’ Rule.