Which of the following can be used as mobile phase in chromatography? А) Нехаne B) Sand C) Acetyl Ferrocene D) Alumina O A OB OD Ferrocene and acetyl ferrocene can be separated by column chromatography. - Which physical property is underlying concept for this separation process? A) Boiling point B) Melting point C) Relative polarity D) Refractive index A OB OD

Which of the following can be used as mobile phase in chromatography? А) Нехаne B) Sand C) Acetyl Ferrocene D) Alumina O A OB OD Ferrocene and acetyl ferrocene can be separated by column chromatography. - Which physical property is underlying concept for this separation process? A) Boiling point B) Melting point C) Relative polarity D) Refractive index A OB OD

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

In chromatography, it is desirable to increase the resolution. a) increase the plate height (H) b) decrease the plate height (H) c) decrease the number of plates (N) to
In chromatography the concentration of a separated compound is directly related to a) stationary phase concentration b) absorbance c) wavelength d) peak area
You use paper chromatography to separate the following two molecules. The stationary phase is coated with hexane C6H14 and the mobile phase is water. Which molecule will travel furthest up the paper? Explain using intermolecular forces between molecule and water. OH OH Phenol Napthol
QUESTION 5 In a chromatographic separation using a polar stationary phase and a mobile phase composed of 60% hexane and 40% ethyl acetate, two compounds, benzene (peak A) and toluene (peak B), are eluted. The width of peak A at its base is 1.2 min, the width of peak B at its base is 1.3 min, and the retention time of peak A is 5.2 min and peak B is 3.5 min. What is the resolution (Rs) between these two peaks and is it acceptable? R = 1.36. It is not an acceptable resolution. R = 0.74. It is an acceptable resolution. R = 1.36. It is an acceptable resolution. R = 0.74. It is not an acceptable resolution.
percentage purity of an ibuprofen sample was determined by a reversed phase HPLC method as follows: Y Der ● A calibration curve of peak area versus concentration (ug/mL) of pure ibuprofen was constructed The ibuprofen sample for analysis was prepared by taking 10.0204 g of powder and dissolving it in/1Lbf distilled water (solution A). 1 ml of the latter solution was further diluted to IL with distilled water (solution B). Solution B was analysed by HPLC analysis Results The equation for the best-fit line of the calibration curve is: y=26820x-1323.8. ● The average peak area for the ibuprofen sample (solution B) was 266796.2 Calculate the percentage purity of the ibuprofen powder.
Which is correct? Random errors affect accuracy and systematic errors affect precision. An accurate result shows agreement with the true or accepted value. Precise results can contain significant random error, but little systematic error. The standard deviation is a good measure of accuracy. Polydimethylsiloxane (PDMS) stationary phases have low polarities. Which of the following statements is TRUE about gas chromatography using PDMS stationary phases? The gas chromatography column is typically packed with silica microparticles. An oven is used to control the column temperature because a constant temperature is always needed in gas chromatography Octane (C8H18, boiling point: 126 ºC) is eluted later than dodecane (C12H26, boiling point: 216 ºC) 3-Pentanone ((C2H5)2CO, boiling point: 102 ºC) is eluted later than propanol (CH3CH2CH2OH, boiling point: 97 ºC)
You run the chromatography system with paper as the stationary phase and 70% isopropanol as the mobile phase. You determine the Rf of a polar analyte to be 0.40. If you use 100% isopropanol (a less polar solvent) instead of isopropanol as the mobile phase what would you expect to happen to the Rf value? No value effect on Rf higher lower could be higher or lower
A young researcher set out to develop a method for quantifying the polycyclic aromatic hydrocarbon (PAH) content in a contaminated soil sample using open tubular gas chromatography. During the initial stages of method development, the researcher was unable to separate the early eluting compounds, anthracene and naphthalene, with baseline resolution. Select the possible modifications the researcher could make to improve the resolution. use a column with a smaller inner diameter decrease the column length increase the stationary phase thickness increase the temperature choose a different stationary phase
A quality-control laboratory analyzes a product mixture us-ing gas-liquid chromatography. The separation of components ismore than adequate, but the process takes too long. Suggest twoways, other than changing the stationary phase, to shorten theanalysis time
Please create a caption for this table. Solution NaCl Conc. (%) Osmolality (mOsm) % transmittance Absorbance % hemolysis % crenation C distilled 0 0 0.001029 4.987584625 100 0.03354 1 0.177179111 54.61 0.001551 4.809388202 96.42720001 0.05837 2 0.297126222 91.58 0.01012 3.994819487 80.09527231 0.08444 3 0.442542222 136.4 3.849 1.414652089 28.3634704 0.134 4 0.590164444 181.9 64.8 0.188424994 3.777880643 0.2125 5 0.74752 230.4 95.64 0.019360433 0.388172513 0.3368 6 0.89644 276.3 99.56 0.001915112 0.038397585 0.5336 7 1.095648889 337.7 99.98 8.68676E-05 0.001741676 0.9834 8 1.336711111 412 100 0 0 2.1 9 1.755568889 541.1 100 0 0 7.9 10 2.674395556 824.3 100 0 0 57.83 11 4.490211111 1384 100 0 0 99.72
You are analyzing the volatile liquids in charcoal lighter fluid. Which type of chromatography would be the best choice? Ion Exchange Thin Layer Gas HP Liquid Size Exclusion
In which mode of chromatography do solute and solvent molecules compete to interact with functional groups on the surface of the stationary phase? a) extraction b) partition c) absorbance d) adsorption