Which of the following indicates the correct rms value of the diode current for a 1-o full bridge diode rectifier supplied by a source voltage of 220 V, 60 Hz? The value of load resistance is 20 2 (assuming large inductance for maintain constant load current). (a) 9.90 A (b) 7.0 A (c) 4.95 A (d) 11 A

Which of the following indicates the correct rms value of the diode current for a 1-o full bridge diode rectifier supplied by a source voltage of 220 V, 60 Hz? The value of load resistance is 20 2 (assuming large inductance for maintain constant load current). (a) 9.90 A (b) 7.0 A (c) 4.95 A (d) 11 A

Electric Motor Control

10th Edition

ISBN:9781133702818

Author:Herman

Publisher:Herman

Chapter59: Motor Startup And Troubleshooting Basics

Section: Chapter Questions

Problem 12SQ: How is a solid-state diode tested? Explain.

See similar textbooks

Similar questions

What is the difference between a diode and rectifier?
How is a solid-state diode tested? Explain.
What is CEMF?
In a full wave rectifier circuit involving double diodes, a sinusoidal input signal of the following nature is applied e=10 sin(500*pi*t) V. What will be value of the dc voltage obtained at the output of the rectifier.
Solve using hand calculation
Draw the input waveform and output waveform for the circuit given below with proper values marked in the figure. Assume D1 as germanium and D2 as silicon diodes. Input Vpp%3D20V, V1=3 V and V2=10 V. R D2 D1 Vin Vout V1 V2 Maximum voltage of output waveform Minimum voltage of output waveform Ps
5-For single phase half-wave controlled rectifier with a freewheeling diode connected across the inductive load, the supply voltage is 220V (RMS). The mean value of the output voltage for a=45 is: 100.7V 70.9V 84.5V 6-For fully controlled single phase bridge rectifier with inductive load (R=102, L=50mH), F=50HZ and a=45', the load current is: Continuous discontinuous verge continuous 7-Fully controlled three phase bridge rectifier circuit is supplied through delta-star transformer. For highly inductive load, the waveform of the line supply current (primary line current of the transformer) is: Square quasi-square six- step
True or False. Please explain. thank you As the temperature increases, the forward voltage decreases in a silicon diode. Then, the graph of the forward bias region will shift to the left.
Draw the changes in Vi and Id of the ideal diode half-wave rectifier circuit in the figure. The frequency of the sine signal here will be taken as 50Hz. (Changes in Vi and Id will be drawn!!!)
3 Given the bridge-type full-wave rectifier circuit shown 220V 60Hz 220V:Es Es D1 D2 D3 D4 The load resistor is 220 and the transformer average current is 300mA. Determine: (a) Average value, RMS value, and frequency of load voltage VRL. (b) Average current and PIV of each diode. RL
Please answer in typing format solution please only Please answer in typing format I will like it please thanks
9. A Center-Tapped Fullwave Rectifier (CTFWR) has an input AC voltage of 10V with a 2kOhm load resitor. The diodes (D1 & D2) used are both Si. D1 is forward biased during positive half cycle while D2 is forward biased during negative half cycles.