Unbalanced Connected Loads WYEGiven: ZA= 11-j10.22ZB13+j122Zc 15 tj 14.2::V₂ 360+ Phase sequenceVAB"360 10 VУвс = 3602-120 VVCA = 360 2120 VCS Scanned with CamScannerZABTO(30A)FindsFind:DELTAZAB(2-BC)IA, IB, ICApparent Power ineach Phase (SA, SB, SC)2CP

Given: Consider the following figure: ZA=11-j10 ΩZB=13+j12 ΩZC=15+j14 Ω Line voltage: VL=360 V…

WYE TO (ZAB Given: ZA= 11-j10.22 ZB 13+j12_2 2 Zc : 15 tj 142 : VL 360 + Phase sequence VAB - 360 LOV Увс : 3602-120 V VCA 360 2120 V ? DELTA ZAB Finds IA, IB... Find: ZCP (2BC) Ic Apparent Power in each Phase (SA, SB, SC)

WYE TO (ZAB Given: ZA= 11-j10.22 ZB 13+j12_2 2 Zc : 15 tj 142 : VL 360 + Phase sequence VAB - 360 LOV Увс : 3602-120 V VCA 360 2120 V ? DELTA ZAB Finds IA, IB... Find: ZCP (2BC) Ic Apparent Power in each Phase (SA, SB, SC)

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: A series of 3 load centers are supplied from a single generator. A simple current grading protection…

Q: cable consists of braided copper and covered two pair conductors with shield.

A: STP cable consists of braided copper and covered two pair conductors with a 22AWG shield.

Q: is used to prevent debris in the hydro power plant. Tunnel O Penstock Surge tank Trash rack

A: Trash-racks have been installed in the hydropower plant system to prevent the entry of large debris…

Q: What is the approximate value of surge impedance of a power cable ? 400 100 40 1600 A Moving to…

A: Surge impedance is defined as the square root of ratio of line impedance Z and shunt admittance Y is…

Q: 73. The full-load copper loss of a trans¬former is 1600 W. At half-load, the copper loss will be

A: —

Q: For the system shown in Fige, a 3-phasefault Loccurs at the beginning ofT.L. Determine 1.…

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub parts for…

Q: 2. Unbalanced delta connected load has a. Symmetric Current b. A symmetric current c. Infinite…

Q: If all the sequence voltages at the fault point in a power system are equal, then the fault is a…

A: When all the sequence voltages at the fault point in a power system are equal, then the fault is a…

Q: When a loaded generator is supplying power to a motor, a balanced 3-ph fault occur at the terminals…

Q: < Back The results of a short may include: O High voltage drop O A motor that turns slowly O A…

A: A short circuit means that two nodes of an electrical circuit are joined by zero resistance (very…

Q: 5. Current on phaser diagram of unbalanced Y- connected load has a. No symmetry b. Symmetry c.…

A: given statement about unbalanced star load

Q: Calculate the fault current in each phase for a L-G fault occurs at machine-2 for the system shown…

A: Given- Sequence Positive Negative Zero Generator 0.16j 0.17j 0.06j Transformer-1 0.1j 0.1j 0…

Q: Using a system voltage of 13,800V calculate the fault current for a three phase fault at Point B on…

Q: In which portion of the transmission system is the occurrence of faults more common a alternator B…

A: Answer:C transmission line

Q: 3-phase fault is the severe fault among all other faults True False

A: Choose the correct option Is it true or false The given Statment "3 phase fault is severe fault…

Q: 12 - Which of the following power plant is based on wave energy? a. Off Shore System b. All of…

A: Off shore system and on shore system are based on wind energy.

Q: 3. What significance has power factor in an unbalanced system?

A: The objective is to determine the effect on power factor in the unbalanced power system.

Q: A 100 MVA, 20 kV alternator has X1 = X2 = 0.20 pu and Xo = 0.05 pu. The neutral of the generator is…

A: The above question is based on fault analysis.Please note that all the options are wrong here as…

Q: what would be the minimum size feeder conductor THHW 75 degrees for four 30- amp motor generator arc…

A: To find minimum size feeder conductor THHW 75 degrees motor generator arc welders = 4 numbers , 30…

Q: Explain briefly why is there no wattmeter reading when the load is purely capacitive.

Q: The neutral current in an unbalanced star connected system is not equal to

A: Neutral current in an unbalanced star connected system

Q: What are the faults on this pole?

A: Basically There are 3 phase wire passing through the pole. So there may 3 phase symmetrical fault, 3…

Q: The terminal voltage of shunt generator is 220 V when the load current is 5 A. If the load current…

A: In shunt generator emf induced is almost constant as speed is constant. Terminal voltage =…

Q: The one line diagram of the system and data: Gl and G2:reactance=0.2 p.u ,11kv, 100MVA T1 and T2:…

A: Fault analysis- Transmission line are represented using series reactance. So, series resistance of…

Q: Two generators operated in parallel in a generating station, as generator A has 20 KVA, 20KV, 5% ,…

Q: A 3-phase motor is rated at 100VA 0.9pf lag when operated with 100V 60Hz. The motor must be operated…

A: The 3ϕ system can be drawn as Based on the rating of the Motor, the line current drawn by the motor…

Q: 11 To increase the voltage in the system, :the modules are connected in (ähäi 2) .Series .Parallel

A: Given, To increase the voltage of the system, the modules are connected in ____.

Q: what is the value of phase current in a balanced star connected system a. is equal to line…

A: As we knows that in In balanced delta or start circuits, the line voltage is equal to phase voltage,…

Q: 3. For the network shown below, a balanced fault occurred at motor (M) terminal. Calculate the fault…

Q: Two shunt generators A and B, with ratings of 250 and 400kW respectively having equal no-load…

Q: The reading of ammeter A1 is____ A.The reading of ammeter A2 is____ A. The reading of ammeter A3 is…

Q: why is there two types of coaxial cables ones with an Impedance 75 ohm (r) and ones with Impedance…

A: Coaxial cables:- A form of copper cable known as coaxial cable is specifically designed with a…

Q: In wattmeter, the coil connected in parallel is called.........................................?

A: In wattmeter, the coil connected in parallel is called

Q: a. True b. False Q3/A: For the power system shown, calculate fault current and when a 3-phase fault…

Q: Find the fault current in both generators and in the engine for a three -phase failure In the middle…

A: To find the fault current in both generators and the engine, as well as the voltages in nodes 1 and…

Q: Question 6 Which of the following has the highest percentage of occurrence in a power networl L-L…

A: In this question , we will find which fault has highest percentage of occurrence...

Concept explainers

HVDC

HVDC stands for high voltage direct current in the electric power transmission system. The high voltage direct current system uses direct current (DC) for the transmission of electrical power through transmission lines in contrast with the alternating current that is the AC system. The HVDC is used to transmit bulk power point-to-point through long distances transmission lines. Power is rapidly transferred because the efficiency of transmission lines is greatly increased over long distances due to HVDC lines.

Question

Unbalanced Connected Loads

WYE
Given: ZA= 11-j10.22
ZB
13+j122
Zc 15 tj 14.2
:
:
V₂ 360
+ Phase sequence
VAB
"
360 10 V
Увс = 3602-120 V
VCA = 360 2120 V
CS Scanned with CamScanner
ZAB
TO
(30A)
Finds
Find:
DELTA
ZAB
(2-BC)
IA, IB, IC
Apparent Power in
each Phase (SA, SB, SC)
2CP

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

In distribution substation, the shunt compensation used is of in nature.
What is the impact of a fault at Location A to Location B? ..
A redundant part or component increases reliability because it is connected in parallel, not in series. Question 40 options: True False
Give two points to compare the co-current versus counter-current flow arrangement
S7
Need to validate my answers for item 1
I want the solution in the form of a list and quickly I need it
q10
In a three phase -four wire star connected system, the three outer wires are called as lines and the common wire in centre is called as to search hp
3. Machines 1 & 2 --- 100 MVA, 18 kV, X"=X2=0.3, Xo= 0.07 pu Machine 2 Xn = .1 pu Transformers ------ 100 MVA, 20-345Y kV X=0.1 pu Line 2-3 z1=1+j120 ohm zo= 2+j300 ohm Machine 1 Kary 1 T₁ 2 2013 FY-Y (3) T₂ TO A A. Develop a base table with a 100 MVA, 345kV base in the Line. Machine 2 Kroooy
A DC generator has the following magnetization characteristics taken at 600 rpm. Field 1 2 3 4 5 7 Current |(A) Generated emf (V) 18 23 45 67 85 |100 112 121|126 If the generator is shunt excited, determine the load current. a.) when terminal voltage is 120 V ,field resistance is 15 ohms at 600 rpm. b.) when terminal voltage is 144 V, field resistance is 18 ohms at 700 rpm.
Which of the following is not a boundary condition for an SLG fault on phase 'a' of a power system?