You complain about fire safety to the landlord of your high-rise apartment building. He is willing to install an evacuation device if it is cheap and reliable, and he asks you to design it. Your proposal is to mount a large wheel (radius 0.400 m) on an axle at its center and wrap a long, light rope around the wheel, with the free end of the rope hanging just past the edge of the roof. Residents would evacuate to the roof and. one at a time, grasp the free end of the rope, step off the roof, and be lowered to the ground below. (Ignore friction at the axle.) You want a 90.0-kg person to descend with an acceleration of g/4. (a) If the wheel can be treated as a uniform disk, what mass must it have? (b) As the person descends, what is the tension in the rope?
Want to see the full answer?
Check out a sample textbook solutionChapter 10 Solutions
University Physics (14th Edition)
Additional Science Textbook Solutions
Physics for Scientists and Engineers: A Strategic Approach with Modern Physics (4th Edition)
Physics for Scientists and Engineers: A Strategic Approach, Vol. 1 (Chs 1-21) (4th Edition)
College Physics (10th Edition)
Conceptual Physics (12th Edition)
Applied Physics (11th Edition)
Essential University Physics (3rd Edition)
- An ultracentrifuge accelerates from to 100,000 rpm in 2.00 min. (a) What is the average angular acceleration in rad/s2 ? (b) What is the tangential acceleration of a point 9.50 cm from the axis of rotation? (c) What is the centripetal acceleration in m/s2 and multiples of g of this point at full rpm? (d) What is the total distance travelled by a point 9.5 cm from the axis of totation of the ultracentrifuge?arrow_forwardHelp with the attached question.arrow_forwardThere is a clever kitchen gadget for drying lettuce leaves after you wash them. It consists of a cylindrical container mounted so that it can be rotated about its axis by turning a hand crank. The outer wall of the cylinder is perforated with small holes. You put the wet leaves in the container and turn the crank to spin off the water. The radius of the container is 15.0 cm. When the cylinder is rotating at 1.64 revolutions per second, what is the magnitude of the centripetal acceleration at the outer wall?arrow_forward
- Initially, a small 4.0-kg rock is whirling at the end of a very thin string in a circular path of radius 1.25 m on a horizontal frictionless surface, as shown in the figure. The initial tangential speed of the rock was 8.0 m/s. The string has been slowly winding around a vertical rod, and a few seconds later the length of the string has shortened to 0.25 m. What is the instantaneous speed of the mass at the moment the string reaches a length of 0.25 m?arrow_forwardTwo boxes are connected to a string, and the string is hung over a pulley connected to the ceiling, as shown in the figure below. The masses of the boxes are m1 = 18.0 kg and m2 = 12.0 kg, the mass of the pulley is M = 5.00 kg, and the radius of the pulley is R = 0.300 m. Box m2 is initially on the floor, and box m1 is initially 4.40 m above the floor when it is released from rest. The pulley's axis has negligible friction. The mass of the string is small enough to be ignored, and the string does not slip on the pulley, nor does it stretch. (a) How much time (in s) does it take box m1 to hit the floor after being released? (b) How would your answer to part (a) change if the mass of the pulley were neglected? (Enter the time, in seconds, it takes box m1 to hit the floor if the mass of the pulley were neglected.)arrow_forwardA common carnival ride, called a gravitron, is a large cylinder in which people stand against the wall of the ride as it rotates. At a certain point the floor of the cylinder lowers and the people are surprised that they don't slide down. Suppose the radius of the cylinder is r = 11 m, and the friction between the wall and their clothes is μs = 0.55. Consider the tangential speed v of the ride's occupants as the cylinder spins. a. What is the frequency f in revolutions per minute of the carnival ride when it has reached the minimum speed to "stick" someone to the wall?arrow_forward
- A common carnival ride, called a gravitron, is a large cylinder in which people stand against the wall of the ride as it rotates. At a certain point the floor of the cylinder lowers and the people are surprised that they don't slide down. Suppose the radius of the cylinder is r = 13 m, and the friction between the wall and their clothes is μs = 0.64. Consider the tangential speed v of the ride's occupants as the cylinder spins. (a) What is the minimum speed, in meters per second, that the cylinder must make a person move at to ensure they will "stick" to the wall? (b) What is the frequency f in revolutions per minute of the carnival ride when it has reached the minimum speed to "stick" someone to the wall?arrow_forwardA common carnival ride, called a gravitron, is a large cylinder in which people stand against the wall of the ride as it rotates. At a certain point the floor of the cylinder lowers and the people are surprised that they don't slide down. Suppose the radius of the cylinder is r = 12 m, and the friction between the wall and their clothes is μ = 0.62. Consider the tangential speed v of the ride's occupants as the cylinder spins. a) What is the minimum speed, in meters per second, that the cylinder must make a person move at to ensure they will "stick" to the wall? Vmin = b) What is the frequency fin revolutions per minute of the carnival ride when it has reached the minimum speed to "stick" someone to the wall? f=arrow_forwardHow much work is done by the motor in a CD player to make a CD spin, starting from rest? The CD has a diameter of 12.0 cm and a mass of 15.8 g. The laser scans at a constant tangential velocity of 1.20 m/s. Assume that the music is first detected at a radius of 29.0 mm from the center of the disk. Ignore the small circular hole at the CD’s center. in Jarrow_forward
- A small ball of mass 740.0 g is placed in a tube that is bent into a circular arc of radius R= 67.5 cm.The friction between the ball and the walls of the tube is negligible. The ball has an iron core. A magnet is used to raise the ball until it makes an angle of 5.00 degrees with the vertical, and then released from rest. Where will the ball be 1.20 seconds after being released? Express your answer in terms of the angle,θ, that the ball makes with the vertical.arrow_forwardA disk of radius R spins about its center at 1 revolution every Y seconds. Find the linear speed of a point at distance R from the center of rotation. Solve for R=10 cm and Y=5 s.arrow_forwardA small 0.360-kg object moves on a frictionless horizontal table in a circular path of radius 2.90 m. The angular speed is 4.35 rad/s. The object is attached to a string of negligible mass that passes through a small hole in the table at the center of the circle. Someone under the table begins to pull the string downward to make the circle smaller. If the string will tolerate a tension of no more than 167 N, what is the radius of the smallest possible circle on which the object can move?arrow_forward
- Physics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage LearningUniversity Physics Volume 1PhysicsISBN:9781938168277Author:William Moebs, Samuel J. Ling, Jeff SannyPublisher:OpenStax - Rice University