7. What will be the appearance of a TLC plate if a solvent of too low polarity is used for the development? A solvent oftoo high polarity Calculate the Rf value from the information given for both the known and unknown solutions and identify eachunknown solution based on the Rf values from the known solutions.distance the spottraveledRf =%3Ddistance the solvent traveledDistance the solvent travels: 6.1cmKnown SolutionsAcetaminophen in Ethanol: traveled 3.4cm2% Ibuprofen in Ethanol: traveled 5.2cm1% Caffeine in Ethanol: traveled 1.1 cm2% Aspirin in Ethanol: traveled 3.5 cmUnknown SolutionsUnknown 1: traveled 3.2 cmUnknown 2: traveled 3.7 cmUnknown 3: traveled 1.0 cmUnknown 4: traveled 4.9 cmQuestions:In Thin-Layer Chromatography, what is the stationary phase? What is the mobile phase?2. This diagram from the chemguide page shows the results of a thin layer chromatography experiment.A. Describe briefly, but precisely what would have been done to get to this stage. You can assume that you haveheight reached byhe solvent the"salvent tonbeen given a suitable thins layer chromatography plate.В.Why is the cover on the beaker?In order to identify the things in a chromatogram, you can measure the Rf value for each spot, How wouldyou work out the Rf value for each spot?С.When do you use a TLC plate coated in Silicon dioxide (SiO2)? Aluminum Oxide (Al2O3)?What error is introduced into the determination of a R, value if the top is left off the developing chamber?What will be the result of applying too much compound to a TLC plate?6. Why is it necessary to run TLC in a closed container and to have the interior vapor saturated with the solvent?3.1456

In TLC, stationery phase is used is polar in nature. components or analyte that has to seperate, has…

Answered: What will be the appearance of a TLC…

What will be the appearance of a TLC plate if a solvent of too low polarity is used for the development? A solvent of too high polarity 7.

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

Where should the analyte be spotted on a TLC plate? Below the 1 cm spot line On the 1 cm spot line. On the solvent front line Above the 1 cm spot line
what is the purpose of TLC Separation & Analysis of Analgesics?
See image below
Write down three differences between GC and HPLC (GC = gas chromatography) (HPLC = High-performance liquid chromatography)
What are some ways to visualize a TLC plate? Why may it be necessary to have more than one method to visualize a TLC plate?
A student spots an unknown sample on a TLC plate. A single spot with an Rf of 0.55 showed up on the plate after developing the sample in hexanes-ethyl acetate 50:50. Does this prove that the unknown is a pure compound?
A standard sample of compound A was placed on a silica TLC plate. After elution in 30/70 ethyl acetate/hexane, the sample showed a single spot at 3.4 cm (relative to the initial point) after the solvent had risen to 7.1 cm (relative to the initial point). A sample which was thought to contain this compound was analyzed by TLC and showed two spots after elution in the same solvent system. The solvent height for this plate was 6.5 cm (relative to the initial point) and the spots were located at 3.6 cm and 5.2 cm (relative to the initial point). Can either of these spots possibly be compound A? Explain. Include a discussion of the R, for each spot.
How does increasing the polarity of the developing solvent affect the Rf of a compound on a silica gel TLC plate?
if you wanted to makes the spots travel up the TLC plate further, what solvent ration would you choose and why? 1:2 Ethyl acetate/Hexane, 2:3 Ethyl acetate/ Hexane, or 1:1 Ethyl acetate/Hexane
Answer the following questions.
Prelaboratory Questions Name Laboratory Section 1. Read the Introduction and Procedure for this experiment, then answer the following ques- tions about preparing a TLC plate. a) Why must you hold the plate only by its edges? b) Why must you use a pencil and not a pen to draw the starting line that is 14 – ½ inch from the bottom end of the plate? c) Why must the starting pencil line be above the level of the solvent on the chamber? d) Why must the sample spot not be too concentrated? (continued on next pa
The figure below shows a typical separation of several fat-soluble vitamins by HPLC. The x-axis is retention time in minutes. From the graph try to estimate retention times for peaks 2 and 3. Retention time peak 2 = Retention time peak 3 = Assume that w1/2 is 0.15 minutes for peak 2 and 0.16 minutes for peak 3. Assume that tm is 2.00 minutes. How much time does gamma-tocopherol spend in the stationary phase? From tr and w1/2 find N for the peak that elutes first. From tr and w1/2 find the resolution of peaks 2 and 3 Calculate α for these peaks. If the flow rate for the column is 1.2 mL/minute what is the retention volume for peak 4?