When the three identical star-connected coils are supplied with 400 V, 50 Hz, 3- o supply, the 1- p wattmeter whose current coil is connected in line R and pressure coil across the phase R and neutral reads 8 kW and the ammeter connected in R- phase reads 36 Amp. Assuming RYB phase sequence find: (i) the power factor, of the load , (ii) resistance and reactance of the coil (iii) reactive

When the three identical star-connected coils are supplied with 400 V, 50 Hz, 3- o supply, the 1- p wattmeter whose current coil is connected in line R and pressure coil across the phase R and neutral reads 8 kW and the ammeter connected in R- phase reads 36 Amp. Assuming RYB phase sequence find: (i) the power factor, of the load , (ii) resistance and reactance of the coil (iii) reactive

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Vin V₁ leee liee V₂ R₂ ww Vout 1:5 Assume the transformer circuit above is ideal, and that R₁ = 1000, R₂ = 4000 and 11,rms = 50 A. Find the rms voltage, Vzrms, across the secondary coil of the transformer. V2.rms [V]:
Question 9: A single-phase, 240V/1920V ideal transformer is supplied from a 240V source through a cable of resistance 5 ohm. If the load across the secondary winding is 1.60 kohm. Find the primary current flowing and find the power dissipated in the load resistance.
Question 2. Consider a 10 KVA, 200/400 V, 50 Hz single-phase transformer has the following test results: O.C. test: 200 V, 0.6 A, 63 W (L.V. side) S.C. test : 20 V, 25 A, 85 W (H.V. side) Determine : i) The efficiency at 75 % of full-load at 0.9 leading power factor. ii) The secondary terminal voltage on fiull-load at unity power factor.
i need the answer quickly
The test results of a 5 kVA, 400/200 V, 50 Hz, single phase transformer are as follows. O.C. Test: 400 V, 1 A, 50 W, H.V. side S.C. Test: 12 V, 12.5 A, 60 W, H.V. side Find the full load efficiency and regulation when the power factor is 0.8 lagging.
Alternator A(100 kVA,3-phase, 240V,60HZ,1800 rpm) is operating with alternator B(125 kVa,3- phase,240 V,60 Hz,1800 rpm). The load of alternator A is 60kW at 90% pf lagging and the load of alternator B is 80kW at 70% lagging. Determine pf of load.
Electrical Engineering _ Power Electronics Notes: pls try to answer in less than 30 min.
A 1500KVA, 8KV, three-phase wye-connected alternator has an effective resistance of 0.502 and a reactance of 62 per phase. It delivers full-load current at 0.8 lagging power factor at rated voltage. What will be the terminal voltage for the same excitation and load current, if the power factor is 0.8 leading?
Following are the results of a test carried out on a 230/600 V single phase, 7.5 kVA transformer. O.C. Test : 230 V, 1.2 A, 280 W, on L.V side S.C. Test : LV winding is shorted. 26 V, 11A, 155 W, H.V. Both the full load efficiency and full load regulation of the transformer on the side are 0.8 lagging p.f Search on.
4.14 A 4800/240-V, single-phase transformer is rated at 10 kVA, and it has an equiv- alent impedance referred to the primary side of Zel= 120+ j300 n. a. Find the equivalent impedance referred to the secondary side Ze2. b. Calculate the voltage at the primary terminals if the secondary supplies rated secondary current at 230 V and unity power factor.
I need the answer quickly
47. A series resistance-capacitance (R-C) circuit is connected to 230-volt, 50 cycle AC source. The current through the resistor is 45.45 A and the power taken by the circuit is 5,000 watts. Compute the following: a. Voltage drop across the resistor b. power factor angle c. circuit impedance