One dimensional normal shock functions by varying upstream Mach number.

Question

Want to see the full answer?

Answer 1

Question

Chapter 12, Problem 129P

To determine

One dimensional normal shock functions by varying upstream Mach number.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

For non-isentropic constant-area flow with stagnation temperature change the following relation was determined: Y 1 To _ ²(y + 1)M² (1 + ¹ Z ¹ M²) 2 TO (1+yM²)² It is possible to use the above equation and calculate the downstream Mach number without resorting to iteration for a flow where the upstream Mach number, as well as the upstream and downstream stagnation temperatures, are known. This is a common calculation for flows through engine combustors. Presuming the left side is a known quantity, show that the above equation can be directly solved as a quadratic in M² and which roots correspond to the subsonic/supersonic solution. Rewrite the equation as: aM4 + bM² + c = 0, and then M² = (−b ± √b² - 4ac)/2a. Determine the appropriate expressions for a, b, and c.

Can the Mach number of a fluid be greater than 1 after a normal shock wave? Explain.

Gas dynamics Dr. Sajida Lafta Q5- Air enters a 15 m long. 4 cm diameter adiabatic duct at V=70 m's, T=500 K, and P=300 kPa. The average friction factor for the duct is estimated to be 0.023. Determine the Mach number at the duct exit, the exit velocity, and the mass flow rate of air.