NOTE: The density of sea water is 1050 kg/m³ Once on land Nemo is placed in a fish tank (filled with sea water). Inside the tank there is a water pump which circulates the water. The water is drawn in through a pipe with a diameter of 0.02m at a speed of 1.7m/s. Calculate the flow rate of water in the pipe. m³/s The pipe then moves up through the tank to the discharge end of the pipe where the water comes out of the pipe. The discharge end of the pipe has a diameter of 0.045m. The flow rate at the pipe discharge is the flow rate at the pipe inlet. Ⓒ Greater Than Less Than Equal to The velocity of water at the pipe discharge is O Greater Than O Less Than Ⓒ Equal to Calculate the velocity of water at the discharge. m/s the velocity of water at the pipe inlet.

NOTE: The density of sea water is 1050 kg/m³ Once on land Nemo is placed in a fish tank (filled with sea water). Inside the tank there is a water pump which circulates the water. The water is drawn in through a pipe with a diameter of 0.02m at a speed of 1.7m/s. Calculate the flow rate of water in the pipe. m³/s The pipe then moves up through the tank to the discharge end of the pipe where the water comes out of the pipe. The discharge end of the pipe has a diameter of 0.045m. The flow rate at the pipe discharge is the flow rate at the pipe inlet. Ⓒ Greater Than Less Than Equal to The velocity of water at the pipe discharge is O Greater Than O Less Than Ⓒ Equal to Calculate the velocity of water at the discharge. m/s the velocity of water at the pipe inlet.

Name: NOTE: The density of sea water is 1050 kg/m³Once on land Nemo is plac
Uploaded: 2024-03-20T06:51:10.000Z
Channel: Bartleby
Description: NOTE: The density of sea water is 1050 kg/m³Once on land Nemo is placed in a fish tank (filled with sea water). Inside the tank there i a water pump which circulates the water. The water is drawn in through a pipe with a diameter of 0.02m at aspeed

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

What is true about the volume of displaced fluid for an object that is completely submerged? (1 Point) The volume of displaced fluid is equal to the object's volume. The volume of displaced fluid is less than the object's volume. The volume of displaced fluid is greater than the object's volume. The volume of displaced fluid is not related to the object's volume.ption 4
If a kitchen sink has a volume of 20 L. Water flows in the sink with a mass flow rate of 0.5 kg/s. If the drain is closed, how long, in seconds, does it take for the sink to fill up? Density of water = 1000 kg/m3
A dam releases water from Its reservoir during a flood season. The water level in the reservoir Is 52.0 m above the exit of water duct at the bottom of the dam. What Is the speed of water at the exlt of water duct?
A large open tank contains water as shown in the figure. The level of the water in the tank is 8 m from the ground while the circular opening in the side of the tank is 1.5 m above the ground. If the discharge rate at the opening is 75 li/sec, determine the diameter of the opening. 1
I got 120 m is this correct?
5.
As shown in the figure below, a hydraulic system has two pistons of different diameter and uses a liquid of density p = 850 kg/m³. The smaller piston has a diameter of 4.7 cm and a mass of 1.6 kg and the larger piston a diameter of 14 cm and a mass of 2.8 kg. Determine h, the height difference between the two pistons. m
A Venturi tube narrows down from the inlet section to the throat. The inlet is 7 ft^2 while the throat area third of the inlet. What is the rate of flow of water when the change in pressure is 0.85 atm? What is the velocity of test and throat section? (English Units) *
Please answer the question
A large tank contains water to a depth of 1.0 m. Water emerges from a small hole in the side of the tank 20 cm below the water level. If the diameter of the hole is 0.50 cm, what is the water flow rate from the hole?
Please help me solve this problem asap. Thank you and god bless!
onlytype