Your assigned problem: The channel consists of an unfinished concrete section (n = 0.014) and overflow regions on each side that contain light brush (n = 0.050). If the bottom of the channel has a slope of 0.0015, determine the steady volumetric flow when the depth is 2.5meters. 1m 1.5 m -5 m -5 m 2m

Your assigned problem: The channel consists of an unfinished concrete section (n = 0.014) and overflow regions on each side that contain light brush (n = 0.050). If the bottom of the channel has a slope of 0.0015, determine the steady volumetric flow when the depth is 2.5meters. 1m 1.5 m -5 m -5 m 2m

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A canal transports a flow of 100 m3/s with a depth of 1.5m. This canal is made of concrete (Manning coefficient of 0.012) and has a slope of 0.02%. The cross-section can be found below. www.www 1.5 m B Figure 1 Canal cross-section Q a) Determine the width of the canal (B) if the flow is currently at normal depth. b) A crack in the concrete was recently discovered. Drying up that portion of the canal with the help of a cofferdam has been suggested in order to correct the situation. It has been suggested that this structure be 50% of the width of the canal. What are your thoughts on this? Is this feasible? What are the consequences? You must clearly state your opinion and explain clearly the effects the cofferdam will have on the flow of water in the canal if it is set up as suggested. Take L=0.5*B, where B is your answer found in a) 2.5 m L B Figure 2 Aerial view of canal with cofferdam (dotted line)
A 2.0m diameter concrete pipe on a slope of 0.005 is to carry water at a normal depth of 1.5m. Determine the flow velocity and flow rate Take n=0.014 also determine q when ho=0.75 and h1=1.0m
The asphalt - lined trapezoidal channel carries 300 cfs of water under uniform flow conditions when S = 0.0015. What is the normal depth? Use n = 0.016. bo L 6 ft- Y'n 50°
Please solve correctly.
A welded steel channel (Manning n = 0.015) is rectangular in cross-section, being 1.55m wide, and is laid on a slope 1 in 500. Water flows in the channel with a depth of 1.28m, what is the volumetric flow rate?
An open channel is anticipated to convey 8cumecs of water. The slope of the channel bed is 0.0015. The available construction material is concrete with a Manning's Roughness Coefficient of 0.014. Design the open channel using the best hydraulic rectangular section, best hydraulic triangular section, best hydraulic trapezoidal section, and best hydraulic circular section.
Find a diameter of pipe required to carry a design flow of 0.186 m3/s when flowing partially, d/D= 0.67, slope= 0.4%, n=0.013 3. Calculate Qf
Q2: Design a concrete-lined canal cross section to carry a discharge of 24 cumecs. The longitudinal slope of the canal is 26 cm/km and the side slopes are 1.5:1, The desired bed width-depth ratio is 2.5 , (n = 0.018).
With Explanation Please. Thank Youuu The channel consists of an unfinished concrete section (f = 0.038) and overflow regions on each side that contain light brush (f = 0.050). If the bottom of the channel has a slope of 0.0015, determine the steady volumetric flow when the depth is 2.5meters.
need complete solution. need ASAP. thank you