International Edition---engineering Mechanics: Statics  4th Edition
International Edition---engineering Mechanics: Statics 4th Edition
4th Edition
ISBN: 9781305856240
Author: Pytel
Publisher: Cengage
bartleby

Concept explainers

bartleby

Videos

Textbook Question
Book Icon
Chapter 1, Problem 1.1P

A person weighs 30 lb on the moon, where g = 5.32 ft/s 2 . Determine (a) the mass of the person; and (b) the weight of the person on earth.

Expert Solution
Check Mark
To determine

(a)

The mass of the person.

Answer to Problem 1.1P

The mass of the person is 5.64 slug.

Explanation of Solution

The person weighs 30 lb on the moon, where g=5.32ft/s2.

Calculation:

Weight of one unit of mass is:

   W=mg m=Wg=305.32 =5.64slug

Conclusion:

The mass of the person is calculated using one unit of mass and then the ratio is calculated.

Expert Solution
Check Mark
To determine

(b)

The weight of a person on earth.

Answer to Problem 1.1P

The weight of a person on earth is 181.61 lb.

Explanation of Solution

The mass of the person is 5.64 slug.

Calculation:

Weight of one unit of mass is,

   W=mg W=5.64×32.2 =181.61lb

Conclusion:

The weight of the person on earth has calculated using one unit of mass and then multiplied with the mass of a person.

Want to see more full solutions like this?

Subscribe now to access step-by-step solutions to millions of textbook problems written by subject matter experts!
Students have asked these similar questions
I need help answering parts a and b
Required information Water initially at 200 kPa and 300°C is contained in a piston-cylinder device fitted with stops. The water is allowed to cool at constant pressure until it exists as a saturated vapor and the piston rests on the stops. Then the water continues to cool until the pressure is 100 kPa. NOTE: This is a multi-part question. Once an answer is submitted, you will be unable to return to this part. Water 200 kPa 300°C On the T-V diagram, sketch, with respect to the saturation lines, the process curves passing through the initial, intermediate, and final states of the water. Label the T, P, and V values for end states on the process curves. Please upload your response/solution by using the controls provided below.
A piston-cylinder device contains 0.87 kg of refrigerant-134a at -10°C. The piston that is free to move has a mass of 12 kg and a diameter of 25 cm. The local atmospheric pressure is 88 kPa. Now, heat is transferred to refrigerant-134a until the temperature is 15°C. Use data from the tables. R-134a -10°C Determine the change in the volume of the cylinder of the refrigerant-134a if the specific volume and enthalpy of R-134a at the initial state of 90.4 kPa and -10°C and at the final state of 90.4 kPa and 15°C are as follows: = 0.2418 m³/kg, h₁ = 247.77 kJ/kg 3 v2 = 0.2670 m³/kg, and h₂ = 268.18 kJ/kg The change in the volume of the cylinder is m

Chapter 1 Solutions

International Edition---engineering Mechanics: Statics 4th Edition

Ch. 1 - The position coordinate x of a particle is...Ch. 1 - A differential equation encountered in the...Ch. 1 - Determine the dimensions of constants A and B far...Ch. 1 - The typical power output of a compact car engine...Ch. 1 - Two 12-kg spheres are placed 400 mm apart. Express...Ch. 1 - Two identical spheres of radius 8 in. and weighing...Ch. 1 - A man weighs 170 lb on the surface of the earth....Ch. 1 - Use Eq. (1.4) to show that the weight of an object...Ch. 1 - Plot the earths gravitational acceleration g(m/s2)...Ch. 1 - Find the elevation h (km) where the weight of an...Ch. 1 - Calculate the gravitational force between the...Ch. 1 - The magnitudes of the two velocity vectors are...Ch. 1 - Determine the magnitudes of vectors v1 and v2 so...Ch. 1 - The pole AB is held up by the rope attached to B....Ch. 1 - Resolve the 20-kN force into components along the...Ch. 1 - The velocity vector of the boat has two...Ch. 1 - Two members of a truss apply the forces shown to...Ch. 1 - Two members of a truss apply the forces shown to...Ch. 1 - Determine the resultant of the position vectors A...Ch. 1 - Resolve the position vector A of the car (measured...Ch. 1 - Resolve the 360-lb force into components along the...Ch. 1 - The supporting cables AB and AC are oriented so...Ch. 1 - The two forces shown act on the structural member...Ch. 1 - The resultant of the two forces has a magnitude of...Ch. 1 - The forces acting on the bob of the pendulum are...Ch. 1 - A surveyor sights a target at C from points A and...Ch. 1 - Knowing that the resultant of the two forces is...Ch. 1 - To move the oil drum, the resultant of the three...Ch. 1 - The resultant of the 50-Ib and 30-lb forces is R....Ch. 1 - Obtain the rectangular representation of the force...Ch. 1 - The length of the position vector r is 240 mm....Ch. 1 - Determine the rectangular components of the 560-lb...Ch. 1 - The coordinates of points A and B are (-3, 0, 2)...Ch. 1 - The slider travels along the guide rod AB with the...Ch. 1 - Find the rectangular representation of the force...Ch. 1 - The magnitude of the force F is 160 lb. Find its...Ch. 1 - A rifle at A is fired at a target at B. If the...Ch. 1 - The pole OB is subjected to the 6004b force at B....Ch. 1 - The cables AB and AC are attached to the frame...Ch. 1 - The two forces are applied to the end of the boom...Ch. 1 - The magnitudes of the three forces are...Ch. 1 - Given that P=120lb and Q=130lb, find the...Ch. 1 - Knowing that P=90lb and that the resultant of P...Ch. 1 - If R is the resultant of the forces P and Q, find...Ch. 1 - The force R is the resultant of P and 0. Determine...Ch. 1 - The vertical post is secured by three cables. The...Ch. 1 - Compute the dot product A - B for each of the...Ch. 1 - Compute the cross product C=AB for each of the...Ch. 1 - Given r=4i6j+2km (position vector) F=20i+40j30kN...Ch. 1 - Compute AB and CB for the position vectors shown.Ch. 1 - Use the dot product to find the angle between the...Ch. 1 - Use the dot product to find the angle between the...Ch. 1 - Let A and B be two nonparallel vectors that lie in...Ch. 1 - Determine (a) the angle between the position...Ch. 1 - Find a unit vector that is perpendicular to both...Ch. 1 - The three points A(0,2,2),B(1,4,1), and C(3,0,0)...Ch. 1 - For the position vectors P and Q shown, determine...Ch. 1 - Compute the orthogonal Component of F=6i+20j12klb...Ch. 1 - Compute the value of the scalar a for which the...Ch. 1 - Resolve A=3i+5j4k in. into two vector...Ch. 1 - The force F=5i+12j+4k lb is applied to the handle...Ch. 1 - Determine the value of the scalar a if the...Ch. 1 - Resolve the force F=20i+30j+50klb into two...Ch. 1 - It can be show that a plane area may he...Ch. 1 - The coordinates of the corners of a triangle ABC...Ch. 1 - Show that |abc| equals the volume of a...
Knowledge Booster
Background pattern image
Mechanical Engineering
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.
Similar questions
SEE MORE QUESTIONS
Recommended textbooks for you
Text book image
International Edition---engineering Mechanics: St...
Mechanical Engineering
ISBN:9781305501607
Author:Andrew Pytel And Jaan Kiusalaas
Publisher:CENGAGE L
Introduction To Engg Mechanics - Newton's Laws of motion - Kinetics - Kinematics; Author: EzEd Channel;https://www.youtube.com/watch?v=ksmsp9OzAsI;License: Standard YouTube License, CC-BY