You are developing a distance measuring system using an analog infrared sensor The response curve of the infrared sensor is shown below Using the MSP432E401Y Microcontroller 12-bit ADC over a voltage range of 0 to +3.3V. Determine what the measured distance is for an ADC digital value of 0XBAE Distance in centimeters (cm) 35 6 qn 5 am 30 8 am 7 an 25 10 an 20 15 an 15 25 am 20 am 10 30 am 50 am 40 am 05 80 am 00 O D0 020 O 05 10 istance (1/m) 0.10 0.15 O 0.10 30 O 0.30 O10 O Insufficient ADC resolution Output voltage (V)

Q: Calculate the offset for the physical address 00062 H and segment address FFFFH,

A: physical address is calculated by shifting the segment address (16-bit) left 4 times and adding it…

Q: Define each of the following terms by giving an example for each term: Static sensitivity Error…

A:

Q: Explain the difference between a digital sensor and an analog sensor. Give an example of each.

A: The output produced by the digital sensor is in bits. The production of a digital sensor is a…

Q: De fine time constant (I) for (R-L) cct.

A: The time constant (τ) for an RL (resistor-inductor) circuit is calculated using the…

Q: A physical output is created when an electrical signal is converted into a physical one in the…

A: Given  A physical output is created when an electrical signal is converted into a physical one in…

Q: The instruction "BTG 0x89,3,1" takes. instruction cycles to execute. If the default RC oscillator…

A: Given data: Instruction is BTG 0×89,3,1 RC oscillator with TOSC=32 μs.

Q: What is a rectifier? 2. How does a diode act as a rectifier? 3. What is the significance of PIV?…

A:

Q: Problem 03.113 - The dc output voltages in the rectifier circuit Consider the rectifier circuit…

A: Given:a rectifier circuit, with, we need to find:DC output voltage V1.

Q: Discuss the evolution of microchip technology and its impact on the field of electronics.

A: We need to discuss the evolution of microchip technology and its impact on the field of electronics.

Q: 1. What is the most common photoresist used in IC photolithography? ( ) a.negative photoresist…

A:

Q: Analog data having highest harmonic at 30 kHz generated by a sensor has been digitized using 6 level…

A: Given data: The highest harmonic (frequency) present in the analog data is fm=30 kHz For the PCM…

Q: The resolution of the ADC unit with the reference voltage value of 3V is set to 8 bits. If the…

A: Consider the given data: The input is 1.67 V The bit is 8 The reference voltage is 3 V

Q: Discuss the evolution of microchips and their significance in modern electronics.

A: Discuss the evolution of microchips and their significance in modern electronics.

Q: What kind of circuits are diodes often used in? 1) Sensor circuits  2) Rectifying circuits 3) New…

A: Rectifying circuits

Q: Figure Q4(a)(1) shows two unit of multiple clock source. Referring to the internal circuit diagram…

A:

Analog to Digital Converters

The analog-to-digital converter (ADC) allows circuits controlled by microprocessors, Arduinos, Raspberry Pi, and various reasonable digital circuits to be connected to the real world. In the real world, analog signals have a continuous stream of information from a variety of sources and sensors capable of measuring sound, light, temperature, or movement, in addition to the many digital systems that interact with their environment by measuring analog signals from those transducers.