The molar mass of the protein is to be calculated from its osmotic pressure at 23.1 ° C . Concept introduction: Solvent always flows from lower concentration to higher concentration. This process of solvent flow is known as osmosis. Now if another side external pressure is applied then this process reversed and this applied reverse pressure is known as osmotic pressure. The higher osmotic pressure containing solution has the higher concentration. Basically, with the help of the value of osmotic pressure the concentration of solvent is calculated and with the help of the concentration the molar mass of the compound is calculated. To determine: The molar mass of the protein for the given value of osmotic pressure.

Question

Want to see the full answer?

Answer 1

Question

Chapter 11, Problem 11.105AP

Interpretation Introduction

Interpretation: The molar mass of the protein is to be calculated from its osmotic pressure at 23.1 °C .

Concept introduction: Solvent always flows from lower concentration to higher concentration. This process of solvent flow is known as osmosis. Now if another side external pressure is applied then this process reversed and this applied reverse pressure is known as osmotic pressure.

The higher osmotic pressure containing solution has the higher concentration. Basically, with the help of the value of osmotic pressure the concentration of solvent is calculated and with the help of the concentration the molar mass of the compound is calculated.

To determine: The molar mass of the protein for the given value of osmotic pressure.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

Correct each molecule in the drawing area below so that it has the skeletal ("line") structure it would have if it were dissolved in a 0.1 M aqueous solution of HCI. If there are no changes to be made, check the No changes box under the drawing area. No changes. HO Explanation Check NH, 2 W O :□ G ©2025 M unter Accessibility

An expression for the root mean square velocity, vrms, of a gas was derived. Using Maxwell’s velocity distribution, one can also calculate the mean velocity and the most probable velocity (mp) of a collection of molecules. The equations used for these two quantities are vmean=(8RT/πM)1/2 and vmp=(2RT/M)1/2 These values have a fixed relationship to each other.(a) Arrange these three quantities in order of increasing magnitude.(b) Show that the relative magnitudes are independent of the molar mass of the gas.(c) Use the smallest velocity as a reference for establishing the order of magnitude and determine the relationship between the larger and smaller values.

The reaction of solid dimethylhydrazine, (CH3)2N2H2, and liquefied dinitrogen tetroxide, N2O4, has been investigated for use as rocket fuel. The reaction produces the gases carbon dioxide (CO2), nitrogen (N2), and water vapor (H2O), which are ejected in the exhaust gases. In a controlled experiment, solid dimethylhydrazine was reacted with excess dinitrogen tetroxide, and the gases were collected in a closed balloon until a pressure of 2.50 atm and a temperature of 400.0 K were reached.(a) What are the partial pressures of CO2, N2, and H2O?(b) When the CO2 is removed by chemical reaction, what are the partial pressures of the remaining gases?