You open a restaurant and hope to entice customers by hanging out a sign.CableHingeGOOD EATS)LThe uniform horizontal beam supporting the sign is 1.82 m long, has a mass of 17.37 kg, and ishinged to the wall The sign itself is uniform with a mass of 27.89 kg and overall length of 1.43m. The two wires supporting the sign are each 35.44 cm long, are 73.48 cm apart, and areequally spaced from the middle of the sign. The cable supporting the beam is 2.17 m long.What is the magnitude (N) of the Tension on a single wire connected to the sign?

Answered: You open a restaurant and hope to…

Similar questions

You set up a Halloween prank by attaching a small board to a hinge above your front door. The far end of the board is held up by a cable that can be released by remote control. You place a spooky spider on the board that is dropped on unsuspecting trick-or-treaters when you release the cable. The drawing below shows the set-up. cable 40° Hinge 60 ст You use a board that is 60 cm long and the cable makes an angle of 40 degrees with the board when the board is held horizontally. You place the spider a distance of r = 37 cm from the hinge. The board has a mass of 2.2 kg and the spider has a mass of 1.6 kg. The hinge applies both a horizontal force and a vertical force. You will be asked to determine the direction of both of these forces (left, right, up, down). What is the magnitude of the tension in the cable in Newtons? T = What is the magnitude and direction of the horizontal force from the hinge? Enter a positive number for the magnitude. Fh = Direction ---Select--- What is the…
a D1 Sign Dz A 2.20kg pole is attached to a wall with a hinge as shown. A 5.70kg sign is suspended at the other end of a pole, where D, = 3.30m. A cable attached to the wall forms an angle a = 18.0° with the wall, and is attached to the pole a distance D, = 1.40m from the hinge. Assume the origin is at the hinge. What is the torque on
A force stretches a wire by 1.0 mm.a. A second wire of the same material has the same cross section and twice the length. How far will it be stretched by the same force?b. A third wire of the same material has the same length and twice the diameter as the first. How far will it be stretched by the same force?
A uniform beam of length L and mass mB is supported by two pillars located L/3 from either end, as shown in the figure. A duck of mass mD stands on one end. A scale is placed under each pillar. The entire system is in equilibrium. 1.) Enter an expression in terms of defined quantities and g, for the force under scale that the right pillar shows. 2.) Enter an expression in terms of defined quantities and g, for the force under scale that the Left pillar shows. 3.) Enter an expression in terms of defined quantities and g, for the sum of the scale readings.
A young work crew is trying to quickly finish some touch‑up painting to complete a job. Rather than setting up a secure work area, they decide to try a shortcut. Worker A will hold the far end of a 8.00 m work plank which weighs 115 N and is secured with a hinge on the opposite end. Worker B will stand on the plank 4.11 m from worker A. Worker B also brings up his paint can, ?c=3.54 kg, which he places 0.280 m from where he is standing on the plank (between the two workers). Worker A unfortunately needs to supply 496 N of force to hold the end of the plank. How much does worker B weigh? The acceleration due to gravity is ?=9.81 m/s2.
Structural member AB is to be supported by a strut CD. Determine the smallest length CD may have, and specify where D must be located for a strut of this length to be used. Take x= 120 mm. 60 mm D. y 20 mm E The smallest length CD may have is mm. The coordinates of point Dare ( and Imm.
You open a restaurant and hope to entice customers by hanging out a sign. Cable Hinge GOOD EATS I L The uniform horizontal beam supporting the sign is 1.62 m long, has a mass of 14.24 kg, and is hinged to the wall The sign itself is uniform with a mass of 23.07 kg and overall length of 1.49 m. The two wires supporting the sign are each 39.97 cm long, are 14.04 cm apart, and are equally spaced from the middle of the sign. The cable supporting the beam is 4.60 m long. What is the magnitude (N) of the minimum tension must your cable be able to support without having your sign come crashing down?
Sketch the equilibrium position of each item when hung to a wall by their hinge point. ВМЕ 065 OA (C Figure 2. Three items that need to be hung to a wall by a hinge support in A. The center of gravity is in C. For the scissors, neglect that the two halves can move relative to each other.
A 70kg adult sits at one end of a 9.0m long board. Their 23kg child sits on the other end. A. Where should the pivot be placed so the board is balanced (as distance from adult). Ignore the boards mass. B. Find the pivot point if the board is uniform and has a mass of 15kg.