Words: Backlash, Bearing, Combined, Cup, Dial, Gearset, Housing, Indicator, Position, Record, Shims, Spacers, Thickness, Tighten 1 Measure the ________________ of the original side bearing preload shims. 2 Install the differential case into the ________________. 3 Install service ________________ that are the same thickness as the original preload shims between each bearing ________________ and the housing. 4 Install the bearing caps and finger ________________ the bolts. 5 Mount a dial ________________ to the housing so that the button of the indicator touches the face of the ring gear. Using two screwdrivers, pry between the ________________ and the housing. Pry to one side and set the dial indicator to zero, then pry to the opposite side and ________________ the reading. 6 Select two shims with a ________________ thickness to that of the original shims plus the indicator reading, then install them. 7 Using the proper tool, drive the shims into ________________ until they are fully seated. 8 Install and tighten the ________________ caps to specifications 9 Check the backlash and preload of the ________________. Check the backlash by holding the input pinion, rocking the ring gear, and noting the movement on the ________________ indicator. Adjust the shim pack to allow for the specified backlash. Recheck the ________________ at four points equally spaced around the ring gear
Words: Backlash, Bearing, Combined, Cup, Dial, Gearset, Housing, Indicator, Position, Record, Shims, Spacers,
Thickness, Tighten
1 Measure the ________________ of the original side bearing preload shims.
2 Install the differential case into the ________________.
3 Install service ________________ that are the same thickness as the original preload shims between each
bearing ________________ and the housing.
4 Install the bearing caps and finger ________________ the bolts.
5 Mount a dial ________________ to the housing so that the button of the indicator touches the face of the
ring gear. Using two screwdrivers, pry between the ________________ and the housing. Pry to one side and
set the dial indicator to zero, then pry to the opposite side and ________________ the reading.
6 Select two shims with a ________________ thickness to that of the original shims plus the indicator reading,
then install them.
7 Using the proper tool, drive the shims into ________________ until they are fully seated.
8 Install and tighten the ________________ caps to specifications
9 Check the backlash and preload of the ________________. Check the backlash by holding the input pinion,
rocking the ring gear, and noting the movement on the ________________ indicator. Adjust the shim pack
to allow for the specified backlash. Recheck the ________________ at four points equally spaced around the
ring gear.
Step by step
Solved in 2 steps
