Which of the following should not be done when using the fume hoods?A Work in the fume hood while the hood door is open.B Never place your face inside of the fume hood.c) Set the equipment and chemicals at least 6 inches back from the hood door.Turn on the hood air flow before beginning an experiment.

Answer - The correct option is (a) When doing work in hood, its door should not be open. It should…

Which of the following should not be done when using the fume hoods? A Work in the fume hood while the hood door is open. B Never place your face inside of the fume hood. Set the equipment and chemicals at least 6 inches back from the hood door. (D) Turn on the hood air flow before beginning an experiment.

Which of the following should not be done when using the fume hoods? A Work in the fume hood while the hood door is open. B Never place your face inside of the fume hood. Set the equipment and chemicals at least 6 inches back from the hood door. (D) Turn on the hood air flow before beginning an experiment.

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

4. In which step does the liquid in the system become a low-pressure gas? a. Step 1: Compressor b. Step 2: Condenser Coil C. Step 3: Expansion Valve Step 4: Evaporator Coil d.
Melting point start 54 and stop 59. was your product pure?
what (if anything) should you do with your Bunsen burner before going outside?
List the manipulations where mechanical loss of product could have occurred.
The temperature is 78°F and the dewpoint is 59°F. Find the ratio of vapor pressure to the saturation vapor pressure of air.
Match each item below to its location/purpose.
help please answer in text form with proper workings and explanation for each and every part and steps with concept and introduction no AI no copy paste remember answer must be in proper format with all working
A lower and/or broader melting point range for a compound after recrystallization most likely results from ________. insoluble impurities such as dust or lint the material still being wet with the recrystallization solvent the compound decomposing in the heated solvent the compound undergoing a chemical reaction with the solvent