The transition states of exo and endo Diels Ander reactions of maleic anhydride with cyclopentadiene are to be drawn. Also, the transition state that leads to only one enantiomer need to be shown in each. Concept introduction: A Diels Ander reaction is one between a conjugate diene and a reactant containing a double bond (dienophile) to form a product. The product is called adduct. Diels Ander reactions are highly stereospecific. The configuration of the dienophile is retained in the product and the reaction is a syn addition reaction. The dienes react with dienophiles in cis forms rather than trans forms. Endo and exo refer to the orientation of the dienophile and its electron-withdrawing group when it reacts with a diene in a Diels Ander reaction. Endo is favored in the transition state of a Diels Ander reaction because it has a lower energy.

Question

Want to see the full answer?

Answer 1

Question

Chapter 13, Problem 11PP

Interpretation Introduction

Interpretation:

The transition states of exo and endo Diels Ander reactions of maleic anhydride with cyclopentadiene are to be drawn. Also, the transition state that leads to only one enantiomer need to be shown in each.

Concept introduction:

A Diels Ander reaction is one between a conjugate diene and a reactant containing a double bond (dienophile) to form a product. The product is called adduct.

Diels Ander reactions are highly stereospecific. The configuration of the dienophile is retained in the product and the reaction is a syn addition reaction.

The dienes react with dienophiles in cis forms rather than trans forms.

Endo and exo refer to the orientation of the dienophile and its electron-withdrawing group when it reacts with a diene in a Diels Ander reaction.

Endo is favored in the transition state of a Diels Ander reaction because it has a lower energy.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

LTS Solid: AT=Te-Ti Trial 1 Trial 2 Trial 3 Average ΔΗ Mass water, g 24.096 23.976 23.975 Moles of solid, mol 0.01763 001767 0101781 Temp. change, °C 2.9°C 11700 2.0°C Heat of reaction, J -292.37J -170.473 -193.26J AH, kJ/mole 16.58K 9.647 kJ 10.85 kr 16.58K59.64701 KJ mol 12.35k Minimum AS, J/mol K 41.582 mol-k Remember: q = mCsAT (m = mass of water, Cs=4.184J/g°C) & qsin =-qrxn & Show your calculations for: AH in J and then in kJ/mole for Trial 1: qa (24.0969)(4.1845/g) (-2.9°C)=-292.37J qsin = qrxn = 292.35 292.37J AH in J = 292.375 0.2923kJ 0.01763m01 =1.65×107 AH in kJ/mol = = 16.58K 0.01763mol mol qrx Minimum AS in J/mol K (Hint: use the average initial temperature of the three trials, con Kelvin.) AS=AHIT (1.65×10(9.64×103) + (1.0 Jimai

For the compound: C8H17NO2 Use the following information to come up with a plausible structure: 8 This compound has "carboxylic acid amide" and ether functional groups. The peaks at 1.2ppm are two signals that are overlapping one another. One of the two signals is a doublet that represents 6 hydrogens; the other signal is a quartet that represents 3 hydrogens.

Vnk the elements or compounds in the table below in decreasing order of their boiling points. That is, choose 1 next to the substance with the highest bolling point, choose 2 next to the substance with the next highest boiling point, and so on. substance C D chemical symbol, chemical formula or Lewis structure. CH,-N-CH, CH, H H 10: H C-C-H H H H Cale H 10: H-C-C-N-CH, Bri CH, boiling point (C) Сен (C) B (Choose