The meaning for an atom to be in an excited state and to be in its ground state is to be stated. The procedure by which an excited atom returns to its ground state is to be stated. The meaning of a photon is to be stated. The relation between the wavelength of light and the energy of the photons being emitted by an atom is to be stated. The relation between the energy of the photons being emitted by an atom and the energy changes that takes place within the atom is to be stated. Concept Introduction: The distribution of the electrons that exists in the atomic orbital of an atom is collectively known as electronic configuration. The description of every electron in an orbital is given by the electronic configuration of that atom. A photon always moves with a speed of light that is equal to 3 × 10 8 m/s .

Question

Want to see the full answer?

Answer 1

Question

Chapter 12, Problem 14CR

Interpretation Introduction

Interpretation:

The meaning for an atom to be in an excited state and to be in its ground state is to be stated. The procedure by which an excited atom returns to its ground state is to be stated. The meaning of a photon is to be stated. The relation between the wavelength of light and the energy of the photons being emitted by an atom is to be stated. The relation between the energy of the photons being emitted by an atom and the energy changes that takes place within the atom is to be stated.

Concept Introduction:

The distribution of the electrons that exists in the atomic orbital of an atom is collectively known as electronic configuration. The description of every electron in an orbital is given by the electronic configuration of that atom.

A photon always moves with a speed of light that is equal to 3×108 m/s.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

Don't used hand raiting

at 32.0 °C? What is the osmotic pressure (in atm) of a 1.46 M aqueous solution of urea [(NH2), CO] at 3 Round your answer to 3 significant digits.

Reagan is doing an atomic absorption experiment that requires a set of zinc standards in the 0.4-1.6 ppm range. A 1000 ppm Zn solution was prepared by dissolving the necessary amount of solid Zn(NO3)2 in water. The standards can be prepared by diluting the 1000 ppm Zn solution. Table 1 shows one possible set of serial dilutions (stepwise dilution of a solution) that Reagan could perform to make the necessary standards. Solution A was prepared by diluting 5.00 ml of the 1000 ppm Zn standard to 50.00 ml. Solutions C-E are called "calibration standards" because they will be used to calibrate the atomic absorption spectrometer. a. Compare the solution concentrations expressed as ppm Zn and ppm Zn(NO3)2. Compare the concentrations expressed as M Zn and M Zn(NO3)2 - Which units allow easy conversion between chemical species (e.g. Zn and Zn(NO3)2)? - Which units express concentrations in numbers with easily expressed magnitudes? - Suppose you have an analyte for which you don't know the molar…