Which of the following best describes a catalyst? O It increases the number of collisions between reacting molecules. O It makes the reaction more endothermic. O It provides an alternate pathway with a lower activation energy. It makes the reaction more exothermic.

Which of the following best describes a catalyst? O It increases the number of collisions between reacting molecules. O It makes the reaction more endothermic. O It provides an alternate pathway with a lower activation energy. It makes the reaction more exothermic.

Physical Chemistry

2nd Edition

ISBN:9781133958437

Author:Ball, David W. (david Warren), BAER, Tomas

Publisher:Ball, David W. (david Warren), BAER, Tomas

Chapter6: Equilibria In Single-component Systems

Section: Chapter Questions

Problem 6.44E

See similar textbooks

Similar questions

This yiaph shows how the vapor pressure of three liquids varies with temperature: 900 800. 700. 600 500. 400. 300. - isobutyl alcohol - ethylbenzene - pyridine 200. 100. 100 110 130 140 temperature, °C Use the graph to answer the following questions: most volatile: choose one Which liquid is the most volatile? Which is the least volatile? least volatile: choose one isobutyl alcohol: |°C What is the normal boiling point of each liquid? Note: your answer must be within 1°C of the exact answer to be graded correct. ethylbenzene: °C pyridine: Suppose a beaker of ethylbenzene is put inside a sealed tank containing ethylbenzene gas at 115. degree C and 557. torr. After ten minutes, will there be more liquid in the beaker, less liquid, or the same O more O less O the same amount? vapor pressure, torr
Sketch graphs of total vapor pressure versus the mole fraction of two volatile substances that show (a) positive deviation from Raoults law. (b) negative deviation from Raoults law. (c) a maximum boiling azeotrope. (d) a minimum boiling azeotrope.
In the distillation of a pure substance (e.g., water), why does all of the water not vaporize at once when the boiling point is reached?
as A certain substance has a heat of vaporization of 61.92 kj/mol. At what Kelvin temperature will the vapor pressure be 6 times higher than it was at 297K ? T = Only typed solution
Give clear handwritten solution- What is the normal boiling point of this compound? (Using phase diagram given)
Dynamic equilibrium can be defined as O rate of dissolution rate of dissolving rate of condensing > rate of bubbling rate of dissolution = rate of recrystallization. rate of dissolution > rate of recrystallization.
Based on the given diagram The green broken line defines the pahse diagrma of solution Shows the increase of boiling boiling point of the solvent when in solution Shows a phase diagram of another solvent Shows a lower freezing temperature of solvent in solution only I is correct All are correct I, III, IV is correct I, II and III is correct
What type of solid-liquid extraction is done when the tea leaves is boiled in water?
1) What will happen to a sample of XY if you start at (12 atm, 200 °C) and increase t pressure at constant temperature to 35 atm? 2) If this compound is polar, at what temperature and pressure would you chose to dissolve a small amount of this compound in water? Why?
The figure below describes the temperature-composition relationship of toluene (bp 111°C) and acetone (bp 56°C) solution. Use the information indicated on it to answer question 12. 111°C A. 16% toluene B. 54% toluene C. 70% toluene D. 84% toluene E. 90% toluene toluene L1 V1 L2 0.1 0.2 L3 V2 L4 V3 L5 V4 0.3 0.4 0.5 0.6 mole fraction of acetone V5 L6 L7 0.7 0.8 0.9 56°C acetone 12. Assume that you are provided with an 18 cm fractionating column having an HETP of 6 cm to distill a mixture of 70 % toluene and 30 % acetone. What would be the composition of toluene in the first drop of distillate?
When dissolving an ionic solid in water, dynamic equilibrium is reached whenGroup of answer choices rate of evaporating < rate of bubbling. rate of dissolution < rate of recrystallization. rate of dissolution > rate of recrystallization. rate of dissolution = rate of recrystallization. rate of condensing > rate of dissolving.
Calculate the quantity of lime and soda required for softening one million litre of the following sample of water. If the purities of lime and soda are 80% and 85% respectively. The impurities are Silica = 75 mg/lit. MgCl2 = 19 mg/lit. MgSO4 = 30 mg/lit. CaSO4 = 68 mg/lit. MgCO3 = 884 mg/lit. CaCO3 = 120 mg/lit. (proper steps)