Whether KNO 3 gives the more concentrated solution in H 2 O or CCl 4 is to be determined. Concept introduction: The solution is a homogeneous mixture of two or more substances. It can exist in any of the phases. Salt water, rubbing alcohol, bleach and air are some examples of solutions. It has two components: solute and solvent. The solute is the substance that is present in smaller quantity and gets itself dissolved in the other substance. The solvent is the substance that is present in larger amount and it dissolves solute in itself. The characteristics of solution are as follows: 1. It is a homogeneous mixture of two or more substances. 2. The particles of solute can never be seen by the naked eye. 3. It does not allow the light beam to scatter. 4. It is stable. 5. The components of solution cannot be separated by filtration. 6. It is composed of one phase only.

Question

Want to see the full answer?

Answer 1

Question

Chapter 13, Problem 13.7P

Interpretation Introduction

Interpretation:

Whether KNO3 gives the more concentrated solution in H2O or CCl4 is to be determined.

Concept introduction:

The solution is a homogeneous mixture of two or more substances. It can exist in any of the phases. Salt water, rubbing alcohol, bleach and air are some examples of solutions. It has two components: solute and solvent. The solute is the substance that is present in smaller quantity and gets itself dissolved in the other substance. The solvent is the substance that is present in larger amount and it dissolves solute in itself.

The characteristics of solution are as follows:

1. It is a homogeneous mixture of two or more substances.

2. The particles of solute can never be seen by the naked eye.

3. It does not allow the light beam to scatter.

4. It is stable.

5. The components of solution cannot be separated by filtration.

6. It is composed of one phase only.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

8:57 PM Sun Jan 26 Content ← Explanation Page X Content X ALEKS Jade Nicol - Le A https://www-av C www-awa.aleks.com O States of Matter Understanding consequences of important physical properties of liquids ? QUESTION Liquid A is known to have a lower viscosity and lower surface tension than Liquid B. Use these facts to predict the result of each experiment in the table below, if you can. experiment Liquid A and Liquid B are each pumped through tubes with an inside diameter of 27.0 mm, and the pressures PA and PB needed to produce a steady flow of 2.4 mL/s are measured. 25.0 mL of Liquid A are poured into a beaker, and 25.0 mL of Liquid B are poured into an identical beaker. Stirrers in each beaker are connected to motors, and the forces FA and FB needed to stir each liquid at a constant rate are measured. predicted outcome OPA will be greater than PB OPA will be less than PB OPA will be equal to PB It's impossible to predict whether PA or PB will be greater without more information.…

Show work. Don't give Ai generated solution

5. Please draw in the blanks the missing transition states and the correlated products. Explicitly display relevant absolute stereochemical configuration. MeOH I OMe H Endo transition state, dienophile approaching from the bottom of diene + H ཎྞཾ ཌཱརཱ༔,_o OMe H H OMe Endo transition state, dienophile approaching from the top of diene or from the bottom but horizontally flipped (draw one) + Exo transition state, dienophile approaching from the top of diene or from the bottom but horizontally flipped (draw one) Exo transition state, dienophile approaching from the top of diene or from the bottom but horizontally flipped (draw one) MeO H H MeO H MeO H MeO H H