Answered: Why is the strain the fundamental…

Related questions

Question

Why is the strain the fundamental property but not the stress?
a) Because it is dimensionless
b) Because it is a ratio
c) Because it’s value is calculated in the laboratory
d) No stress is the fundamental property

Expert Solution

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Similar questions

Q2- A biological tissue underwent tensile tests, subjected to the axial load P. a) Determine the average normal (ơ) and average shear stresses (t) acting over area section shown below(A'), which is oriented at angle 0 from the horizontal, as a function of 0 and vertical cross section A. b) Determine angle 0 where o=3 t. (24 points) A'=A/sin0 P 01 A (Results: o =- (sine)²,t = - sin0 cose,0 = 71.56°) %3D A А
Help me please!
7. Carbon steel is tested in uniaxial tension, as shown in the inset schematic, to produce the following stress-strain diagram. 600 500 MPa 600 g 400 400 300 200 200 100 0.005 0.05 0.10 0.15 Strain E Figure 1: Stress vs. strain for plain carbon steel. Note: the inset shows the initial portion of the data, magnified for clarity. a) From the Figure 1, determine the following material properties: (i) elastic modulus, E, (ii) ultimate tensile strength, UTS, (iii) yield stress, oy. b) Label the following regions or points on the figure: (i) fracture point, (ii) plastic region, (iii) elastic region. 8. You wish to design a new bone screw used to hold fractured bone segments together or to hold implants in place. Describe what type of material you would use and what considerations you need to make. 27°F Cloudy Stress (MPa) a

Why is the strain the fundamental property but not the stress? a) Because it is dimensionless b) Because it is a ratio c) Because it’s value is calculated in the laboratory d) No stress is the fundamental property