The mode of transfer for the tensile stress in the matrix in a composite material with short fibers into the fibers.

Question

Want to see the full answer?

Answer 1

Question

Chapter 12, Problem 11CQ

To determine

The mode of transfer for the tensile stress in the matrix in a composite material with short fibers into the fibers.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

Problem: In designing an asphalt concrete mixture for highway pavement, data in the table below showing the aggregate characteristics were used. Percent by weight of Effective specific Aggregate type Bulk specific gravities total paving mixture gravity Coarse aggregates 42 Fine aggregates 51 Mineral fillers 7 2.60 2.71 2.82 2.69 Determine the optimum asphalt content as a percentage of the total mix if results obtained using the Marshall method are shown in the following table. The specific gravity of the asphalt is 1.02. (Use Table 8 for required specifications.) Weight of Specimen (g) Percent Asphalt in Air in Water Stability (lb) Flow (0.01 in.) 5.5 1325.3 785.6 1796 13 6.0 1330.1 793.3 1836 14 6.5 1336.2 800.8 1861 16 7.0 1342.0 804.5 1818 20 7.5 1347.5 805.1 1701 25

12.36 Figure P12.36 shows a 3 × 5 pile group consisting of 15 concrete piles of 400 mm diameter and 12 m in length. What would be the maximum load that can be allowed on the mat with a factor of safety of 3? The piles have a center- to-center spacing of 1200 mm. Qall = ? Clay Cu= 60 kN/m² Clay Cu= 90 kN/m² 5 m 7 m

2.64 A 2.75-kN tensile load is applied to a test coupon made from 1.6-mm flat steel plate (E = 200 GPa, v = 0.30). Determine the resulting change in (a) the 50-mm gage length, (b) the width of portion AB of the test coupon, (c) the thickness of portion AB, (d) the cross-sectional area of portion AB. 2.75 kN A 12 mm 50 mm B 2.75 kN