You have been given a solid with a melting range 142-148°C, and you attempt to recrystallize it from isopropanol (propan-2-ol). What type of melting range might you expect if the recrystallization were successful? The melting range would be higher, but about the same breadth O The melting range would be narrower and lower The melting range would be higher and broader The melting range would be broader but otherwise unchanged The melting range would be both higher and narrower

You have been given a solid with a melting range 142-148°C, and you attempt to recrystallize it from isopropanol (propan-2-ol). What type of melting range might you expect if the recrystallization were successful? The melting range would be higher, but about the same breadth O The melting range would be narrower and lower The melting range would be higher and broader The melting range would be broader but otherwise unchanged The melting range would be both higher and narrower

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

What is the equilibrium concentration of N₂ in water that is in contact with air at 25 °C and air pressure 1 atm? The mole fraction of N2₂ in the air is 80 %, and Henry's law constant for N₂ is 6 x 10-4 mol L-1 atm-1. Select the nearest value. O 4.8x 10-3 mg L-1 4.8 x 10-4 mmol L-1 0.6 x 10-4 mol L-1 6 x 10-3 g L-1 6 x 10-4 mol L-1
A 1.250 g sample of bauxite (the primary ore of aluminum) was analyzed for aluminum. The sample was powderized and treated in concentrated nitric acid. The nitric acid was removed and solids were treated in hot water with added nitric acid. Insoluble solids were removed by gravity filtration. The solution was made basic by the slow addition of dilute ammonia forming the gelatinous precipitate (Al(OH), and Al,O,.x H2O). The precipitate was heated to coagulate it then filtered over filter paper. The paper and solids were placed in a porcelain crucible and the paper was ashed while the precipitate was ignited at 600°C to convert the precipitate to pure Al,O,. The mass of Al,O, recovered was 0.2890 g. The average mass of ash after charring 10 sheets of the identical filter paper was 0.0007 g. Calculate the percent aluminum in the bauxite ore sample.
What separation method could you use to separate water from alcohol? * O extraction O fractional distillation sublimation O crystallization
Draw a schematic diagram using this information. Preparation of the solution Take about 25-30 ml of distilled water in a beaker and add powdered crude copper sulphate while stirring the solution so that the powder dissolves. Keep adding the powdered sample till a little of it remains undissolved, even if it is stirred thoroughly. Now add 2-3 ml of dil. H2SO4 to make the solution clear. This prevents the hydrolysis of copper sulphate. Filtration of the solution Take a funnel and fix a filter paper in it and clamp it to a stand. Place a china dish under the funnel. The stem of the funnel should touch the wall of the china dish to avoid the solution splashing out. Pour the solution into the funnel over a glass rod and collect the filtrate in a china dish. The insoluble impurities are left in the filter paper as residue. Concentration of the filtrate to crystallisation point Heat the china dish on a sand bath till the solution is reduced to about one-third of its original volume. To…
Which of the following will have the greatest solubility in water? Which will have greatest solubility in ethyl acetate (an organic solvent)? HO зас Select one: NH₂ منشود III CH₂ a. I in water and IV in ethyl acetate H₂C H₂C HO HO HO OH HO II IV NH
Considering the procedure below: “Determination of the concentration of HCl: Pipette 10 mL of hydrochloric acid and transfer to a 100 mL volumetric flask, complete the volume with water and homogenize. Remove a 10 mL aliquot of this solution and transfer it to a second dilution in a 100 mL volumetric flask, complete the volume with water and homogenize. Take a 20 mL aliquot of this last solution and transfer to a 250 mL erlenmeyr and add 20 mL of distilled water and 4 drops of the acid-base indicator. Titrate with a previously standardized 0.100 mol/L sodium hydroxide solution until the indicator turns.” Answer: a) In this titration, the indicator used is phenolphthalein. Discuss the use of this indicator considering its turning range and pH at the stoichiometric point of the titration. Justify. b) Considering that the volume of titrant used was equal to 24.5 mL, calculate the concentration of HCl in the sample in mol/L.
The substance to be analyzed coloration test gives weakly-violet color. Interaction with concentrated sulfuric acid leads to evolving of reddish-brown gas with pungent odour. Mixing of salt water solution with chlorine water in presence of trichloromethane changes of color of organic layer to orange. is white, highly soluble in water salt. Flame What kind of substance is this? KBr CaCl, SrCl2 KNO,
Please provide detailed solution and give explanation..
CONCLUSIONS: In general, the boiling points of compounds increase down a group in the periodic table. The melting points and boiling points for the hydrogen compounds of group 6A elements are in the table below. Melting Point (°C) Boiling Point (°C) H₂O 0.0 100.0 H₂S -82.0 -60.0 H₂Se -65.7 -41.2 H₂Te -49.0 -2.2 Use your understanding of chemistry to propose an explanation for the anomaly in the trend for the hydrogen compounds of group 6A elements shown in the table.
2 3 5 6 4 The direction of the distilled water is O2 to 9 9 to 2 7 to 5 O 5 to 7 7 8 9
The melting point of benzoic acid is reported in the literature as 122.3°C. What can you deduce if the melting point of the benzoic acid you have prepared is 121.6°? * A- The product may not be benzoic acid. B- The benzoic acid may still contain hydrochloric acid and sodium chloride that have not been washed out. C- The benzoic acid may not have dried completely yet. D- The first three options are all correct. E- The first three options are incorrect.