Two shunt generators A and B, with ratings of 250 and 400kW respectively having equal no-load voltage of 260V and full load voltage of 240V, calculate the load of each when the total load shared is 600kW. 231kW and 369kW 238kW and 362kW 242kW and 358kW 234kW and 366kW

Q: For the system of Problem 9.11, compute the fault current and voltages at the fault for the…

A: Types of faults at 'F' are a) Single line to ground b) Line to line through fault impedance c)…

Q: R B Y R 400V, 60Hz IR Ze=550° Figure 4: Star Unbalanced Load IR ZR Is ly Zx ZR = 30 < 0° 0 Fault…

A: A balanced load refers to a situation in an electrical system where the connected loads are evenly…

Q: In the system shown in Figure 1, the transformers are connected star-star with both star points…

A: In this question we need to find the load current in per unit value

Q: Three phase power supply load R is 1699 VA, S is 15584 VA and T is 12818 VA. Find (a) the…

A:

Q: When a loaded generator is supplying power to a motor, a balanced 3-ph fault occur at the terminals…

A:

Q: EMF/turn is constant for both primary and secondary windings. Select one: O True O False

A: Choose the correct option Emf/turn is constant for both primary and secondary winding.  Is it true…

Q: Generator Load I Load 2

A:

Q: For the following schematic, if a double-line ground fault occurs at node 5, calculate the currents…

A: The single-line diagram of the power system is given as For fault analysis, we consider only the…

Q: MEASUREMENT RESULTS ENERGY ANALYZER PARAMETERS Uu lu U (phase-phase) cosi Hz AND there is (dev /…

A: Concept: The variation of terminal voltage with load power factor for an alternator is given by the…

Q: EXe A loo KvA transformer has y00turps on tHe Primary and & tuang on tHhe secondary. Th polay and…

A:

Q: 5. Obtain the symmetrical components of a set of unbalanced currents I-1.7 25°, I,=0.761800 and…

A: In this question we will find symmetrical components of current...

Q: Power transformers are used in the power system to change the voltage levels to a level suitable for…

A: We are authorized to answer three subparts at a time. Since you have not mentioned which part you…

Q: Problem 4: A three phase motor draws 30 kVA at 0.80 power factor lagging from a 480 V three phase…

A: The data are given as KVA ratingS1=30kVA,Power factorpf1=cosϕ1=0.8 laggingso, ϕ1=36.87°.1) Without…

Q: Plant A - 150kVA, 0.68pf lagging Plant B - 70kVA, 0.65pf lagging It is desired to correct the power…

A:

Q: 1) IAB 1.6 -30° A - A Delta/Wye connected 600v/120v transformer has the following primary phase…

A: Given:IAB​=1.6∠−30°AIBC​=1.9∠105°AICA​=1.2∠252°A1. Finding the Primary Line CurrentsFor a Delta…

Q: If the core loss of single phase transformer at full load is 316 W, then the core loss at 50% of…

A: If the core losses of single phase transform at full load = 316W Find the losses at 50% load?

Q: Assume the source is Wye connected and the phase voltages are 2kV. What is the phase to phase…

A: phase voltage- Phase Voltage is measured between an individual phase and Ground. Where line voltage…

Q: * Two generators, rated at 100 MW and 400 MW, are supplying power to a network. The system frequency…

A: we need to tell the value of droop R of the 100MW generator.

Q: Please answer this exrcise with equations

A: General formula for 3-phase transformer:

Q: Two generators operated in parallel in a generating station, as generator A has 20 KVA, 20KV, 5% ,…

A:

Q: Obtain the symmetrical components of a set of unbalanced currents Ia=1.28ے250, Ib=0.567ے1800 and…

A:

Q: The reactance of a generator is given as 0.55 pu based on the generator of 21 KV, 350 MVA. Determine…

A:

Q: A 3.3kV, star connected alternator has a transient reactance of 1Ω per phase and negligible winding…

A:

Q: two transformers A and B operate in parallel on both sides. their ratings are as follows: KVA…

A: Note: Since the impedance for both transformers are given in ohms so these are the actual…

Q: Single phase transformer has 24KVA, 2400/240, 50 Hz. Its series impedance Z, 0.15+j0.6pu connected t…

A:

Q: Can you explain regarding shunt reactor and shunt capacitor?

A: Shunt Inductive reactor  Inductive reactor absorbs lagging VAR and supplies leading VAR. The…

Q: 16 test which do to find the value of stater winding losses (Rs) in * synchronous generator DC test…

A: To find the stator winding losses in the synchronous generator can be found by using the DC…

Q: In class B chopper, which of the given statement is true The power flows always from load to source…

A: The power flows always from load to source

Q: Problems: Fl- A 500 V dc generator supplies a load 800 A at point A through 0.025 2 distributor and…

A: Let the required current be i 500-VA0.025=800+i⇒i=500-VA0.025-800

Q: /hat is effect of reverse polarity of a DC generator if it is paralleling with other generator? ттT…

A: effect of reverse polarity of a DC generator if it is paralleling with other generator

Q: Three single phase loads are connected to the 400 V, three phase lines, 60 Hz. Load 1 operating at 3…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: 2. Does the external chara. of series generator represent its load chara? Why? 3. What is the…

A: According to the Bartleby guidelines its a multipart question so we have to solve only one question.…

Q: 72. In 132 kV system, the phase to ground ca- pacitance is 0.01 µF and inductance is 6H. The voltage…

A:

Q: If the core loss of single phase transformer at full load is 124 W, then the core loss at 50% of…

A: Given Data: Core loss = 124 V percentage loading x = 50%

Q: if the core loss of 1 phase transformer at full load is 124 W, then the core loss at 50% of load is…

A: The core loss of 1 phase transformer at full load is 124 W  P = 124 W    Note :  Since the core…

Q: *11-2 A generator supplying an unbalanced load measures the following phase-to-ground voltages: V, =…

A: Whenever there is any kind of fault occurs in a three-phase system, all the phases are unbalanced in…

Q: A three phase power system has a fault level of 500 MVA and Sg = 100 MVA at a 132 kV busbar. What is…

A: Given, A three phase power system has SB=100 MVAVB=132 kV Fault level is 500 MVA.

Q: The maximum size overcurrent device for primary only protection of a three-phase 75 kVA transformer…

A:

Q: transformer losses and exciting current are neglected, the transformer series reactance is .06 p.u…

A: Subtransient reaction engine reaction during the first short-circuit cycle. Temporary reaction…

Q: I need answers ASAP please

A: Positive sequence network-

Q: A 15-kv, 35-kVA 076PF laggny 50H2 four Pole y-connected Steaw- turbine genevuty has a Synchronons…

A:

Q: If the core loss of single phase transformer at full load is 318 w, then the core loss at 50% of…

A: Core losses are eddy current losses and hysteresis loss  Given full load core loss as 318W  When the…