The values of r by using the given differential equation.

Question

Want to see the full answer?

Answer 1

Question

Chapter 1.3, Problem 11P

To determine

The values of r by using the given differential equation.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

6. [10] Evaluate (2 (2+2y) ds where C is the upper half-circle centered at the origin connecting the point (2,0) to the point (-2,0). 7. [10] Show that the vector field F(x, y, z) = is conservative and integrate it along the curve П C(t) = si sin t, nt, cost,t), te [0,1] 8. [10] Use Stokes' Theorem to compute the integral curl F.dS, where F(x, y, z) = xzi+yxj+xy k I cur and S is the part of the sphere x² + y²+z² = 9 that lies inside the cylinder x2 + y² above the xy-plane. 9. [10] Use Green's theorem to evaluate So √1+x3 dx+2xy dy where C is the triangle with vertices (0,0), (1, 0) and (1, 3). 10. [10] Evaluate the surface integral (x²z + y²z) dS where S is the hemisphere x² + y²+2² = 4, z> 0. = 1 and ☐

Part 1: A linear electrical load draws 1₁ A at a 0.72 lagging power factor. See the table to find ½ for your student ID. When a capacitor is connected, the line current dropped to 122 A and the power factor improved to 0.98 lagging. Supply frequency is 50 Hz. a. Let the current drawn from the source before and after introduction of the capacitor be 1₁ and I₂ respectively. Take the source voltage as the reference and express 11 and 12 as vector quantities in polar form. b. Obtain the capacitor current, Ic = 12 − I₁, graphically as well as using complex number manipulation. Compare the results. c. Express the waveforms of the source current before (į (t)) and after (i2(t)) introduction of the capacitor in the form Im sin(2лft + 0). Hand sketch them on the same graph. Clearly label your plots. d. Analytically solve i̟2(t) − i₁ (t) using the theories of trigonometry to obtain the capacitor current in the form, ic(t) = Icm sin(2πft + 0c). Compare the result with the result in Part b.

= x³, y = 8, x = 0. Let R be the region bounded by the curves y = x³ 1. Sketch the region and find the area. Write your answer in simplest fractional form. 2. Sketch the solid you obtain by rotating the region R about the x-axis. 3. Find the volume of the solid obtained by rotating the region R about the x-axis using the disk/washer method. Write the formula you are using. Write your answer in terms of π. Draw the approximating rectangle that you rotate. 4. Find the volume of the solid obtained by rotating the region R about the x-axis using the shell method. Write the formula you are using. Write your answer in terms of π. Draw the approximating rectangle that you rotate. 5. Which method did you find easier and why? [There is no wrong answer for what you find easier, but explain.] 6. Sketch the solid you obtain by rotating the region R about the y-axis. 7. Find the volume of the solid obtained by rotating the region R about the y-axis using the disk/washer method. Write the formula…