You are an entry level engineer in charge of keeping water balance in a water dam which is connected by a pipe to a city.The dam is a 82,02.5 ft by 13,124 ft rectangle. Flow is assumed unsteady and velocity is uniform. Uniform velocity is 8 ft/s. Pipe diameter is 7.5 ft. Density of air is 1.23 kg/m^3 and density of water is 1,000 kg/m^3. what is the law of mass conservation for this situation if air at control surface 1 is neglected.

You are an entry level engineer in charge of keeping water balance in a water dam which is connected by a pipe to a city.The dam is a 82,02.5 ft by 13,124 ft rectangle. Flow is assumed unsteady and velocity is uniform. Uniform velocity is 8 ft/s. Pipe diameter is 7.5 ft. Density of air is 1.23 kg/m^3 and density of water is 1,000 kg/m^3. what is the law of mass conservation for this situation if air at control surface 1 is neglected.

Similar questions

Water is supplied to an office building 30.0 m high through a pipe at ground level. (a) Find the minimum pressure in the supply pipe so that water can reach the top floor of the building. (b)Suppose the pressure in the supply pipe is designed so that water can flow out through a much smaller pipe on the top floor at a speed of 5.0 m/s. Find the pressure in the larger pipe on the ground floor.
Find the pressure difference required between the ends of a 2.00 m long, 1.00 mm diameter horizontal tube for 40° C water to flow through it at an average speed of 4.0 m/s. Water at 40° has a viscosity of 0.7 x 10-3 Pa s. The pressure difference is equal to ______x105 Pa. Recall the equation for volume flow rate with viscosity: Δ?Δ?=??4Δ?8??
Water flows at 1 m/s from a hot water heater, through a 410 kPa pressure regulator. The pressure in the pipe supplying an upstairs bathtub 3 m above the heater is 350 kPa. What’s the speed in this upstairs pipe? (Numerical answer is assumed to be in m/s)
What flows at 0.850 m/s from a hot water heater, through a pressure regulatory at 450 kPa on the ground floor of the house. This same pipe is used to supply water to a bathtub 3.7 m higher in the household at a pressure of 414 kPa. What is the flow speed in the pipe on the same floor as the bathtub?
A sump pump (used to drain water from the basement of houses built below the water table) is draining a flooded basement at the rate of 0.75 L/s, with an output pressure of 1.5×10^5 Pa. (a) The water enters a hose with a 2.8 cm inside diameter and rises 2.2 m above the pump. What is its pressure at this point? (b) The hose goes over the foundation wall, losing 0.55 m in height, and widens to 6.6 cm in diameter. What is the pressure now? You may neglect frictional losses in both parts of the problem.
Water at a pressure of 4.60 atm at street level flows into an office building at a speed of 0.55 m/s through a pipe 4.80 cm in diameter. The pipes taper down to 2.50 cm in diameter by the top floor, 25.0 m above. Calculate the water pressure in such a pipe on the top floor.
Water enters a house from a ground pipe with an inside diameter of 0.02m at an absolute pressure of 4.0 x 105 Pa. A pipe that is 0.01 m in diameterleads to the second-floor bathroom 5.0m above the ground floor. The flowspeed at the ground pipe is 1.5 m/s. Find the following:(a) flow speed on the second floor; and(b) pressure.
Water flows in the system shown below. The flow exits the pipe at a speed of 4.0 m/s.(a). What is the water pressure when it exits the pipe?(b). What is the height of the column of water?
Water at a pressure of 3.85 x 105 N/m2 at street level flows into an office building at a speed of 0.68 m/s through a pipe with a radius of 2.5 cm. The pipe tapers down to 1.4 cm in diameter by the top floor, 18 m above the street. The flow speed is 2.2 m/s at the top floor. Calculate the pressure in the pipe on the top floor.