yi = 1.8 m y2 V2 V = 1.25 m/s 20 cm

Q: In what percentage is the flow that carries a wide rectangular channel reduced if its very thin…

A: According to the question We need to explain The flow rate for the above case

Q: Is it possible for subcritical flow to undergo a hydraulic jump? Explain.

A: A hydraulic jump is a transformation from supercritical (flow at higher velocity) flow to…

Q: Problem 6: Water flows uniformly at a depth y₁=40cm in the concrete channel shown, which is 10m…

A:

Q: 5 As shown in the diagram, a weir of the trapezoidal cross section is used to measure the flowrate…

A:

Q: Water flows half-full through a hexagonal channel of bottom width 2 m at a rate of 60 m3/s.…

A: Given data: The width of side of hexagonal channel is a = 2 m The volume flow rate is given as V̇ =…

Q: A rectangular channel with a bottom width of 7 m discharges water at a rate of 45 m3/s. Determine…

A: The data given is, Discharge, Q = 45 m3/s Rectangular channel width, b = 7 m

Q: Consider uniform water flow in a wide brick channel of slope 0.4°. Determine the range of flow depth…

A: Step 1: The channel bed slope (S0) is given as: The roughness coefficient (n) of stream can be…

Q: specific energy for a 3 m wide channel is to be 3 kg-m/kg. What would be the maximu

A:

Q: Water discharges into a rectangular horizontal channel from a sluice gate and undergoes a hydraulic…

A: Write the given data:

Q: Water flows uniformly half-full in a 2-m-diameter circular channel that is laid on a grade of 1.5…

A: Given data: The diameter of the channel is d = 2 m Since, 2r = d The radius of the channel is r = 1…

Q: Water at 10°C flows in a 2-m-diameter circular channel half-full at an average velocity of 2.5 m/s.…

A:

Q: Water is flowing in a 90° V-shaped cast iron channel with a bottom slope of 0.0018 at a rate of 3…

A: Draw the schematic figure. The assumption to be made are, The flow is steady and uniform. The…

Q: How does the pressure change along the free surface in an open-channel flow?

A: Fluids are transported from one position to another using natural or constructed conveyance…

Q: Water flowing in a wide horizontal channel at a flow depth of 56 cm and an average velocity of 9 m/s…

A: The flow depth of channel is y1 56 cm = 0.56 m. The value for average velocity is v1 = 9 m/s.   The…

Q: Consider water flow through a V-shaped channel. Determine the angle ? the channel makes from the…

A: Consider the diagram shown below for the channel as shown below. From the above diagram,

Q: Consider water flow through a wide rectangular channel undergoing a hydraulic jump. Show that the…

A: Given data Flow depth before the jump, y1. Flow depth after the jump, y2. The expression of Froude…

Q: The Blue Ridge Flume, constructed in Shasta County, California, in 1872 to supply water for gold…

A: From the given figure, the height of the flume can be calculated using the figure below and the…

Q: When is the flow in an open channel said to be uniform? Under what conditions will the flow in an…

A: Uniform flow: Uniform flow in the open channel is said when the depth of flow is constant at every…

Q: What is the concept of specific energy in open channel flow, and how is it related to flow depth and…

A: Specific energy is a basic idea in open channel flow that is used to examine how water flows. At any…

Q: Water is released from a 0.8-m-deep reservoir into a 4-m-wide open channel through a sluice gate…

A: Given Data: The depth water is y1 = 0.8 m. The height of gate is a = 0.1 m. The width of gate is b…

Q: What percentage of initial energy is lost in this jump?

A: Given dataF1 = 10The percent of initial energy lost is the ratio of E2/E1

Q: Consider the uniform flow of water in a wide channel with a velocity of 10 m/s and flow depth of…

A: Here,V1=10ms,Y1=0.65 mNow,critical depth,Yc=(V12.Y12g)13=(102×0.6529.81)13=1.627 mBump…

Q: As shown in the figure below, at the entrance to a 3-ft-wide channel the velocity distribution is…

A: The width of the channel, (b)=3 ftThe value of height (h)=0.93 ft.The velocity profile at the exit,…

Q: Water flows in a rectangular open channel with constant channel width at 1 m depth, 0.8 m/s…

A: