What will be the value of load applied parallel to the diagonal of 100x100x100)mm cube since the splitting tensile strength=3 Mpa 57.8 KN O 46.7 KN (O 47.1 KN O

Q: Determine the shear strain Yxy at corners D and the plastic distorts as shown by the dashed lines. 3…

A:

Q: Q/Normal and shear stresses acting at the point is shown in Figure 1- Determine the principal…

A:

Q: The beam below has a fixed support at A and a roller support at B. It is subject to transverse…

A:

Q: 3. The plastic block is subjected to an axial compressive force of 600 N. Assuming that the caps at…

A: The average normal and shear stress acting along section a-a has to be determined, for the given…

Q: Two vertical forces, each of magnitude P= 13 kN, are applied to a beam of the cross section shown.…

A: Objective: To determine the maximum compressive and tensile stresses in portion BC of the beam.…

Q: -0/02 -400 m

A:

Q: 8. A rigid bar AB is supported by three rods. A load P = 350 kN is applied to the bar. The modulus…

A: To Find :- Deformation in the rods in mm

Q: The stresses shown act at a point in a stressed body. Normal and shear stress magnitudes acting on…

A:

Q: The prismatic block with dimensions a * b * c is placed in a rigid space of the same size. Find the…

A: Finding out the force to shorten the block by 2mm.

Q: A beam of rectangular cross-section 40 x 20 mm is loaded with tensile force 1000 N as shown in…

A: A rectangular cross-section beam 40 x 20 mm, Tensile load=1000 N.

Q: How to make a effective stiffness matrix for this figure?

A: The free body diagram of the given structure is:

Q: В 0.4h 0.2h 0.4h 0.4b 0.2b 0.4b

A: The given data is: Transverse Shear force (V) = 8 kip b = 6 in h = 14 in

Q: termine the shear strain yxy at corners A, B, C, D i = dashed lines. Consider small strain…

A:

Q: The pin-jointed planar truss shown is subjected to a single downward force P at joint A. Consider 1…

A:

Properties of materials

A property of a material describes its characteristics and distinguishes it from the others. The material properties are described it in terms of its hardness, color, appearances, and so on. The material properties generally depend on the type of material, or whether it is a metal or an alloy. There are different kinds of material properties such as mechanical properties, thermal properties, physical properties, and chemical properties. Chemical properties describe the material in terms of a chemical change. The mechanical properties come into existence when the material is acted upon by an external load. Thermal properties are associated with the temperature of the material and specific heat.