X3(s) Determine transfer function F(s) for the system in Figure Q4. Where, M1 = M2 = M3 = Q4 1 kg, K1 = K2 = 1 Nm-1 and C1 = C2 = 1 kgs-1. >X2 >X1 >f(t) X3 M2 C2 C1 K1 K2 M1 M3

Q: True or False: The LENGTHEN command doesn’t work with arcs.

A: While using the LENGTHEN command, the Delta and angle options allows the user to lengthen or shorten…

Q: What is use to clean solutions that eventually become spent and must be disposed of properly

A: Few washers are used to clean solutions. These are given as, (1) Sump pits (2) Car washers (3) Part…

Q: I need parts 5 and 6 answered pertaining to the print and set of sequence of operations.   Note: If…

A: When the operator actuate the two-push button valves (1) and (2) until the weight starts to descend.…

Q: what can be caused by excessive negative caster

A: Solution:

Q: Two techs are discussing oil coolers. Technician A says that when inspecting oil- to-water type…

A: Solution:

Q: Technician A says that the oxygen sensor provides the major input during the open-loop…

A: There are two modes of operations for the engine: (1) Open loop mode: In this mode, no feedback is…

Q: Help

A: In first angle projection, the top view should be oriented below the front view , but in the asked…

Q: Explain why a screen buffer is necessary for the control pan

A: The buffer is the area in which the data is stored. The date stored in the buffer area is always…

Q: What rating is used for hearing protection devices? Noise reduction rating O Canister Color Code…

A: Hearing protection devices are used to protect the ears from the noises generated due to the working…

Q: Why should a technician not file the rough surface on the contractors contacts

A: Solution:

Q: Match the following in the right order

A: Given below solution Explanation:Step 1: Step 2: Step 3: Step 4:

Q: What kind of detergent do you use with a sc8000 industrial automatic scrubber/sweeper?

A:

Q: True or False? Safety of the material handling process should be determined after the system is put…

A: The safety of material handling process should be determined after the system is put in place and…

Q: What is meant by 'sensor bias voltage' and how is it used in an engine management system? (70-100…

A: It is asked to write about sensor bias voltage and its working

Q: Lockout locks: Can be used to lock tool boxes, storage sheds, etc. Can be used only for lockout…

A: Lockout locks are used to lock out machinery or area until maintenance is completed. They are not…

Q: Which of the following is NOT a Mechanical Engineering Student Shop safety rule? Wear open shoes Put…

A: Which of the following is NOT a Mechanical Engineering Student Shop safety rule?   A) Wear open…

Q: True or False: Objects must actually touch each other for the TRIM command to work.

A: The TRIM command is a tool in AutoCAD software which is used to eliminate or cut off any selected…

Applied Fluid Mechanics

A fluid is a substance that is continuously deformed by the application of shear stress. The rate of deformation of a fluid depends on its viscosity. The fluid tries to flow when it interacts with some other system.